In order to increase the capacity of a DS-CDMA system, several kinds of interference suppression techniques have been studied, such as multiple access interference (MAI) cancellers and adaptive array antennas. However, their performance tends to degrade in high traffic-load situations. To compensate for the degradation, a receiver cascading an adaptive array antenna and a multistage parallel interference canceller (PIC) is studied in this paper. This receiver first uses an adaptive array antenna to suppress interference signals spatially, and uses a multistage PIC to suppress in-beam interference effectively. The performance of the cascaded receiver is evaluated with two schemes for antenna weight generation by computer simulations assuming a Rayleigh-distributed L-path channel. When antenna weights are generated for each user by an LMS algorithm, the cascaded receiver has shown better performance at the cost of a large number of pilot symbols and symbol by symbol weight update. Its performance degradation is 2.8 dB at the BER of 10-4 even when the number of users increases from one to 24. On the other hand, when antenna weights are generated for each path by a DMI algorithm, its performance is degraded due to the inaccurate weight generation which occurs when the SINR of the desired signal is small. This degradation can be mitigated by using all signals of the desired user received by all antenna patterns of desired user for RAKE combining when the difference among arrival angles of the paths of the desired user is small.

This paper introduces our proposed pre-FFT type MMSE-AAA for an OFDM packet transmission system to suppress sporadic interference. The AAA scheme controls an antenna weight to minimize the mean square error between its output signals of two periods with identical transmitted waveform and iterates the weight updating process in an OFDM symbol to rapidly converge the weight. The average PER performance of the proposed AAA with the presence of a sporadic inter-system/intra-system interference signal is evaluated through computer simulations that assume an exponentially decaying 12-path LOS fading channel and IEEE 802.11a data frame transmission. Simulation results show that the proposed AAA can effectively suppress sporadic inter-system interference that is irrelevant to its arrival timing. Sporadic intra-system interference can also be suppressed by the proposed AAA more efficiently than inter-system interference as long as the interference arrives between 13% and 90% of the OFDM symbol duration after the beginning of an OFDM symbol of the desired signal.

A multi-band wireless local area network (WLAN) enables flexible use of multiple frequency bands. To efficiently monitor radio resources in multi-band WLANs, a distributed-sensing system that employs a number of stations (STAs) is considered to alleviate sensing constraints at access points (APs). This paper examines the distributed sensing that expands the sensing coverage area and monitors multiple object channels by employing STA-based sensing. To avoid issuing unnecessary reports, each STA autonomously judges whether it should make a report by comparing the importance of its own sensing result and that of the overheard report. We address how to efficiently collect the necessary sensing information from a large number of STAs. We propose a reactive reporting scheme that is highly scalable by the number of STAs to collect such sensing results as the channel occupancy ratio. Evaluation results show that the proposed scheme keeps the number of reports low even if the number of STAs increases. Our proposed sensing scheme provides large sensing coverage.

In a CDMA non-linear interference canceller, a generated replica of an interference signal is multiplied by a positive number smaller than unity, which is called cancellation moderating factor (CMF), to prevent interference enhancement due to inaccurate replica subtraction. In this paper, two CMF controlling schemes applicable to a multistage parallel interference canceller with multi-antenna (spatial diversity) reception are proposed. They control CMF by using the mean square error of the complex channel gain or by using the ratio of the estimated power of each interference signal to remaining interference signals' power, in order to mitigate the replica subtraction error due to inaccurate channel estimation. The performance of the proposed schemes are evaluated by computer simulations assuming an asynchronous uplink single chip-rate variable spreading factor DS-CDMA system. The simulation results show that the proposed schemes with higher order diversity reception improve the bit error rate (BER) performance compared with a conventional scheme considering the tentative decision error or fixed CMF settings. Their performance improvement is by 0.1-0.9 dB in terms of the required Eb/N0 at an average BER of 10-5 over exponentially decaying 5-path Rayleigh distributed channels when the number of receiving antennas is 6.

In this paper, a multistage parallel interference canceller (MPIC) with multiple-beam reception for a DS-CDMA system is proposed to suppress multiple access interference (MAI) effectively. Its aim is to reduce the computational complexity of the conventional MPIC cascaded with an adaptive array antenna. It employs multiple fixed beams based on phased array and selects suitable beams to demodulate the transmitted signal of each user. Then it suppresses residual interference signals by the MPIC cascaded with multiple-beam receiver. Its bit error rate (BER) performance is evaluated by computer simulations assuming an uplink single-chip-rate multiple-spreading-factor DS-CDMA system over both exponentially decaying 5-path and equal average power 2-path Rayleigh distributed channels. When there are 16 users in an 120-sectored single cell, the proposed receiver with 6-element array antenna and 2-stage MPIC shows better or comparable BER performance compared with that of the conventional receiver. Moreover, the proposed receiver with 8 beams can reduce the number of complex multiplications to about 40% of that of the complexity-reduced conventional receiver over 5-path channels.

This paper proposes a new overlay transmission system for wireless LAN with RTS/CTS exchange. Conventional timing synchronization schemes may fail in the presence of inter-system interference, because they have not been designed for overlay transmission. In the proposed system, a transmitter estimates the transmission timing of the next wireless LAN DATA frame, and then sends its DATA frame at almost the same time as the estimated transmission timing to easily establish timing synchronization at the receiver. Moreover, we employ a tapped delay line adaptive array antenna at both transmitter and receiver to effectively suppress interference due to overlay transmission in a rich multipath propagation environment. The frame error rate performances of the proposed system and the IEEE 802.11a wireless LAN are evaluated through computer simulations that assume an exponentially decaying 8-path non-line-of-sight fading channel and include a timing synchronization process. Simulation results demonstrate that the proposed system can achieve overlay transmission while avoiding interference in a rich multipath propagation environment.

We have proposed a quality of experience (QoE)-oriented wireless local area network (WLAN) to provide sufficient QoE to important application flows. Unlike ordinary IEEE 802.11 WLAN, the proposed QoE-oriented WLAN dynamically performs admission control with the aid of the prediction of a “loadable capacity” criterion. This paper proposes an algorithm for dynamic network reconfiguration by centralized control among multiple basic service sets (BSSs) of the QoE-oriented WLAN, in order to maximize the number of traffic flows whose QoE requirements can be satisfied. With the proposed dynamic reconfiguration mechanism, stations (STAs) can change access point (AP) to connect. The operating frequency channel of a BSS also can be changed. These controls are performed according to the current channel occupancy rate of each BSS and the required radio resources to satisfy the QoE requirement of the traffic flow that is not allowed to transmit its data by the admission control. The effectiveness of the proposed dynamic network reconfiguration is evaluated through indoor experiments with assuming two cases. One is a 14-node experiment with QoE-oriented WLAN only, and the other is a 50-node experiment where the ordinary IEEE 802.11 WLAN and the QoE-oriented WLAN coexist. The experiment confirms that the QoE-oriented WLAN can significantly increase the number of traffic flows that satisfy their QoE requirements, total utility of network, and QoE-satisfied throughput, which is the system throughput contributing to satisfy the QoE requirement of traffic flows. It is also revealed that the QoE-oriented WLAN can protect the traffic flows in the ordinary WLAN if the border of the loadable capacity is properly set even in the environment where the hidden terminal problem occurs.