This paper presents a spatial division (SD) transmission method based on two-ray fading that dispenses with the high signal processing cost of multiple-input and multiple-output (MIMO) detection and antennas with narrow beamwidth. We show the optimum array geometries as functions of the transmission distance for providing a concrete array design method. Moreover, we clarify achievable channel capacity considering reflection coefficients that depend on the polarization, incident angle, and dielectric constant. When the ground surface is conductive, for two- and three-element arrays, channel capacity is doubled and tripled, respectively, over that of free space propagation. We also clarify the application limit of this method for a dielectric ground by analyzing the channel capacity's dependency on the dielectric constant. With this method, increased channel capacity by SD transmission can be obtained merely by placing antennas of wireless transceiver sets that have only SISO (single-input and single-output) capability in a two-ray propagation environment. By using formulations presented in this paper for the first time and adding discussions on the adoption of polarization multiplexing, we clarify antenna geometries of SD transmission systems using polarization multiplexing for up to six streams.

Multiple-input multiple-output (MIMO) technology is a useful means of achieving the higher data rates needed in the latest wireless devices. However, weighting calculations for MIMO transmission become complicated when there are a large number of antennas. Thus, developing a simpler way to transmit and receive multiple streams is an idea worth considering. With this in mind, we propose a spatial division method using orthogonal directivities formed by using higher order modes of rectangular microstrip antennas. Each of them is formed by one antenna element so that channels are orthogonalized only by antennas. We verify antenna radiation characteristics by using higher order mode microstrip antennas and confirm that orthogonal directivities are obtained with them. Measurement of two stream transmission reveals that the method achieves almost the same channel capacity as that of an eigenmode-beamforming method because of the high multiplexing gain it achieves.

One of the procedures for increasing the number of multi-input and multi-output (MIMO) branches without increasing the computational cost for MIMO detection or multiplexing is to exploit parallel transmissions by using polarization multiplexing. In this paper the effectiveness of using polarization multiplexing is confirmed under the existence of polarization rotation, which is inevitably present in short-range multi-input and multi-output (SR-MIMO) channels with planar array antennas. It is confirmed that 8×8 SR-MIMO transmission system with polarization multiplexing has 60bit/s/Hz of channel capacity. This paper also shows a model for theoretical cross polarization discrimination (XPD) degradation, which is useful to calculate XPD degradations on diagonal paths.

A Simple decoding method for short-range MIMO (SR-MIMO) transmission can reduce the power consumption for MIMO decoding, but the distance between the transceivers requires millimeter-order accuracy in order to satisfy the required transmission quality. In this paper, we propose a phase difference control method between each propagation channel to alleviate the requirements for the transmission distance accuracy. In the proposed method, the phase difference between each propagation channel is controlled by changing the transmission (or received) power ratio of each element of sub-array antennas. In millimeter-wave broadband transmission simulation, we clarified that when sub-array antenna spacing is set to 6.6 mm and element spacing of sub-array antenna is set to 2.48mm, the proposed method can extend the transmission distance range satisfying the required transmission quality, which is that bit error rate (BER) before error correction is less than 10-2 from 9∼29mm to 0∼50mm in QPSK, from 15∼19mm to 0∼30mm in 16QAM, and from only 15mm to 4∼22mm in 64QAM.

A method for increasing alignment tolerance in simple multiple-stream transmission is described. Its use of π-shifted antenna directivity phase enables it to cancel interference even when antenna placement deviations occur. The interference cancellation by using π-shifted directivities provides higher alignment tolerance than that with conventional fixed weight methods. It also provides smaller channel gain variation than can be obtained using fixed weights even when antenna displacement occurs. An objective function is described that is determined by the alignment tolerance. The function is defined to maximize the alignment tolerance. The method's validity is confirmed by an experimental analysis of two-stream transmission in which the alignment tolerance of the proposed method is compared to that of conventional fixed weight methods.