The search functionality is under construction.
The search functionality is under construction.

Keyword Search Result

[Keyword] intensity modulation(8hit)

1-8hit
  • Accurate BER Approximation for SIM with BPSK and Multiple Transmit Apertures over Strong Atmospheric Turbulence

    Jinkyu KANG  Seongah JEONG  Hoojin LEE  

     
    LETTER-Communication Theory and Signals

      Pubricized:
    2021/07/30
      Vol:
    E105-A No:2
      Page(s):
    126-129

    In this letter, we derive a novel and accurate closed-form bit error rate (BER) approximation of the optical wireless communications (OWC) systems for the sub-carrier intensity modulation (SIM) employing binary phase-shift keying (BPSK) with multiple transmit and single receive apertures over strong atmospheric turbulence channels, which makes it possible to effectively investigate and predict the BER performance for various system configurations. Furthermore, we also derive a concise asymptotic BER formula to quantitatively evaluate the asymptotically achievable error performance (i.e., asymptotic diversity and combining gains) in the high signal-to-noise (SNR) regimes. Some numerical results are provided to corroborate the accuracy and effectiveness of our theoretical expressions.

  • Peculiar Characteristics of Amplification and Noise for Intensity Modulated Light in Semiconductor Optical Amplifier

    Kazuki HIGUCHI  Nobuhito TAKEUCHI  Minoru YAMADA  

     
    PAPER-Lasers, Quantum Electronics

      Vol:
    E97-C No:11
      Page(s):
    1093-1103

    Amplification characteristics of the signal and the noise in the semiconductor optical amplifier (SOA), without facet mirrors for the intensity modulated light, are theoretically analyzed and experimentally confirmed. We have found that the amplification factor of the temporarily varying intensity component is smaller than that of the continuous wave (CW) component, but increases up to that of the CW component in the high frequency region in the SOA. These properties are very peculiar in the SOA, which is not shown in conventional electronic devices and semiconductor lasers. Therefore, the relative intensity noise (RIN), which is defined as ratio of the square value of the intensity fluctuation to that of the CW power can be improved by the amplification by the SOA. On the other hand, the signal to the noise ratio (S/N ratio) defined for ratio of the square value of the modulated signal power to that of the intensity fluctuation have both cases of the degradation and the improvement by the amplification depending on combination of the modulation and the noise frequencies. Experimental confirmations of these peculiar characteristics are also demonstrated.

  • Subcarrier Intensity Modulation/Spatial Modulation for Optical Wireless Communications

    Yan CHENG  Seung-Hoon HWANG  

     
    PAPER-Wireless Communication Technologies

      Vol:
    E97-B No:5
      Page(s):
    1044-1049

    In this paper, we investigate a combination scheme of subcarrier intensity-modulation (SIM) with spatial modulation (SM) for optical wireless communication. Using computer simulation, the performances of the proposed SIM/SM scheme are investigated and compared with those of the conventional SIM scheme in the additive white gaussian noise (AWGN) as well as in outdoor environment with turbulence induced fading characteristics. Numerical results show that the proposed SIM/SM scheme can outperform the conventional SIM in an environment with different spectral efficiencies. When the spectral efficiency is varied from 2bits/s/Hz to 4bits/s/Hz, an Eb/N0 gain of 2dB to 5dB is achieved, when the bit error rate of 10-5 is maintained. It shows that the employment of SM may further improve the power efficiency of SIM, when the number of subcarriers increases according to the spectral efficiency. When the spectral efficiency is 4bits/s/Hz, the SIM/SM scheme for 0.5 of log-irradiance variance in the log-normal turbulence channel shows the same performance as SIM with variance of 0.3. This means that the SIM/SM can be an alternative choice in even worse environments.

  • Bandwidth Enhanced Operation of Single Mode Semiconductor Laser by Intensity Modulated Signal Light Injection

    Hiroki ISHIHARA  Yosuke SAITO  Wataru KOBAYASHI  Hiroshi YASAKA  

     
    BRIEF PAPER-Lasers, Quantum Electronics

      Vol:
    E95-C No:9
      Page(s):
    1549-1551

    3 dB bandwidth enhancement of single mode semiconductor lasers is confirmed numerically and experimentally when they are operated by intensity modulated signal light injection. 3 dB bandwidth is enlarged to 2.5 times of resonant frequency. The numerical analysis of rate equations predicts that the bandwidth enhancement is accomplished by the modal gain control of semiconductor lasers with injected intensity modulated signal light through non-linear gain coefficient term.

  • Optical Wireless N-CSK with Modified Pseudo Orthogonal M-Sequence Sets

    Yusuke KOZAWA  Hiromasa HABUCHI  

     
    PAPER-Spread Spectrum Technologies and Applications

      Vol:
    E94-A No:11
      Page(s):
    2188-2193

    In this paper, N-CSK (N parallel Codes Shift Keying) using modified pseudo orthogonal M-sequence sets (MPOMSs) to realize the parallel combinatory spread spectrum (PC/SS) communication system for the optical communications is proposed. Moreover, the upper bound of data transmission rate and the bit error rate (BER) performance of this N-CSK system using the chip-level detection are evaluated through theoretical analysis by taking into account the scintillation, background-noise, avalanche photo-diode (APD) noise, thermal noise, and signal dependence noise. It is shown that the upper bound of data transmission rate of the proposed system is better than those of OOK/CDM and SIK/CDM. Moreover, the upper bound of data transmission rate of the proposed system can achieve about 1.5 [bit/chip] when the code length of MPOMS is 64 [chip].

  • Novel Optoelectronic Networks Using Cascaded Optical Intensity Modulation Links for Frequency Multiplexing and Mixing.

    Yoshinori NAKASUGA  Kohji HORIKAWA  Hiroyo OGAWA  

     
    PAPER-System Applications

      Vol:
    E79-C No:1
      Page(s):
    105-110

    A new configuration is proposed for an optoelectronic network (OEN) using microwave frequency mixing and multiplexing. The mn OEN consists of m optical sources, m-parallel n-stage cascaded optical intensity modulators, and m-photodetectors. The mn OEN matrix is theoretically discussed, and 12, 22 and 33 OENs are analyzed in detail. The 22 OEN, which mixes and multiplexes microwaves, is further investigated and the theoretical prediction derived from OEN equations is experimentally confirmed.

  • Future Technology Trends on Magneto-Optical Recording

    Fumio KUGIYA  Takeshi MAEDA  Masahiko TAKAHASHI  

     
    INVITED PAPER

      Vol:
    E78-C No:11
      Page(s):
    1499-1508

    Computer circumstance have changed drastically, and larger capacity removable media is indispensable. Magneto-optical disk is promising candidate to satisfy computer user's needs. In this report, future perspective of high density magneto-optical recording technology is investigated.

  • XPM Effect in Coherent FDM Systems Using FSK and Heterodyne Detection Scheme

    Katsuhiko KUBOKI  Yusuke UCHIDA  

     
    INVITED PAPER

      Vol:
    E78-B No:5
      Page(s):
    654-663

    Cross-phase modulation (XPM) induced by residual intensity modulation in coherent optical frequency-shift-keying (FSK) frequency division multiplexing (FDM) transmission systems that use dispersion-shifted fibers is evaluated theoretically and experimentally in terms of spectral profile deformation. The bit-error rate is measured in a 2.5-Gbit/s 4-channel 40-km dispersion-shifted fiber transmission experiment, and we confirm experimentally and theoretically that the power penalty in the presence of residual intensity modulation of over 4 mWp-p exceeds 1dB. Experimental results show that the penalty due to XPM is large even when the power of the newly generated lights caused by four-wave mixing is 20-dB less than that of signals. This confirms that residual intensity modulation must be reduced in continuous-phase (CP)-FSK-FDM systems even though they are designed to avoid generating four-wave mixing.