1-2hit |
Shohei HASEGAWA Takenori YASUZUMI Tomoki UWANO Osamu HASHIMOTO
In this paper, a microstrip lowpass filter using hairpin structure and Chip-Capacitor is proposed. Firstly, the LPF with one hairpin element is briefly designed and optimized with LC prototype structure using circuit simulator. With the capacitor loaded the proposed LPF illustrates the sharp attenuation performance near the cut-off frequency and the wideband rejection characteristics. Then, in order to improve the stopband attenuation the three-hairpin LPF is studied. By optimazing its design the attenuation is improved by 32 dB.
Keren LI Yasuhisa YAMAMOTO Daisuke KURITA Osamu HASHIMOTO
This paper presents an ultra-wideband (UWB) bandpass filter using a combination of broadside-coupled structure and lumped-capacitor-loaded shunt stub resonator. The broadside-coupled microstrip-to-coplanar waveguide structure provides an ultra-wide bandpass filtering operation and keeps a good stopband at lower frequencies from DC at the same time. The lumped-capacitor-loaded shunt stub resonator creates two transmission zeros (attenuation poles which can be located at the outsides of the two bandedges of the UWB bandpass filter to improve the out-band performance by selecting a suitable combination of the length of the shunt stubs and the capacitance of the loaded chip capacitors. The filter was designed based on electromagnetic simulation for broadside-coupled structure, microwave circuit simulation and experiments for determining the transmission zeros. The filter was fabricated on a one-layer dielectric substrate. The measured results demonstrated that the developed UWB bandpass filter has good performance: low insertion loss about 0.46 dB and low group delay about 0.26 ns at the center of the passband and very flat over the whole passband, and less than -10 dB reflection over the passband. The implemented transmission zeros, particularly at the low frequency end, dramatically improved the out-band performance, leading the filter satisfy the FCC's spectrum mask not only for indoor but also for outdoor applications. These poles improved also the skirt performance at both bandedges of the filter. A lowpass filter has been also introduced and integrated with the proposed bandpass filter to have a further improvement of the out-band performance at the high frequency end. The filters integrated with lowpass section exhibit excellent filter performance: almost satisfying the FCC's spectrum mask from DC to 18 GHz. The developed UWB bandpass filter has a compact size of 4 cm1.5 cm, or 4.8 cm1.5 cm with lowpass section implemented.