Diffraction field by a wide and thick slit on a conducting screen has been analyzed. High frequency ray-mode coupling analysis has been utilized, and the total diffracted or radiated field in each region is considered as a summation of successive modal radiation contribution due to the original modal excitation by the incident plane wave. Our derived results are compared with those obtained by other solutions, and good agreement has been observed, and the validity of our formulation is confirmed.

Press-induced long-period fiber gratings exhibiting strong core-to-cladding mode coupling were formed in photonic crystal fiber. Only one resonance peak was observed over a 600 nm spectral range and the resonant wavelength was tuned over the whole range by tilting a groove plate before pressing the fiber. The resonant wavelength decreased with increasing periodicity of the grating, which was opposite to the trend of the step-index conventional optical fiber. Meanwhile, the resonant wavelength increased with increasing the ambient refractive index, which was also opposite to that of the conventional optical fiber.

It is known that a high permittivity NRD guide suffers from irregular transmission phenomena. In this study, we clarified that this problem is caused by a mode coupling phenomenon between the operating and parasitic modes due to a small remaining asymmetrically air gap between the metal plates and high permittivity dielectric materials.

A bandpass filter (BPF) with shielded inverted microstrip lines (SIMSL), previously demonstrated by the author, has shown the nontrivial asymmetry of filter responses in spite of adopting a conventional filter synthesis procedure. This paper will reveal the mechanism of the asymmetry and propose prescriptions for recovering the defect, in addition to observing the wave propagation property of SIMSL. Firstly, the behavior of phase constants or effective dielectric constants for various modes propagating on single SIMSL are indicated in terms of the line configuration, and the dispersion characteristics of the quasi-TEM mode are interpreted from the point of mode coupling between the pure TEM mode and dielectric slab modes. Then it is shown that the asymmetry is dependent only on the transmission characteristics of SIMSL parallel-coupled lines involved in the filter circuits. Theoretical considerations reveal that the asymmetry is due to the fact that SIMSL has quite different phase constants for the even- and odd-mode. On the basis of these results, the optimized BPF is designed and it is experimentally demonstrated that the symmetry of its responses is notably recovered. Furthermore, this optimization is still quite efficient for achieving high attenuation properties at its harmonics.

A technique for the design of circular- and racetrack-shaped NRD guide ring resonators was developed based on the mode coupling theory. Besides the operating mode, a parasitic mode is generated at curved sections of the resonator as a result of the mode conversion. Resonance of the NRD guide ring resonator is derived by characteristic equations of the coupled modes and then employed in making the design diagrams, which are useful for determining the dimensions of the ring resonators. It is shown that the discrepancy between the experimental results and previous theory can be resolved by using the present theory. Low loss, small-sized ring resonators with curvature radii of less than 5.3 mm were fabricated at 60 GHz and a band rejection performance of more than 30 dB was observed. Moreover, a procedure for the design of the channel dropping filter was developed and a 2-pole filter, which has great advantages such as a low insertion loss of 1.2 dB and a compact size smaller than that of a golf ball, was successfully developed by using two racetrack-shaped ring resonators.

A general analytical expression for describing the growth of the resonant peak wavelengths of long period gratings is derived. The theoretical calculations explain the shift of peak loss wavelengths in the direction of either shorter or longer wavelengths as the induced index change of grating increases. We have calculated and experimentally verified the sensitivity of the resonant peak wavelengths with respect to an overlay index for various grating periods. It is shown that the center wavelength shift of the claddding modes depends strongly on the grating period and the claddding mode order.

Optical-MSSW interaction has received wide interest for realization of thin film devices for optical signal processing at microwave signal frequency. In this paper, a device structure to obtain optical-MSSW interaction in a three-dimensional optical waveguide using a multilayered garnet structure is proposed and analyzed. The multilayered structure enables optimization of the waveguide parameters, separately, for optical and MSSW propagation. Interaction in a three-dimensional optical waveguide is promising for integration of the device with other optical integrated circuits. Optical and MSSW propagation characteristics in the multilayered device are investigated and the optical mode conversion characteristics between the Ezpq and the Expq modes supported by the three-dimensional optical waveguide are derived. The dependence of the mode coupling coefficient on the waveguide parameters, such as the film thicknesses, waveguide width, saturation magnetization, and the MSSW power is also analyzed. It is demonstrated through a numerical example that, by proper selection of the waveguide parameters, it is possible to achieve practical device dimensions.

Electromagnetic plane wave scattering by a wide trough on the ground has been analyzed by high frequency asymptotic techniques based on Geometrical Theory of Diffraction. Field in the trough region has been formulated in terms of parallel plane waveguide modes, whose excitation (coupling) coefficients are obtained by ray-mode conversion techniques. Numerical calculation has been done extensively and thus obtained results are then compared with those by other methods. Good agreements have been observed except for oblique incidence case. It is found that first and secondary modal re-radiation fields from the indented trough region play an important role for scattering far field, and primary edge diffracted field contributes mainly to reflection boundary direction.