In this paper, we introduce a parallax barrier system that shows high definition autostereoscopy and holds wide viewing zone. The proposed method creates a 4-view parallax barrier system with full display resolution per view by setting aperture ratio to one quarter and using time-division quadplexing, then applies obtained 4-view to 2-view, so that the viewing zone for each eye becomes wider than that from the conventional methods. We build a prototype with two 120,Hz LCD panels and manage to achieve continuous viewing zone with common head-tracking device involved. However, moire patterns and flickers stand out, which are respectively caused by the identical alignments of the color filters on the overlaid LCD panels and a lack of refresh rate of 240,Hz. We successfully remove the moire patterns by changing the structure of the system and inserting a diffuser. We also reduce the flickers by proposing 1-pixel aperture, while stripe shaped noise due to the lack of refresh rate occurs during a blink or a saccade. The stripe noise can be effectively weakened by applying green and magenta anaglyph to the proposed system, where extra crosstalk takes place since the default RGB color filters on LCD panels share certain ranges of wavelength with each other. Although a trade-off turns out to exist between stripe noise and crosstalk from our comparison experiment, results from different settings all hold acceptable quality and show high practicability of our method. Furthermore, we propose a solution that shows possibility to satisfy both claims, where extra color filters with narrow bandwidths are required.

We demonstrate high baud-rate DQPSK modulation with full-ETDM technique using a novel high-speed optical IQ modulator consisting of a ridge-type optical waveguide structure on a thin LiNbO3 substrate. Our fabrication technique achieves a drastic extension of the modulator's bandwidth and a reduction of half-wave voltage. Demonstration of 90-Gbaud NRZ-DP-DQPSK signal generation with the modulator successfully achieved a bit rate of 360-Gb/s under full-ETDM configuration.

We demonstrate a single-channel 1.28 Tbit/s-525 km transmission using OTDM of subpicosecond DQPSK signals. In order to cope with transmission impairments due to time-varying higher-order PMD, which is one of the major limiting factors in such a long-haul ultrahigh-speed transmission, we newly developed an ultrafast time-domain optical Fourier transformation technique in a round-trip configuration. By applying this technique to subpicosecond pulses, transmission impairments were greatly reduced, and BER performance below FEC limit was obtained with increased system margin.

In this paper, we demonstrate a 10.66 Gb/s bidirectional TDM over long-reach WDM hybrid PON supported by distributed Raman amplification, and the power budget margin is measured to be 15 dB for downstream transmission and 12 dB for upstream transmission, with dual Raman pump power of 300 mW.

All-optical switching is of considerable interest, since it enables the construction of large-capacity networks with protocol- and bit-rate-independent transmission. In this paper, we determine the most desirable of three all-optical architectures for a backbone network, by comparing the following architectures: the wavelength-routed network, the slotted wavelength-routed network, and the optical burst switching network. After proposing an optical path accommodation algorithm that minimizes the total fiber length, we evaluate the total network cost in order to compare the availability of the first two architectures. We then compare the architectures in terms of the burst blocking probability in order to clarify the effectiveness of the third architecture.

Timing noise of 160 GHz optical pulses has been evaluated over nine decades of Fourier frequency using the optoelectronic harmonic mixing technique. For down-converting the 160 GHz pulse intensity into a low-frequency IF signal, the fourth order modulation sidebands produced by a Mach-Zehnder intensity modulator have been employed. Phase noise power spectral density and timing jitter for 155.552-GHz optical time-division multiplexed pulses and 160.640-GHz passively mode-locked pulses are measured using the time domain demodulation and time interval analysis techniques, respectively.

Today, an ultra-high capacity transmission system based on N40 Gb/s channel rate is the most promising approach to achieve multi-terabit/s of capacity over a single fiber. We have demonstrated 5.12 Tbit/s transmission of 128 channels at 40 Gbit/s over 3100 km and 10.24 Tbit/s transmission of 256 channels at 42.6 Gbit/s (using FEC) over 100 km, based on four main technologies: 40 Gbit/s electrical time-division multiplexing (ETDM), vestigial sideband demultiplexing (VSB), advanced amplifier technology including Raman amplification and TeraLightTM fiber. A record spectral efficiency of 1.28 bit/s/Hz is applied to achieve 10.24 Tbit/s transmission within the C- and L-band.

We describe a simplified receiver structure having several receiving antennas (i.e., an adaptive array antenna system) and using time-division-multiplexing (TDM) signal processing. Three simplified receiver structures were investigated for use in the antenna system. To confirm the feasibility of using a TDM receiver, both a TDM receiver and a conventional adaptive array receiver were constructed for testing. In our proposed system, several repetitions of the constant modulus algorithm (CMA) are used to reduce co-channel interference (CCI). The frame format used for both receivers was the same as that of the personal handy phone system in Japan. The laboratory testing was done using a fading simulator to enable measurement of the bit error rate. The results are very promising and show the feasibility of the TDM receiver.

Recent progress in ultrahigh bit rate optical transmission using time-division multiplexing and wavelength-division multiplexing is described. Latest over 1 Tbit/s transmission experiments are shown and the possibility of higher bit rate transmission is discussed.

Recent progress in ultrahigh bit rate optical transmission using time-division multiplexing and wavelength-division multiplexing is described. Latest over 1 Tbit/s transmission experiments are shown and the possibility of higher bit rate transmission is discussed.

This paper considers methods to design multiple-output networks based on decision diagrams (DDs). TDM (time-division multiplexing) systems transmit several signals on a single line. These methods reduce: 1) hardware; 2) logic levels; and 3) pins. In the TDM realizations, we consider three types of DDs: shared binary decision digrams (SBDDs), shared multiple-valued decision diagrams (SMDDs), and shared multi-terminal multiple-valued decision diagrams (SMTMDDs). In the network, each non-terminal node of a DD is realized by a multiplexer (MUX). We propose heuristic algorithms to derive SMTMDDs from SBDDs. We compare the number of non-terminal nodes in SBDDs, SMDDs, and SMTMDDs. For nrm n, log n, and for many other benchmark functions, SMTMDD-based realizations are more economical than other ones, where nrm n is a (2n)-input (n1)-output function computing (X2+Y2)+0.5, log n is an n-input n-output function computing (2n1)log(x1)/nlog2, and a denotes the largest integer not greater than a.