The purpose of this study is to establish a whole-body averaged specific absorption rate (WB-SAR) estimation method using the power absorbed by humans; a cylindrical-external field scanning technique is used to measure the radiated RF (radio-frequency) power. This technique is adopted with the goal of simplifying the estimation of the exposure dosimetry of humans who have different postures and/or sizes. In this paper, to validate the proposed measurement method, we subject numerical human phantom models and cylindrical scanning conditions to FDTD analysis. We design a radiation system that uses a dielectric lens to achieve plane-wave irradiation of tested human phantoms in order to develop an experimental WB-SAR measurement system for UHF far-field exposure condition. In addition, we use a constructed SAR measurement system to confirm absorbed power estimations of simple geometrical phantoms and so estimate measurement error of the measurement system. Finally, we discuss the measurement results of WB-SARs for male adult and child human phantom models.

This paper discusses a method to evaluate mutual couplings of cavity-backed slot antennas using the FDTD technique. The antenna fed by the short-ended probe is considered, which is investigated as an element of the power transmission antenna, Spacetenna, for the solar power satellite SPS2000. It is found from the FDTD computation on E-plane two- and four-element array antennas that the size of the problem space should be larger for the evaluation of the mutual coupling than for the estimation of the input impedance. Since enlarging the size of the problem space requires a large amount of computer storage, it is not practical for computer simulations. In order to carry out accurate estimations of the mutual coupling with relatively small amount of computer memory, the problem space is extended only in the broadside of the array antenna and in the other directions there are ten cells between the antenna surface and the outer boundary. Computer simulations demonstrate that there are no differences between the results of the proposed problem space geometry and the problem space extended in each direction of the axis coordinate by the same number of cells. Furthermore comparisons of computed and experimental results demonstrate the effectiveness of the approach after discussing how large the size of the problem space is required to estimate the mutual coupling.