We review the recent advances on strain and temperature sensing techniques based on multimodal interference in perfluorinated (PF) graded-index (GI) polymer optical fibers (POFs). First, we investigate their fundamental characteristics at 1300nm. When the core diameter is 62.5µm, we obtain strain and temperature sensitivities of -112pm/µε and +49.8nm/°C, the absolute values of which are, by simple calculation, approximately 13 and over 1800 times as large as those in silica GI multimode fibers, respectively. These ultra-high strain and temperature sensitivities probably originate from the unique PF polymer used as core material. Subsequently, we show that the temperature sensitivity (absolute value) is significantly enhanced with increasing temperature toward ∼70°C, which is close to the glass-transition temperature of the core polymer. When the core diameter is 62.5µm, the sensitivity at 72°C at 1300nm is 202nm/°C, which is approximately 26 times the value obtained at room temperature and >7000 times the highest value previously reported using a silica multimode fiber. Then, we develop a single-end-access configuration of this strain and temperature sensing system, which enhances the degree of freedom in embedding the sensors into structures. The light Fresnel-reflected at the distal open end of the POF is exploited. The obtained strain and temperature sensitivities are shown to be comparable to those in two-end-access configurations. Finally, we discuss the future prospects and give concluding remarks.

Dense millimeter-wave networks are a promising candidate for next-generation cellular systems enabling multiple gigabit-per-second data rates. A major disadvantage of millimeter-wave systems is signal disruption by rain, and here we propose a novel method for rain sensing using dual-frequency measurements at 25 and 38GHz from a small-scale Tokyo Institute of Technology (Tokyo Tech) millimeter-wave network. A real-time algorithm is developed for estimating the rain rate from attenuation using both ITU-R relationships and new coefficients that consider the effects of the rain Drop Size Distribution (DSD). The suggested procedure is tested on measured data, and its performance is evaluated. The results show that the proposed algorithm yields estimates that agree very well with rain gauge data.

We will discuss performance optimization of strain and temperature sensors based on long period fiber gratings (LPFGs) through control of the temperature sensitivity of the resonant peak shifts. Distinction between the effects of strain and temperature is a major concern for applications to communication and sensing. This was achieved in this work by suppressing or enhancing the temperature sensitivity by adjusting the doping concentrations of GeO2 and B2O3 in the core or cladding. The LPFGs were fabricated with a CO2 laser by the mechanical stress relaxation and microbending methods. The optimized temperature sensitivities were 0.002 nm/ for the suppressed case and 0.28 nm/ for the enhanced case, respectively. These LPFGs were used for simultaneous measurement of strain and temperature. The result indicates the rms errors of 23 µstrain for the strain and 1.3 for the temperature.