Multiple-input multiple-output (MIMO) technology is a useful means of achieving the higher data rates needed in the latest wireless devices. However, weighting calculations for MIMO transmission become complicated when there are a large number of antennas. Thus, developing a simpler way to transmit and receive multiple streams is an idea worth considering. With this in mind, we propose a spatial division method using orthogonal directivities formed by using higher order modes of rectangular microstrip antennas. Each of them is formed by one antenna element so that channels are orthogonalized only by antennas. We verify antenna radiation characteristics by using higher order mode microstrip antennas and confirm that orthogonal directivities are obtained with them. Measurement of two stream transmission reveals that the method achieves almost the same channel capacity as that of an eigenmode-beamforming method because of the high multiplexing gain it achieves.

For quasi millimeter-wave and millimeter-wave high-speed wireless communications over wireless LANs and wireless ATMs, narrow beam antennas have been shown to provide high transmission quality by suppressing the troublesome multipath effect. However, the diameter of sector antennas needed to create the narrow beams rapidly increases with the sector number. In addition, the cylindrical shape of typical sector antennas does not suit portable terminals. This paper shows a methodology for designing planar sector antennas that overcomes these problems. The proposed antenna uses two kinds of beams and the antenna gains are equalized in all sectors. The antenna is developed as a 4-beam subarray fed by a planar Butler matrix circuit. The design method of the subarray and an evaluation of its characteristics in the 20 GHz band are discussed.

One of the procedures for increasing the number of multi-input and multi-output (MIMO) branches without increasing the computational cost for MIMO detection or multiplexing is to exploit parallel transmissions by using polarization multiplexing. In this paper the effectiveness of using polarization multiplexing is confirmed under the existence of polarization rotation, which is inevitably present in short-range multi-input and multi-output (SR-MIMO) channels with planar array antennas. It is confirmed that 8×8 SR-MIMO transmission system with polarization multiplexing has 60bit/s/Hz of channel capacity. This paper also shows a model for theoretical cross polarization discrimination (XPD) degradation, which is useful to calculate XPD degradations on diagonal paths.

Short-range Multiple-Input-Multiple-Output (SR-MIMO) transmission is an effective technique for achieving high-speed and short-range wireless communication. With this technique, however, the optimum aperture size of array antennas grows when the transmission distance is increased. Thus, antenna miniaturization is an important issue in SR-MIMO. In this paper, we clarify the effectiveness of using dual-polarized planar antennas as a means of miniaturizing SR-MIMO array antennas by measurements and analysis of MIMO transmission characteristics. We found that even in SR-MIMO transmission, the use of dual-polarized transmission enables higher channel capacity. Dual-polarized antennas can reduce by two thirds the array area that is needed to obtain the same channel capacity. For a transmission distance of two wavelengths, the use of a dual-polarized antenna improved the channel capacity by 26 bit/s/Hz while maintaining the same number of transmitters and receivers and the same antenna aperture size. Moreover, dual-polarized SR-MIMO has a further benefit when zero-forcing (ZF) reception without transmit beamforming is adopted, i.e., it effectively simplifies hardware configuration because it can reduce spatial correlation even in narrow element spacing. In this work, we confirmed that the application of dual-polarization to SR-MIMO is an effective way to both increase channel capacity and enhance transceiver simplification.

Sector antennas provide many advantages such as when combined with a narrow beam antenna, they become particularly effective in achieving high-speed wireless communication systems and they aid in simplifying the structure. These antennas have a drawback in that as the number of sectors increases, the antenna size rapidly increases. Therefore, downsizing the sector antenna has become a major research topic. A promising candidate is utilizing a phased-array type antenna; however, this antenna requires a phase-shifter circuit for beam scanning and generally the feeding circuit for this type of antenna is very complicated. To address these issues, we propose a self-selecting feeding circuit that is controlled by the same control circuit and is operated similarly to the conventional single port n-th throw (SPNT) switch. We fabricated a small cylindrical 12-sector antenna at 19 GHz employing the proposed feeding circuit for verification purposes. Furthermore, this paper clarifies the design method of this feeding circuit where the antenna diameter is 71 mm, and the results clearly show that the gain is more than 12 dBi.

Short-range multiple-input and multiple-output (SR-MIMO) has attracted much attention, because the technique makes it possible to raise channel capacity to several hundred Gbit/s by utilizing the millimeter-wave band (e.g., 60 GHz band). Although the opposed transceiving antennas are assumed to be accurately positioned in previous studies regarding SR-MIMO, a very important issue is to evaluate the performance degradation due to displacement between MIMO transceivers. In SR-MIMO over the millimeter-wave band, any displacement is perceived as significant because the wavelength is small. This paper evaluates the influence on SR-MIMO transmission performance over millimeter-wave caused by displacement between the transmitting and receiving antennas. The channel capacity is found to degrade by 5% when the horizontal displacement is 1 mm and by 2.7% when the rotational displacement is 10 degrees. In addition, comparing performances obtained with a number of antenna array arrangements clarifies that a square pattern arrangement is suitable for short-range wireless transmission.

A Simple decoding method for short-range MIMO (SR-MIMO) transmission can reduce the power consumption for MIMO decoding, but the distance between the transceivers requires millimeter-order accuracy in order to satisfy the required transmission quality. In this paper, we propose a phase difference control method between each propagation channel to alleviate the requirements for the transmission distance accuracy. In the proposed method, the phase difference between each propagation channel is controlled by changing the transmission (or received) power ratio of each element of sub-array antennas. In millimeter-wave broadband transmission simulation, we clarified that when sub-array antenna spacing is set to 6.6 mm and element spacing of sub-array antenna is set to 2.48mm, the proposed method can extend the transmission distance range satisfying the required transmission quality, which is that bit error rate (BER) before error correction is less than 10-2 from 9∼29mm to 0∼50mm in QPSK, from 15∼19mm to 0∼30mm in 16QAM, and from only 15mm to 4∼22mm in 64QAM.

This paper first presents an active integrated antenna configuration designed for broadband mobile wireless access systems using the 25-GHz band. This active integrated antenna comprises a microstrip antenna array and RF front-end circuits adopting spatial power combining schemes for reduced power consumption of the power amplifiers. Furthermore, the antenna and RF circuits are integrated into each side of a thick copper backing plate and both are connected through microstrip line /slot transitions. The developed active integrated antenna achieves the output power of 14.6 dBm and a noise figure of less than 5 dB. The wireless system using the developed active integrated antenna achieves a 6-dB improvement in the packet error rate compared to that using a passive antenna with the same array design as the active integrated antenna. Furthermore, we obtained the first license of the active integrated antenna for commercial use in high-speed wireless communication systems in Japan.

A method for increasing alignment tolerance in simple multiple-stream transmission is described. Its use of π-shifted antenna directivity phase enables it to cancel interference even when antenna placement deviations occur. The interference cancellation by using π-shifted directivities provides higher alignment tolerance than that with conventional fixed weight methods. It also provides smaller channel gain variation than can be obtained using fixed weights even when antenna displacement occurs. An objective function is described that is determined by the alignment tolerance. The function is defined to maximize the alignment tolerance. The method's validity is confirmed by an experimental analysis of two-stream transmission in which the alignment tolerance of the proposed method is compared to that of conventional fixed weight methods.

This paper proposes a new satellite communication system that enables high-speed communication in a mobile environment. The system configuration combines a terrestrial mobile network and an existing satellite system, and includes a tracking antenna that was newly developed to receive 30 Mbit/s signals from commercial communication satellites. A prototype system comprising the mobile network, the satellite system and a vehicle in which the tracking antenna is installed was constructed for purposes of evaluation and demonstration. A LAN system was incorporated in the experimental vehicle by using the tracking antenna, a satellite router and a Personal Digital Cellular phone. The validity of the proposed system was verified by the tracking antenna driving tests, system UDP tests and FTP throughput tests in a mobile environment.

Newly developed multi-layer inductors on GaAs three-dimensional MMICs are presented. We analyzed single-, double-, triple-, and quadruple-layer stacked-type inductors in what may be the first report on inductors on a GaAs MMIC with three or more layers. The performance of single- and multi-layer inductors was measured and calculated by electromagnetic field simulation. The multi-layer inductors produce 2-11 times higher inductance than that of conventional inductors on 2D-MMICs although they are the same size. This means that the proposed multi-layer inductors have smaller areas with the same inductances than those of conventional inductors. We also conducted the first-ever investigation of how performance factors such as parasitic capacitance, Q-factor, and self-resonant frequency are degraded in multi-layer inductors vis-a-vis those of conventional inductors. A microwave amplifier using multi-layer inductors was demonstrated and found to reduce circuit size by 20%.

We propose a novel feeding circuit for a 30 GHz planar multibeam antenna applied to high-speed wireless communication systems. The feeding circuit is a bi-layer 8-port Butler matrix constructed with phase adjusted slot-coupled hybrids and branch-line hybrids. The new circuit configuration eliminates troublesome vias and line crossings, so it can be manufactured by traditional photolithograph. The feeding circuit is designed by using the spectral domain moment method considering bonding film effects. A prototype of a multibeam antenna which has seven pencil-beams with 10 beamwidths is manufactured and tested; the beam scan angle error is less than 3 at 30 GHz.

Research on wireless power transmission technology is being actively conducted, and studies on spatial transmission methods such as SSPS are currently underway for applications such as power transfer to the upper part of steel towers and power transfer to flying objects such as drones. To enable such applications, it is necessary to examine the configuration of the power-transfer and power-receiving antennas and to improve the RF-DC conversion efficiency (hereinafter referred to as conversion efficiency) of the rectifier circuit on the power-receiving antenna. To improve the conversion efficiency, various methods that utilize full-wave rectification rather than half-wave rectification have been proposed. However, these come with problems such as a complicated circuit structure, the need for additional capacitors, the selection of components at high frequencies, and a reduction in mounting yield. In this paper, we propose a method to improve the conversion efficiency by loading a high-impedance microstrip line as a feedback line in part of the rectifier circuit. We analyzed a class-F rectifier circuit using circuit analysis software and found that the conversion efficiency of the conventional configuration was 54.2%, but the proposed configuration was 69.3%. We also analyzed a measuring circuit made with a discrete configuration in the 5.8-GHz band and found that the conversion efficiency was 74.7% at 24dBm input.

A novel analog decoding method using only 90-degree phase shifters is proposed to simplify the decoding method for short-range multiple-input multiple-output (MIMO) transmission. In a short-range MIMO transmission, an optimal element spacing that maximizes the channel capacity exists for a given transmit distance between the transmitter and receiver. We focus on the fact that the weight matrix by zero forcing (ZF) at the optimal element spacing can be obtained by using dividers and 90-degree phase shifters because it can be expressed by a unitary matrix. The channel capacity by the proposed method is next derived for the evaluation of the exact limitation of the channel capacity. Moreover, it is shown that an optimal weight when using directional antennas can be expressed by using only dividers, 90-degree phase shifters, and attenuators, regardless of the beam width of the directional antenna. Finally, bit error rate and channel capacity evaluations by both simulation and measurement confirm the effectiveness of the proposed method.

This paper presents a spatial division (SD) transmission method based on two-ray fading that dispenses with the high signal processing cost of multiple-input and multiple-output (MIMO) detection and antennas with narrow beamwidth. We show the optimum array geometries as functions of the transmission distance for providing a concrete array design method. Moreover, we clarify achievable channel capacity considering reflection coefficients that depend on the polarization, incident angle, and dielectric constant. When the ground surface is conductive, for two- and three-element arrays, channel capacity is doubled and tripled, respectively, over that of free space propagation. We also clarify the application limit of this method for a dielectric ground by analyzing the channel capacity's dependency on the dielectric constant. With this method, increased channel capacity by SD transmission can be obtained merely by placing antennas of wireless transceiver sets that have only SISO (single-input and single-output) capability in a two-ray propagation environment. By using formulations presented in this paper for the first time and adding discussions on the adoption of polarization multiplexing, we clarify antenna geometries of SD transmission systems using polarization multiplexing for up to six streams.

This paper proposes a sector base station antenna for mobile wireless communication systems employing multiple woodpile metamaterial reflectors and a multiband radiator that establishes the same beamwidth in the horizontal plane for more than two frequency bands. Electromagnetic Band Gap (EBG) characteristics of each metamaterial reflector can be controlled through structural parameters of the woodpile reflector, e.g., the rod width and rod spacing. As an example of the proposed antenna, a design for a triple-frequency-band antenna that radiates at 800 MHz, 2,GHz, and 4,GHz is shown. The algorithm used to adjust the beamwidth of the proposed antenna is newly introduced and adjusts the beamwidth to be the same for each band using the rod width of the woodpile. A prototype of the proposed antenna has the approximately 90$^{circ}$ beamwidth in the horizontal plane at the three frequencies, and the measurement results agree well with the electromagnetic field simulation results.

A series-fed beam-scanning array employing a MUlti-Stage Configured microstrip Antenna with Tunable reactance devices (MUSCAT) is proposed. The proposed antenna significantly expands the beam scanning range and achieves high efficiency. This antenna comprises unit element groups, whose elements are placed close to each other and employ tunable reactance devices. Analyses and experiments on the unit element groups show that their multi-stage configuration extends the phase shift range and increases the radiation efficiency, e.g., a 120phase shift and the radiation efficiency of more than 50% are achieved, when three stages are employed. The radiation pattern of the fabricated MUSCAT array antenna comprising eight unit element groups is measured. A beam scanning range of 27, which is greater than twice the beam scanning range of a non-multi-stage configuration, is achieved.