1-3hit |
Yasunori SUZUKI Junya OHKAWARA Shoichi NARAHASHI
This paper proposes a method for reducing the peak-to-average power ratio (PAPR) at the output signal of a digital predistortion linearizer (DPDL) that compensates for frequency dependent intermodulation distortion (IMD) components. The proposed method controls the amplitude and phase values of the frequency components corresponding to the transmission bandwidth of the output signal. A DPDL employing the proposed method simultaneously provides IMD component cancellation of out-of-band components and PAPR reduction at the output signal. This paper identifies the amplitude and phase conditions to minimize the PAPR. Experimental results based on a 2-GHz band 1-W class power amplifier show that the proposed method improves the drain efficiency of the power amplifier when degradation is allowed in the error vector magnitude. To the best knowledge of the authors, this is the first PAPR reduction method for DPDL that reduces the PAPR while simultaneously compensating for IMD components.
Chin-Liang WANG Yuan OUYANG Ming-Yen HSU
One major drawback of orthogonal frequency-division multiplexing is the high peak-to-average power ratio (PAPR) of the output signal. The selected mapping (SLM) and partial transmit sequences (PTS) methods are two promising techniques for PAPR reduction. However, to generate a set of candidate signals, these techniques need a bank of inverse fast Fourier transforms (IFFT's) and thus require high computational complexity. In this paper, we propose two low-complexity multiplication-free conversion processes to replace the IFFT's in the SLM method, where each conversion process for an N-point IFFT involves only 3N complex additions. Using these proposed conversions, we develop several new SLM schemes and a combined SLM & PTS method, in which at least half of the IFFT blocks are reduced. Computer simulation results show that, compared to the conventional methods, these new schemes have approximately the same PAPR reduction performance under the same number of candidate signals for transmission selection.
Orthogonal frequency-division multiplexing (OFDM) is an attractive transmission technique for high-bit-rate communication systems. One major drawback of OFDM is the high peak-to-average power ratio (PAPR) of the transmitted signal. This study introduces a low-complexity selected mapping (SLM) OFDM scheme based on discrete Fourier transform (DFT) constellation-shaping. The DFT-based constellation-shaping algorithm applied with conventional SLM scheme usually requires a bank of DFT-shaping matrices to generate low-correlation constellation sequences and a bank of inverse fast Fourier transforms (IFFTs) to generate a set of candidate transmission signals, and this process usually results in high computational complexity. Therefore, a sparse matrix algorithm with low-complexity is proposed to replace the IFFT blocks and the DFT-shaping blocks in the proposed DFT constellation-shaping SLM scheme. By using the proposed sparse matrix, the candidate transmission signal with the lowest PAPR can be achieved with lower complexity than that of the conventional SLM scheme. The complexity analysis of the proposed algorithm shows great an improvement in the reduction of the number of multiplications. Moreover, this new low-complexity technique offers a PAPR that is significantly lower than that of the conventional SLM without any loss in terms of energy and spectral efficiency.