Ring head recording on single-layer perpendicular recording media was studied by a simple simulation analysis based on a loop tracing method considering only the perpendicular component. Although the assumed model was primitive, the simulation results qualitatively well explained the experimental results such as a decrease in output at high recording currents and its relaxation upon using a smaller gap-length head. The simulation results revealed that achievable recorded magnetization is, in general, much smaller than the saturation value due to a broad distribution of the ring head field, but a medium with a steeper slope in the perpendicular M-H loop could improve the recording performance. This was confirmed experimentally for the medium with a steeper loop slope, though the medium exhibited a larger medium noise at high densities. It was suggested that the development of perpendicular recording for higher output and lower noise could be performed for both media with a small and steep loop slope. The former should be improved by means of the recording head while the latter by the media. A large improvement is expected for both cases.

B-ISDN telecommunication systems will require signal processing speeds up to 600 Mbps or more. We must therefore consider the affects of signal reflection, signal attenuation, time dalay, and so on when designing these systems. The higher the signal speed, the larger the electrical noise induced around the connector, especially in the plated through holes (PTHs) area. This paper presents the results of our investigation focused on connector mounting configurations in the signal transmission line, especially whether or not signals transmit through the PTH in a printed circuit board (PCB). How the signal reflection characteristics depend upon transmission line configurations are discussed and experimental results and simulation analyses for a transmission line system using a small miniature A-type (SMA) connector as an example are performed. It is suggested that designs for future high-speed signal transmission circuits take into account the PTH diameter and/or the PTH pitch conditions, values for which can be determined from simulation analysis.