Accurate on-chip 100-ps/100-µV waveform measurements of signal transition in a large-scale digital integrated circuit clearly demonstrates the correlation of dynamic delay variation with power supply noise waveforms. In addition to the linear dependence of delay increase with the height of static IR drop, the distortion of a signal waveform during a logic transition that is induced by dynamic power supply noise causes significant delay variation. However, an analysis reveals that average modeling of dynamic power supply noise, which is often used in conventional simulation techniques, cannot match the experimentally measured values. Our proposed circuit simulation technique, which incorporates time-domain power supply noise waveform macro models along with parasitic impedance networks, reproduces the delay variation well, even with a relative timing difference among different clock domains. Such basic knowledge can be applied in precise delay calculations that consider dynamic power supply noise, a crucial factor in deep sub-100-nm LSI design.

In this letter, we show the effects of the chip waveform selection on the detection performance of the energy detector in DS/SS communications. Three chip waveforms such as rectangular, half-sine and raised-cosine are examined as the DS/SS chip waveform. It is demonstrated that the partial-band detection can enhance the detection performance of the energy detector approximately 50-70% compared with the full-band detection. When the chip rate is identical, the raised-cosine waveform shows lower detection probability due to its wider spreading bandwidth. However, when the spreading bandwidth is identical, the rectangular waveform shows lower detection probability due to its lower partial-band energy factor.

This letter studies the impact of chip waveform shaping on the multiple access interference (MAI) in band-limited direct sequence code-division multiple access (DS-CDMA) systems. The family of band-limited waveforms with zero interchip interference (ICI) and with an excess bandwidth β in the range 0β 1 is considered. A criterion for the performance comparison of various band-limited chip waveforms based on the elementary density function is established. The effect of varying the roll-off factor of a band-limited chip waveform on the MAI level is also investigated.

In this paper, the design of signature waveforms for asynchronous CDMA systems equipped with a correlation receiver is first considered. Optimal signature waveforms that minimize the average multiple access interference (MAI) at the output of a correlation receiver are found, while satisfying the constraint on available transmission bandwidth. Comparison to signature waveforms previously obtained for synchronous systems is also made to justify the superior performance of the designed signature waveforms in asynchronous systems. Furthermore, for direct-sequence CDMA (DS-CDMA) systems with random signature sequences, the use of multiple chip waveforms is also proposed as a means of suppressing MAI. Bandwidth constrained multiple chip waveforms that maximize the signal-to-interference ratio (SIR) at the output of each correlation receiver are found. Numerical results show that by using double chip waveforms instead of a single chip waveform, it is possible to reduce the MAI by 10% for a fixed transmission bandwidth (or equivalently, to save about 10% of transmission bandwidth for a given SIR requirement). The advantage of using double chip waveforms is also demonstrated in terms of the bit error rate (BER), whose calculation is based on our extension to Holtzman's approximation in.