In this paper, a microstrip lowpass filter using hairpin structure and Chip-Capacitor is proposed. Firstly, the LPF with one hairpin element is briefly designed and optimized with LC prototype structure using circuit simulator. With the capacitor loaded the proposed LPF illustrates the sharp attenuation performance near the cut-off frequency and the wideband rejection characteristics. Then, in order to improve the stopband attenuation the three-hairpin LPF is studied. By optimazing its design the attenuation is improved by 32 dB.

A design method for an ultra-wideband bandpass filter (BPF) with four coupled lines has been developed. For demonstration purposes, 50 Ω-matched self-complementary antennas integrated with the ultra-wideband, differential-mode BPF with four coupled lines, a notch filter, and a low-pass filter (LPF) were prepared and tested. An optimized structure for a single-stage, broadside-coupled and edge-coupled four-lines BPF was shown to exhibit up to 170% fractional bandwidth and an impedance transformation ratio of 1.2 with little bandwidth reduction, both analytically and experimentally. Using the optimized structure, 6-stage BPFs were designed to transform the self-complementary antenna's constant input impedance (60πεe- 1/2(Ω)) to 50 Ω without degrading bandwidth. In addition, two types of filter variations--a LPF-embedded BPF and a notch filter-embedded BPF--were designed and fabricated. The measured insertion loss of both filter systems was less than 2.6 dB over the ultra-wideband (UWB) band from 3.1 GHz to 10.6 GHz. The filter systems were embedded in the wideband self-complementary antennas to reject unnecessary radiation over the next pass band and 5-GHz wireless LAN band.

We propose a third-order low-pass notch filter realized by a single operational amplifier and a minimum number of equal-valued capacitors. As a design example we realize a Chebyshev filter with a ripple of 0.5 dB and it is shown that the experiment result is very good.