In this paper, a new single soft switched forward converter with a self driven synchronous rectification (SDSR) is introduced. In the proposed converter, a soft switching condition (ZCS turn on and ZVS turn off) is provided for the switch, by an auxiliary circuit without any extra switch. In additional, this auxiliary circuit does not impose high voltage or current stresses on the converter. Since the proposed converter uses SDSR to reduce conductive loss of output rectifier, the rectifier switches are switched under soft switching condition. So, the conductive and switching losses on the converter reduce considerably. Also, implementing control circuit of this converter is very simple, due to the self-driven method employed in driving synchronous rectification and the converter is controlled by pulse width modulation (PWM). The experimental results of the proposed converter are presented to confirm the theoretical analysis.

Paralleled converter system with synchronous rectifiers (SRs) causes several problems such as surge voltage, inhalation current and circulating current. Generally, the system stops operation of the SRs in light load to avoid these problems. However, simultaneously, large voltage fluctuations in the output of the modules are occurred due to forward voltage drop of diode. The fluctuations cause serious faults to the semiconductor devices working in very low voltage such as CPU and VLSI. Moreover, the voltage fluctuations generate unstable current fluctuations in the paralleled converter system with current-sharing control. This paper proposes new switching control methods for rectifiers to reduce the voltage and current fluctuations. The effectiveness of the proposed methods is confirmed by computer simulation and experimental results.

This paper presents a novel current driving method for the synchronous rectifier (SR) in a Flyback topology. Compared to the previous proposed Current Driven Synchronous Rectifier (CDSR), the proposed CDSR features simple structure, low power loss and good performance. The proposed SR driving method is implemented in a 64 W Flyback converter with universal input, and efficiency as high as 92.5% is achieved at low input (90 V ac) and full load condition.

A class E low dv/dt PWM synchronous rectifier regulating the output voltage at a fixed frequency is presented, analyzed and verified experimentally. This rectifier is derived from the class E low dv/dt rectifier by replacing the controlled switch (MOSFET with its anti-parallel diode) with the rectifier diode in class E low dv/dt rectifier, and by using the synchronized PWM signal to control the output voltage at desired value. The ZVS condition of the controlled switch can be maintained from full-loaded to open-loaded. The experimental results measured at switching frequency 1 MHz are in good agreement with the theoretical prediction.

This paper presents a new type of zero-voltage-switched (ZVS) push-pull dc-dc converter with two synchronous rectifiers in the secondary circuit. ZVS is realized using the magnetizing current of the transformer as a constant current source during the commutation. The output voltage is controlled by PWM with a constant switching frequency. The circuit operation is described using equivalent circuits. The steady-state and dynamic characteristics are analyzed and confirmed experimentally.

It has been reported that the efficiency of a low voltage power supply is improved by replacing diodes in an output-stage with synchronous rectifiers (SR). A SR consists of a bipolar junction transistor with a low-saturation voltage and a current transformer. Although the SR has low offset-voltage, its reverse recovery characteristic is usually poor. In this paper, an RCD circuit which improves the reverse recovery characteristic of the SR is proposed. This circuit is simple, and it is composed of a diode, a capacitor and a resistor. The analysis and the experimental results of the SR with the proposed RCD circuit are presented. The optimum design of the RCD to improve the reverse recovery characteristic of SR is discussed.