In this paper, a compact controlled reception pattern antenna (CRPA) array based on a mu-zero resonance (MZR) antenna is proposed for a global positioning system (GPS). The MZR antenna can be minimized by designing structure based in mu-negative (MNG) transmission line. The MNG transmission line can be implemented by a gap structure for the series capacitance and a shorting via for a short-ended boundary condition. The CRPA array, which operates in L1 (1.57542GHz) and L2 (1.2276GHz) bands, is designed as a cylinder with a diameter and a height of 127mm (5 inches) and 20mm, respectively, and is composed of seven radiating elements. To design the compact CRPA array with high performance attributes such as an impedance matching (VSWR) value of less than 2, an isolation between array elements (<-12dB), an axial ratio (<5dB), and a circular polarization (CP) gain (>-1dBic: L1 band and >-3dBic: L2 band), we employ two orthogonal MZR antennas, a superstrate, and chip couplers. The performances of the CRPA antenna are verified and compared by an analytic analysis, a full-wave simulation, and measurements.

A penta-band antenna based on the mu-negative transmission line is presented for radio frequency (RF) energy harvesting application. The antenna utilizes five radiation modes; two quarter wavelength resonances, three quarter wavelength resonance, zeroth order resonance, and first order resonance. The parasitic radiating strip antenna generates quarter wavelength resonance radiation. The dual band antenna based on two unit cell mu-negative (MNG) transmission line gives birth to the zeroth order resonance (ZOR) mode and the first order resonance (FOR) mode. The parasitic radiating strip and dual band antenna based on two unit mu-negative (MNG) transmission line are magnetically coupled by a feed monopole with gap. This feed monopole, simultaneously, radiates at quarter and three quarter wavelength resonance frequency to cover the other bands. The multi-mode coupling mechanism of this penta-band antenna is well modeled by our derived equivalent circuit. The measured radiation efficiencies are more than 87% over the entire penta-band.

In this paper, we present the effects of finite superstrates and asymmetrical grounds on the performance of high gain superstrate antennas. First, when the source of a superstrate antenna is located at an edge of a ground plane, that is, an asymmetric ground plane, the gain of the superstrate antenna can be made to match the gain of the superstrate antenna with a symmetrical ground plane using the PEC (E-plane asymmetric) or the AMC wall (H-plane asymmetric) near the edge. Second, the gain of the superstrate antenna, which has a ground plane with dimensions sufficiently close to infinite, is found to be roughly proportional to the reflection magnitude of a partially reflective surface (PRS). It is found that when the square ground size has a finite dimension of two wavelengths or less, the reflection magnitude of the PRS should have the optimum value for achieving maximum gain. Finally, the gain of the superstrate antenna is studied when the ground plane differs from a PRS. For the above three cases, the performances of the superstrate antenna are verified and compared by analysis, full-wave simulation, and measurement.

In this paper, a rotman lens of multi-beam feed that can be applied to a car collision avoidance radar is designed using nonradiative dielectric (NRD) guide appropriate to the millimeter wave frequency. For the optimum condition, NRD guide at the transmission lines of input and output ports is designed to obtain low loss, small coupling between the transmission lines, and dominant mode operation. The rotman lens is also optimized so as to minimize sidelobe of array factor. To prevent beam pattern from being distorted, multiple-reflection from sidewall has been eliminated by corrugated sidewall.