A new architecture-based Dynamically Programmable Arithmetic Array processor (DPAA) is proposed for general purpose Digital Signal Processing applications. Parallelism and pipelining are achieved by using DPAA, which consists of various basic arithmetic blocks connected through a code-division multiple access bus interface. The proposed architecture poses 100% interconnection flexibility because connections are done virtually through code matching instead of physical wire connections. Compared to conventional multiplexing architectures, the proposed interconnection topology consumes less chip area and thus, more arithmetic blocks can be incorporated. A 16-bit prototype chip incorporating 10 multipliers and 40 other arithmetic blocks had been implemented into a 4.5 mm 4.5 mm chip with 0.6 µm CMOS process. DPAA also features its simple programmability, as numerical formula can be used to configure the processor without programming languages or specialized CAD tools.

A new analog correlator circuit is proposed for direct sequence code division multiple access (DS-CDMA) demodulator. The circuit consists of only 16 switches, 4 capacitors and 2 level shifters. Control sequence requires only three clock phases. Simulation with code length of 127 reveals that the proposed circuit has a good ability to cancel off the charge error and dissipates 3.4mW at 128MHz. The circuit had been designed using a 0.6µm CMOS process. The area of 256µm 245µm is estimated to be 9 times smaller compared to other reported equivalent analog correlators.

This paper describes a new architecture-based microprocessor, a dynamically programmable parallel processor (DPPP), that consists of large numbers of simplified ALUs (sALU) as processing blocks. All sALUs are interconnected via a code division multiple-access bus interface that provides complete routing flexibility by establishing connections virtually through code-matching instead of physical wires. This feature is utilized further to achieve high parallelism and fault tolerance. High fault tolerance is realized without the limitations of conventional fabrication-based techniques nor providing spare elements. Another feature of the DPPP is its simple programmability, as it can be configured by compiling numerical formula input using the provided user auto-program interface. A prototype chip based on the proposed architecture has been implemented on a 4.5 mm 4.5 mm chip using 0.6 µm CMOS process.