In this paper, an experimental method is proposed for extracting the primary and secondary parameters of transmission lines with frequency dispersion. So far, there is no report of these methods being applied to transmission lines with frequency dispersion. This paper provides an experimental evaluation means of transmission lines with frequency dispersion and clarifies the issues when applying the proposed method. In the proposed experimental method, unnecessary components such as connectors are removed by using a simple de-embedding method. The frequency response of the primary and secondary parameters extracted by using the method reproduced all dispersion characteristics of a transmission line with frequency dispersion successfully. It is demonstrated that an accurate RLGC equivalent-circuit model is obtained experimentally, which can be used to quantitatively evaluate the frequency/time responses of shielded-FPC with frequency dispersion and to validate RLGC equivalent-circuit models extracted by using electromagnetic field analysis.

In this paper, dependency of transmission loss of shielded-flexible printed circuits (FPC) for differential-signaling on thickness of conductive shield is studied by numerical modeling based on an equivalent circuit model compared with the experimental results. Especially, the transmission loss due to the thin conductive shield is focused. The insufficient shielding performance for near magnetic field decreases the resistance due to the thin conductive shield. It is shown that the resistance due to the thin conductive shield at lower frequencies is smaller than that in the “thick conductive shield” case.

To provide basic considerations for the realization of method for suppressing the EMI from differential-paired lines on flexible printed circuits (FPC), the characteristics of the SI performance and shielding effectiveness (SE) of shielded-flexible printed circuits for differential-signaling are investigated in this paper experimentally and by a numerical modeling. Firstly, transmission characteristics of TDR measurement and frequency response of |Sdd21| are discussed, from view point of signal integrity. Secondly, as the characteristics of the SE performance for EMI, frequency responses of magnetic field are investigated. Although placement of conductive shield near the paired-lines decreases characteristics impedance, |Sdd21| for the “with Cu 5.5 µm-thickness copper shield” is not deteriorated compared with “without shield” and sufficient SE performance for magnetic field can be established. But, thin-shield deteriorates SI as well as SE performances. The frequency response of |Sdd21| at higher frequencies for the “Ag 0.1 µm” case has the steep loss roll off. A reflection loss resulted from impedance-mismatching is not dominant factor of the losses. The dominant factor may be magnetic field leakage due to very thin-conductive shield.

A new shielding evaluation setup for conductive O-rings is proposed. This setup consists of the holder with a groove to fix the O-ring position. There are two ways to apply O-rings in narrow gaps, cylinder-fixing and plane-fixing. With this holder shielding effects of the O-rings can be evaluated from 10 kHz to 1 GHz for both fixing types.

Electromagnetic shielding clothes for reducing human exposure to radio waves have been commercialized. However, their effect has so far been confirmed only in the form of the raw material. In this paper, we develop a new compact scheme for measuring electromagnetic radiations using a short dipole antenna and Gaussian pulses in order to evaluate the effect of the shielding clothes over a wide frequency range with the aid of time-domain measurements and FDTD computation. The proposed method is based on a time-domain analysis technique and pulse compression technique, which enables the user to separate the direct transmission wave from the reflection from the floor as well as from the refracted wave around the neck of the clothes. The direct advantage is that measurements can be made in an ordinary laboratory without the function of an electromagnetic anechoic chamber. Also, we can separate direct transmission wave and diffraction wave from the measurement result by using pulse compression technique, then each frequency characteristic of the shielding shirt can be evaluated. The performance of the separation is confirmed by comparing the measurements with those of a shirt with no opening. We further demonstrate the possibility of predicting the effective conductivity of the material as a function of frequency by comparing the measured results with realistic FDTD computations, which will enable us to design a shielding shirt via numerical means.