The cell discard process and the requirements for cell loss compensation methods in ATM (Asynchronous Transfer Mode)-based networks are discussed. In addition to the average cell loss rate, the probability distribution of consecutive cell discard length is slso investigated using computer simaulation of cell multiplexing. Average cell loss rate characteristics show the difficulty of reducing the cell loss rate only by increasing buffer size when cell arrival is bursty. The probability distribution of consecutive cell discard length indicates that cells are consecutively discarded even if cell arrival is less-bursty and the link utilization factor is not large. A simple mathematical model which represents the cell discard process is also derived. Estimation of cell loss compensation effect based on the obtained cell discard process model is presented. It shows that a cell loss compensation method which can only compensate for the isolated cell losses provides a cell loss rate reduction factor of only around 1/2 to 1/5 even if the input signals are not bursty. Therefore, consecutive cell loss compensation is necessary to efficiently reduce cell loss probability regardless of the burstiness of the input cell arrival.

A new wide-dynamic-range CMOS image sensor with pixel-level analog-to-digital (A/D) converters is proposed. The pulse-counters in the sensor are arranged outside the pixel area in order to reduce pixel size, which is a key requirement for making high-definition cameras. A new scheme called variable threshold operation is also presented as a suitable readout operation method for the sensor. Experimental measurements on a prototype sensor show that the prototype can obtain linear output response proportional to illumination by applying the new readout operation.

This very useful optical sampling system uses a passively mode-locked fiber laser as an optical sampling pulse source and is based on sum-frequency generation. The optical pulse had a sufficiently short pulse width, and its peak power was very high. In addition, it had a very low timing jitter. We could observe optical signals that were jitter-free in terms of single scanning. The sum-frequency generation conversion efficiency was 1.0 10-4 W-1, and the temporal resolution was 700 fs, when we used a 5-mm-thick KTP crystal. A 320-Gbit/s optical signal could be clearly observed. We have also developed a polarization-insensitive optical sampling system with a two-path configuration based on sum-frequency generation using the type-II phase matching condition in a KTP crystal. The polarization dependency was less than 3.5% (0.15 dB) in the wavelength range from 1520 to 1620 nm.

The timing jitter of the optical pulse from a gain-switched laser diode is reduced by CW light injection. The reduction ratio of the timing jitter is 5. 5. The pulse width was compressed by a nonlinear optical loop mirror to a pedestal-free optical pulse with a pulse width of 420 fs.

This paper shows the recent standardization activities on Ethernet OAM functions. First, it briefly introduces recent carrier class Ethernet services indicating their characteristics and operational issues. Then, it explains current standardization status on Ethernet OAM functions. Finally it shows the requirements for Ethernet OAM functions and details of the OAM mechanisms currently being standardized by ITU-T SG13, SG15 and IEEE 802.1 WG.

This paper describes the roles and benefits of an ATM transport network composed of ATM transport systems, such as ATM cross-connect systems and/or ATM add-drop multiplexers. The ATM transport network is an economical way of providing the ATM public network and a virtual path service for enterprise users. This paper exemplifies the effectiveness of a VP grooming function in the ATM transport system by comparing it to the network costs with direct fiber connection, an alternative to VP grooming. Main and junction module architecture for the ATM cross-connect system is proposed to realize an economical network that supports small to large traffic. For implementing a large-scale cross-connect switch, a cell congestion control method that employs re-arrangement control and a concentration network is proposed. Implementation of multiple service classes and VP protection switching in the ATM cross-connect system are mentioned. We also describe an SDH signal transmission method based on ATM cells, that offers a cost effective and reliable transport network.

The ATM Virtual Path(VP)-based transport network is a candidate for the future multi-reliability and broadband integrated service infrastructure. This paper compares the performance attributes of the VP transport network with those of the conventional SDH network and future optical path-based transport network. This paper shows that the VP-based network is superior in terms of path-grooming efficiency and connection capability, and will still play an important role when WDM technologies are introduced to carrier networks. This paper also describes the recently fabricated VP Cross Connect(VP-XC) system configuration and the VP Automatic Protection Switching(APS) performance of the XC.

In a distributed-memory parallel-processing system, the overhead of data transfer among the processors is so large that it is important to reduce the data transfer. We consider the data transfer in evaluating an expression consisting of data distributed among the processors. We propose some algorithms which assign the operators in the expression to the processors so as to minimize the number or the cost of data transfers, on the condition that the data allocation to the processors is given. The basic algorithm is given at first, followed by some variations.

A highly sensitive optical sampling system has been produced by using sum-frequency generation in a periodically poled lithium niobate crystal. When the relations between crystal length and wavelength bandwidth and SFG conversion efficiency were investigated theoretically and experimentally, a system with a 1.4-mm-long periodically poled lithium niobate crystal was found to have a 22.5-nm wavelength bandwidth and a SFG conversion efficiency ten times that of a similar system with a 3-mm-long KTP crystal. The SNR of the system with the 1.4-mm-long PPLN crystal was about 7 dB higher than that of the system with a 3-mm-long KTP crystal, and a temporal resolution better than 1 ps was obtained by using compressed optical sampling pulses. The eye diagram of a 10-Gbit/s RZ optical signal with a 1-mW peak power could be observed, and the eye diagram of a 160-Gbit/s RZ optical signal could be observed clearly.

In this paper presented is a theorem: a planar digraph which is embedded in a plane and which has a single source and a single sink both lying on the outer face of the digraph, is acyclic, if and only if all the inner faces are acyclic. Hence the number of tiesets necessary and sufficient for guaranteeing the acyclicity of the digraph is equal to the nullity of the digraph.