We performed numerical analyses on structure sensitive field emission properties of our proposing plasmon resonant photomixer (PRX) in the terahertz range. The photomixer incorporates doubly interdigitated grating strips for gate electrodes and a vertical resonator structure for realizing highly efficient terahertz emission even at room temperature. We investigated the dependence of total field emission properties of PRX's on their material and dimension parameters. Introduction of low-conductive gate electrodes and ac-coupled 2D periodic plasmon gratings with depleted connecting portions are effective for expanding its lower cutoff frequency. The cutoff frequency, which is around 1.0 THz in standard metal-gates configuration, is expanded to less than 500 GHz. The output intensity could also be amplified more than double. On the other hand, a shorter vertical cavity is effective for expanding its upper cutoff frequency, which is expanded close to vertical resonant frequency, while maintaining the lower cutoff frequency. The combination of these design rules can realize much broader bandwidth operation.

We analytically investigated the feasibility of multiplier operation in the terahertz range for our original plasmon resonant photomixer. The photomixer features two unique structures (doubly interdigitated gate gratings and a vertical cavity) for higher radiation efficiencies. Its total field emission properties are the result of a combination of plasmon excitation dynamics and electromagnetic field dynamics. The plasmon excitation formulated by the hydrodynamic equations exhibits fundamental and harmonic resonances whose intensities monotonically decrease with the number of harmonics due to the dispersive plasma damping factors. The electromagnetic dynamics, on the other hand, formulated by the Maxwell's equations, reflect material- and structure-dependent device parameters; the grating-bi-coupled plasmonic cavity together with the vertical cavity structures produce nonlinear field emission properties. This results in extraordinary field enhancement at distinct frequencies inconsistent with the plasmon resonances. The frequency-dependent FDTD (finite difference time domain method) Maxwell's simulation revealed that the field emission peak frequency shifted upward apart from the fundamental mode of plasmon resonant frequency and approached to its second harmonic frequency with increasing the electron density in the plasmon cavity. Calculated total field emission spectra indicated that highly dense 2D-plasmon conditions enable frequency-doubler operation in the terahertz range.

This paper presents a novel mm-wave and THz device concept, with a detailed physical modeling and quantitative performance evaluation, called as CW HTS (high temperature superconductive) photomixer/antenna. Optical heterodyne photomixing in the DC-biased HTS strip has been employed to create mm-wave and THz signal, and the size of strip on the grounded dielectric substrate is designed to have an efficient broadside radiation. Incorporating the HTS microstrip configuration as both photomixing media and radiation element at the same time not only increases the CW photocurrent but also the radiation power, while it reduces the radiation loss associated with the patch antenna. Two possible configurations called as longitudinal and transversal will be introduced and their photomixing efficiency and output radiation power will be compared. The detailed analysis along with the optimum design of the geometrical parameters of the microstrip structure shows that the transversal scheme exhibits higher radiation power. The typical nW output power can be obtained by mW laser pump power for frequencies up to the gap frequency of the HTS material. The output power of the proposed device is theoretically higher than the experimentally available data from a Low-Temperature-Grown (LTG) GaAs photomixer integrated with dipole or bow-tie antenna reported in the literature.