We evaluated the transmission performance, including received power and transmission throughput characteristics, in 4×4 single-user multiple-input multiple-output (SU-MIMO) transmission for synchronous time division duplex (TDD) and downlink data channels in comparison with single-input single-output (SISO) transmission in an environment where a local 5G wireless base station was installed on the roof of a research building at our university. Accordingly, for the received power characteristics, the difference between the simulation value, which was based on the ray tracing method, and the experimental value at 32 points in the area was within a maximum difference of approximately 10 dB, and sufficient compliance was obtained. Regarding the transmission throughput versus received power characteristics, after showing a simulation method for evaluating throughput characteristics in MIMO, we compared the results with experimental results. The cumulative distribution function (CDF) of the transmission throughput shows that, at a CDF of 50%, in SISO transmission, the simulated value is approximately 115Mbps, and the experimental value is 105Mbps, within a difference of approximately 10Mbps. By contrast, in MIMO transmission, the simulation value is 380Mbps, and the experimental value is approximately 420Mbps, which is a difference of approximately 40Mbps. It was shown that the received power and transmission throughput characteristics can be predicted with sufficient accuracy by obtaining the delay profile and the system model at each reception point using the both ray tracing and MIMO simulation methods in actual environments.

This paper demonstrates the suppressing power of 10 Gbps On Off keyed signal using biased half-wave rectification. Authors have previously reported that radio frequency (RF) and optical on-off keying (OOK) signal can be simultaneously transmitted over the radio over fiber (RoF) link [1]. Since the optical OOK signal has much broader bandwidth compared to RF signal, it interferes with RF signal. Reference [1] experimentally shows that the optical OOK signal degrades the RF signal in terms of signal-to-noise power ratio (SNR) when 10 Gbps OOK and 1.9 GHz microwave are employed as baseband and RF, respectively. This paper proposes an interference suppression, and the proposal is subsequently used for detecting the RF signal. Experiments are conducted for the purpose of the proof-of-concept of the proposal. Finally numerical simulations are employed to show the performance enhancement in terms of error vector magnitude (EVM).

Terahertz (THz) band is an attractive candidate for future broadband (> 10 Gb/s) wireless backhaul and fronthaul. THz transmitter employing optical frequency comb can provide high quality THz carrier, and is useful to the future broadband THz communication systems based on coherent transmission technique. To realize coherent transmission, high quality carrier generation is essential and it is important to evaluate the signal quality of a THz transmitter. In this paper, we derive error vector magnitude (EVM) including optical impairments (optical amplifier noise, laser phase noise, optical crosstalk and IQ imbalance of optical modulator) of the optical frequency comb based transmitter. The calculated EVM is in good agreement with simulated one, and practical requirements for optical impairment are indicated. The analysis will be useful in the design of THz transmission systems employing an optical frequency comb.

The k-error linear complexity of periodic sequences is an important security index of stream cipher systems. By using an interesting decomposing approach, we investigate the intrinsic structure for the set of 2n-periodic binary sequences with fixed complexity measures. For k ≤ 4, we construct the complete set of error vectors that give the k-error linear complexity. As auxiliary results we obtain the counting functions of the k-error linear complexity of 2n-periodic binary sequences for k ≤ 4, as well as the expectations of the k-error linear complexity of a random sequence for k ≤ 3. Moreover, we study the 2t-error linear complexity of the set of 2n-periodic binary sequences with some fixed linear complexity L, where t < n-1 and the Hamming weight of the binary representation of 2n-L is t. Also, we extend some results to pn-periodic sequences over Fp. Finally, we discuss some potential applications.

In this paper, a simple and efficient design scheme for digital compensation of path imbalances in linear amplification with nonlinear component (LINC) transmitters is proposed to reduce signal distortion. For the LINC transmitters including path imbalances, an error vector magnitude (EVM) is analyzed and an optimal complex gain that minimizes the EVM is extracted. In addition, a straight-forward compensation scheme for the path imbalances is proposed using a least square method for complex gains of each radio frequency path. The effectiveness of the proposed method is compared with the other digital compensation methods. A LINC transmitter with multi-level quadrature amplitude modulation input signals is experimented to verify the performance of the suggested scheme. The proposed compensator can reduce the EVM and the adjacent channel power ratio of the output signals less than 2% and 45 dBc, respectively.

This paper suggests an outphasing scheme to reduce adjacent channel spectral regrowth triggered by the gain and phase mismatch between two signal paths in linear amplification with nonlinear component (LINC) systems. The error vector magnitude and power spectral density of the output signal considering path mismatch are described analytically using path mismatch factor. An outphasing scheme is proposed to reduce the spectral regrowth. The proposed outphasing scheme reshapes the phases of the separated signals in LINC systems to reduce the changes of the phases. Its performance is verified by performing simulations with multi-tone signals. The result shows that the scheme can reduce the spectral regrowth of the multi-tone signals significantly compared to the conventional outphasing scheme for LINC systems with path imbalance.

Nonlinear distortions in power amplifiers (PAs) generate spectral regrowth at the output, which causes interference to adjacent channels and errors in digitally modulated signals. This paper presents a novel method to evaluate adjacent channel leakage power ratio (ACPR) and error vector magnitude (EVM) from the amplitude-to-amplitude (AM/AM) and amplitude-to-phase (AM/PM) characteristics. The transmitted signal is considered to be complex Gaussian distributed in orthogonal frequency-division multiplexing (OFDM) systems. We use the Mehler formula to derive closed-form expressions of the PAs output power spectral density (PSD), ACPR and EVM for memoryless PA and memory PA respectively. We inspect the derived relationships using an OFDM signal in the IEEE 802.11a WLAN standard. Simulation results show that the proposed method is appropriate to predict the ACPR and EVM values of the nonlinear PA output in OFDM systems, when the AM/AM and AM/PM characteristics are known.

We derived explicit formulas for evaluating the error vector magnitude (EVM) from the amplitude distortion (AM-AM) and phase distortion (AM-PM) of power amplifiers (PAs) in orthogonal frequency-division multiplexing (OFDM) systems, such as the IEEE 802.11a/g wireless local area networks (WLANs) standards. We demonstrated that the developed formulas allowed EVM simulation of a memoryless PA using only a single-tone response (i.e. without OFDM modulation and demodulation), thus enabling us to easily simulate the EVM using a harmonic-balance (HB) simulator. This HB simulation technique reduced the processing time required to simulate the EVM of a PA for the IEEE 802.11a standard by a factor of ten compared to a system-level (SL) simulation. We also demonstrated that the measured EVM of a PA module for the IEEE 802.11g could accurately be predicted by applying the measured static AM-AM and AM-PM characteristics to the derived formulas.