A flat stick-shaped whip antenna was developed for Japanese commercial portable telephones. It provides a high gain even though it is short and retractable. It is an open-sleeve type antenna. i.e., the inductance-loaded dipoleantenna element parallels a twin-lead type feeder. It suppresses the currents on the radio housing even at short antenna lengths. Moreover, it is easy to achieve two resonant characteristies and able to construct retractable type. A relatively high gain is gotten even when the antenna is in a retracted state. This antenna has a suitable configuration for commercial portable telephones. This paper first calculates, the current suppression of the housing on a principal model of this antenna, i.e., without a twin-lead feeder. The second analysis determines the effects of the twin-lead feeder and the dielectric coat on the antenna. Next,the two resonant technique and the configuration for the retractable-type antenna describes. In addition, the return loss and radiation pattern for the trial model were measured. The return loss shows that the two resonant characteristics and the bandwidths of the high and low resonant frequencies are 2.2% and 1.5%(VSWR2), respectively. For when the antenna is extended, radiation patterns are nearly the same as for the case of the 1/2 wavelength dipole antenna, and the antenna efficiencies are -1.6 dB at 820 MHz and -1.1 dB at 950 MHz. Other hand, for the retracted state, they are destroyed by the housing currents, but the efficiency is relatively high of -1.8 dB at 950 MHz. In these experiments, it is clear that the antenna achieves high performances.

This study proposes a novel resonator design that uses tightly coupled parallel coils to improve the quality factor (Q factor) in coupled magnetic resonance wireless power transfer. Depending on the characteristics of the tightly coupled parallel-connected coils, the proposed resonator can offer significantly reduced resistance with very little self-inductance loss. A double-layer spiral coil structure is used for resonator design and evaluating its characteristics. Measured results show that a resonator consisting of two identical, tightly coupled parallel double-layer spiral coils can match the Q factor of a conventional double-layer spiral coil with the same number of turns, even though its equivalent resistance is approximately 75% less. Moreover, the system power transfer performance of the resonator was measured under the impedance matching condition. To further reduce the resistance, we propose another resonator comprising of three parallel and tightly coupled double-layer spiral coils, and measure its equivalent resistance characteristics for different wire gap sizes.

To achieve a very high data rate within a limited frequency band in orthogonal frequency division multiplexing (OFDM) systems, multi-input multi-output (MIMO) techniques are very promising. Moreover, if a transmitter has the channel state information (CSI), the achievable spectrum efficiency can be maximized using the eigenbeam-space division multiplexing (E-SDM). However, this scheme demands accurate channel estimation. Therefore, in a closed-loop transmission scheme, an increase in the amount of feedback is absolutely necessary for the E-SDM. This paper describes a downlink beamforming method that significantly reduces the amount of feedback needed by using the common transmission weight vectors in all sub-carriers, compared to the amount required for E-SDM. The proposed method also applies transmission diversity to compensate for the quality. The effectiveness of the proposed method was confirmed using computer simulations in both Ricean and Rayleigh fading environments.

Wireless power transfer (WPT) based on electric coupled resonance can withstand a great level of variability in antenna separation. In this paper, we propose an independent electrical coupled resonance WPT system to further increase such systems' power transfer distance and ensure flexibility in the antenna location. The proposed system's power transfer function, critical coupling point, and resonance frequency splitting are investigated via the equivalent circuit, simulation, and experiment. Moreover, the input impedance characteristic of two electric coupled resonance antennas is also analyzed according to the transfer distance. In the region of under coupled, an appropriate impedance matching method is required to achieve effective power transfers. Here, we proposed a fixed configuration type matching loop with a series-connecting variable capacitance that can be added into both the source and load antennas. Experimental results demonstrate that the proposed matching loop can convert the two electric coupled resonance antennas' input impedance to the feed port impedance very well at varying transfer distances; these results are in good agreement with the simulation results.

A series-fed beam-scanning array employing a MUlti-Stage Configured microstrip Antenna with Tunable reactance devices (MUSCAT) is proposed. The proposed antenna significantly expands the beam scanning range and achieves high efficiency. This antenna comprises unit element groups, whose elements are placed close to each other and employ tunable reactance devices. Analyses and experiments on the unit element groups show that their multi-stage configuration extends the phase shift range and increases the radiation efficiency, e.g., a 120phase shift and the radiation efficiency of more than 50% are achieved, when three stages are employed. The radiation pattern of the fabricated MUSCAT array antenna comprising eight unit element groups is measured. A beam scanning range of 27, which is greater than twice the beam scanning range of a non-multi-stage configuration, is achieved.

Recently, Multiple Input Multiple Output-Orthogonal Frequency Division Multiplexing (MIMO-OFDM) has attracted much attention as a technology achieving high-speed wireless transmission with a limited bandwidth. However, since bit loading and adaptive modulation per sub-carrier should be employed according to the transmission quality of each sub-carrier in MIMO-OFDM, it is very important to understand the frequency correlation characteristics in broadband MIMO channels. This paper investigates the frequency correlation characteristics based on the antenna configuration for actual indoor MIMO channels. The results show that the frequency correlation of the channel capacity for the array antenna configured in the horizontal plane is significantly different compared to that configured in the vertical plane. Moreover, we propose a new cluster model that considers the antenna configuration in both the horizontal and vertical planes to estimate the frequency correlation in broadband MIMO channels.