In the user-congested high-frequency band, radio frequency interference (RFI) is a dominant factor that degrades the detection performance of high-frequency surface wave radar (HFSWR). Up to now, various RFI suppression algorithms have been proposed while they are usually inapplicable to the compact HFSWR because of the minimal array aperture. Therefore, this letter proposes a novel RFI mitigation scheme for compact HFSWR, even for single antenna. The scheme utilized the robust principal component analysis to separate RFI and target, based on the time-frequency distribution characteristics of the RFI. The effectiveness of this scheme is demonstrated by the measured data, which can effectively suppress RFI without losing target signal.

Wi-Fi Direct is a promising and available technology for device-to-device (D2D) proximity communications. To improve the performances of Wi-Fi Direct communication, optimized radio resource allocations are important. This paper proposes network assisted Wi-Fi Direct (NAWD), which operates based on the media independent services framework of IEEE 802.21 standard, for optimizing radio resource allocations. The NAWD is enhanced Wi-Fi Direct with the assistance of infrastructure networks (e.g., cellular network) and allocates radio resources (e.g., frequency channels and transmit power) to reduce radio interferences among Wi-Fi Direct devices (e.g., smart phones and set-top boxes). The NAWD includes mechanisms for gathering configuration information (e.g., location information and network connection information) of Wi-Fi Direct devices and allocating optimized radio resources (e.g., frequency channels and transmit power) to reduce radio interferences among Wi-Fi Direct devices. Simulation results show that the proposed NAWD increases significantly SINR, power efficiency, and areal capacity compared to legacy Wi-Fi Direct, where areal capacity is total traffic throughput per unit area.

Wireless mesh networks have been attracting many users in recent years. By connecting base stations (mesh nodes) with wireless connections, these network can achieve a wide-area wireless environment with flexible configuration and low cost at the risk of radio interference between wireless links. When we utilize wireless mesh networks as infrastructures for Internet access, all network traffic from mobile nodes goes through a gateway node that is directly connected to the wired network. Therefore, it is necessary to distribute the traffic load by deploying multiple gateway nodes. In this paper, we propose a spanning tree construction algorithm for TDMA-based wireless mesh networks with multiple gateway nodes so as to maximize the traffic volume transferred between the mesh network and the Internet (system throughput) by taking account of the traffic load on the gateway nodes, the access link capacity and radio interference. Through a performance evaluation, we show that the proposed algorithm increases the system throughput regardless of the bottleneck position and achieves up to 3.1 times higher system throughput than a conventional algorithm.

In the near future, wireless local area networks (WLANs) will overlap to provide continuous coverage over a wide area. In such ubiquitous WLANs, a mobile node (MN) moving freely between multiple access points (APs) requires not only permanent access to the Internet but also continuous communication quality during handover. In order to satisfy these requirements, an MN needs to (1) select an AP with better performance and (2) execute a handover seamlessly. To satisfy requirement (2), we proposed a seamless handover method in a previous study. Moreover, in order to achieve (1), the Received Signal Strength Indicator (RSSI) is usually employed to measure wireless link quality in a WLAN system. However, in a real environment, especially if APs are densely situated, it is difficult to always select an AP with better performance based on only the RSSI. This is because the RSSI alone cannot detect the degradation of communication quality due to radio interference. Moreover, it is important that AP selection is completed only on an MN, because we can assume that, in ubiquitous WLANs, various organizations or operators will manage APs. Hence, we cannot modify the APs for AP selection. To overcome these difficulties, in the present paper, we propose and implement a proactive AP selection method considering wireless link condition based on the number of frame retransmissions in addition to the RSSI. In the evaluation, we show that the proposed AP selection method can appropriately select an AP with good wireless link quality, i.e., high RSSI and low radio interference.