This paper investigates receive power control for multiuser inductive power transfer (IPT) systems with a single-frequency coil array. The primary task is to optimize the transmit coil currents to minimize the total input power, subject to the minimum receive powers required by individual users. Due to the complicated coupling mechanism among all transmit coils and user pickups, the optimization problem is a non-convex quadratically constrained quadratic program (QCQP), which is analytically intractable. This paper solves the problem by applying the semidefinite relaxation (SDR) technique and evaluates the performance by full-wave electromagnetic simulations. Our results show that a single-frequency coil array is capable of power control for various multiuser scenarios, assuming that the number of transmit coils is greater than or equal to the number of users and the transmission conditions for individual users are uncorrelated.

This paper studies the joint optimization of precoding, transmit power and data rate allocation for energy-efficient full-duplex (FD) cloud radio access networks (C-RANs). A new nonconvex problem is formulated, where the ratio of total sum rate to total power consumption is maximized, subject to the maximum transmit powers of remote radio heads and uplink users. An iterative algorithm based on successive convex programming is proposed with guaranteed convergence to the Karush-Kuhn-Tucker solutions of the formulated problem. Numerical examples confirm the effectiveness of the proposed algorithm and show that the FD C-RANs can achieve a large gain over half-duplex C-RANs in terms of energy efficiency at low self-interference power levels.

Parallel line feeder (PLF) consisting of a two-wire transmission line operating in the MHz band has been proposed as a wide-coverage short-distance wireless charging. In the MHz band, a PLF of several meters suffers from standing wave effect, resulting in fluctuation in power transfer efficiency accordingly to the receiver's position. This paper studies a modified version of the system, where the PLF is divided into individually compensated segments to mitigate the standing wave effect. Modelling the PLF as a lossy transmission line, this paper theoretically shows that if the segments' lengths are properly determined, it is able to improve and stabilize the efficiency for all positions. Experimental results at 27.12 MHz confirm the theoretical analysis and show that a fairly high efficiency of 70% can be achieved.

This paper proposes constant voltage design based on K-inverter for cooperative inductive power transfer (IPT) where a nearby receiver picks up power and simultaneously cooperates in relaying the signal toward another distant receiver. In a cooperative IPT system, wireless power is fundamentally transferred to the nearby receiver via one K-inverter and to the distant receiver via two K-inverters. By adding one more K-inverter to the nearby receiver, our design is among the simplest methods as it delivers constant output voltage to each receiver via two K-inverters only. Experimental results verify that the proposed cooperative IPT system can stabilize two output voltages against the load variations while attaining high RF-RF efficiency of 90%.

Optimal loads and maximum achievable efficiency for multiple-receiver inductive power transfer (IPT) system have been formulated by theoretical studies in literatures. This paper presents extended analysis on system behavior at optimal load condition and extensive S-parameter evaluation to validate the formulas. Our results confirm that at the optimal load condition, the system is in a resonance state; the impact of cross-coupling among receivers is completely mitigated; and the efficiency reaches its maximum expressed by an efficiency angle tangent, in an manner analogous to the well-known kQ-theory for single-receiver IPT. Our contributions do not lie in practical applications of multiple-receiver IPT but in establishing principles for design and benchmarking the system.