Sr0. 7Bi2. 3Ta2O9(SBT) films are drawing attention as fatigue-free materials. We prepared an SBT film containing discontinuous crystals in the Bi-layered compound using a misted deposition method. In comparison to films prepared by the spin-on method, leakage current was low and spontaneous polarization is high but saturation performance was low. The low saturation performance seems attributable to the inclusion of discontinuous crystals in the Bi-layered compound, while the low leakage current may be explained by the films smaller, denser particles, which form a film without voids, resulting in higher uniformity. The misted deposition method has advantages of finer grain size and higher uniformity.

We prepared alkoxide solutions to fabricate SrBi2Ta2O9 (SBT) ferroelectric capacitors with IrO2 electrodes. In this process, to minimize excess bismuth, the Sr : Bi : Ta mole ratio was kept at 0. 9 : 2. 1 : 2. 0, i. e. , nearly stoichiometric. Three types of solution - mixed-only (MIX), complexed (COMP), and hydrolyzed (HYD) - were used. The HYD capacitor had low absolute leakage current, 10-7 A/cm2 order, and good saturation properties to 6 V. When voltage was applied to each capacitor at 2 to 6 V, MIX and COMP capacitors showed only partial hysteresis loops due to a high leakage current, reflecting the I-V characteristics. These results are probably due to film density caused by metaloxane network bonding. A fatigue endurance test was conducted using cycling of polarization switching at 6 V using the HYD capacitor with IrO2 electrodes. Slight changes were, however, observed in hysteresis loop configuration, but good hysteresis properties were kept up to 1. 04 1012 cycles. We compared SBT ferroelectric thin films fabricated with Pt electrodes and with IrO2 electrodes. Scarcely any difference due to SBT in the XRD pattern was seen, depending on the substrate material. We found that the use of IrO2 electrodes had the effect of decreasing the crystallization temperature. On Pt and IrO2 electrodes, the two films have surface morphology quite different from that of the rod-like structure wellknown for SBT films prepared using a metal 2-ethylhexanate solution. Their surfaces show a similar morphology with relatively large, closely packed grains. A comparison of the I-V characteristics after reannealing showed that the capacitor with IrO2 electrodes had a higher leakage current than that with Pt electrodes. The leakage current was probably due to the density of the film and interface between the SBT film and electrodes.