We investigate the engineering of the impurity bands in photonic crystals (PCs) for realizing high-efficiency wave guiding, all-optical switching and optical delay for ultrashort optical pulses. It is found that quasi-flat impurity bands suitable for the transmission of ultrashort pulses can be achieved by properly controlling the configuration of coupled cavity waveguides (CCWs). At sharp corners, high bending efficiency is obtained over the entire impurity band. All-optical switching can be realized by creating a dynamical band gap at the center of an impurity band. The concentration of electromagnetic wave at defect regions leads to high switching efficiency while the tunable feature of PC defects makes all-optical control possible. It is also revealed that CCWs with quasi-flat impurity bands provide efficient group delay for ultrashort pulses with negligible attenuation and distortion. From the viewpoint of practical fabrication, the effect of disorder on the transmission property of impurity bands is discussed and the criterion for localization transition is determined.

An all-optical switch based on a single photonic crystal defect with an air-bridge configuration and two-photon absorption was proposed, fabricated and characterized. In optical measurements, we obtained a sharp defect mode with a quality factor higher than 600 at 1.55 µm. More importantly, we observed its nonlinear response to the excitation of ultrashort pulses by utilizing two-photon absorption. Nonliner refractive index change of about -410-3 was achieved at a pumping power density of 3.6109 W/cm2.