The search functionality is under construction.
The search functionality is under construction.

Keyword Search Result

[Keyword] silicon surface(2hit)

1-2hit
  • Data Analysis Technique of Atomic Force Microscopy for Atomically Flat Silicon Surfaces

    Masahiro KONDA  Akinobu TERAMOTO  Tomoyuki SUWA  Rihito KURODA  Tadahiro OHMI  

     
    PAPER

      Vol:
    E92-C No:5
      Page(s):
    664-670

    A data analysis technology of atomic force microscopy for atomically flat silicon surfaces has been developed. Atomically flat silicon surfaces composed of atomic terraces and steps are obtained on (100) orientation 200 mm diameter wafers by annealing in pure argon ambience at 1,200 for 30 minutes. Atomically flat silicon surfaces are lead to improve the MOS inversion layer mobility and current drivability of MOSFETs and to decrease the fluctuations in electrical characteristics of MOSFETs. It is important to realize the technology that evaluates the flatness and the uniformity of atomically flat silicon surfaces. The off direction angle is calculated by using two straight edge lines selected from measurement data. And the off angle is calculated from average atomic terrace width under assumption that height difference between neighboring terraces is equal to the step height, 0.135 nm, of (100) silicon surface. The analyzing of flatness of each terrace can be realized by converting the measurement data using the off direction angle and the off angle. And, the average roughness of each terrace is about 0.017-0.023 nm. Therefore, the roughness and the uniformity of each terrace can be evaluated by this proposed technique.

  • Removal of Fe and Al on a Silicon Surface Using UV-Excited Dry Cleaning

    Rinshi SUGINO  Yoshiko OKUI  Masaki OKUNO  Mayumi SHIGENO  Yasuhisa SATO  Akira OHSAWA  Takashi ITO  

     
    PAPER

      Vol:
    E75-C No:7
      Page(s):
    829-833

    The mechanism of UV-excited dry cleaning using photoexcited chlorine radicals has been investigated for removing iron and aluminum contamination on a silicon surface. The iron and aluminum contaminants with a surface concentration of 1013 atoms/cm2 were intentionally introduced via an ammonium-hydrogenperoxide solution. The silicon etching rates from the Uv-excited dry cleaning differ depending on the contaminants. Fe and Al can be removed in the same manner. The removal of Fe and Al is highly temperature dependent, and is little affected by the silicon etching depth. Both Fe and Al on the silicon surface were completely removed by UV-excited dry cleaning at a cleaning temperature of 170, and were decreased by two orders of magnitude from the initial level when the surface was etched only 2 nm deep.