We discuss the division of radio resources in the time and frequency domains for wireless local area network (WLAN) devices powered with microwave energy. In general, there are two ways to avoid microwave power transmission (MPT) from influencing data communications: adjacent channel operation of continuous MPT and WLAN data transmission and co-channel operation of intermittent MPT and WLAN data transmission. Experimental results reveal that, even when we implement these methods, several problems arise because WLAN devices have been developed without supposing the existence of MPT. One problem clarified in our experiment is that adjacent channel operation at 2.4GHz does not necessarily perform well owing to the interference from MPT. This interference occurs regardless of the frequency separation at 2.4GHz. The other problem is that intermittent MPT could result in throughput degradation owing to the data rate control algorithm and the association scheme of the WLAN. In addition, the experimental results imply that a microwave energy source and a WLAN device should share information on the timings of intermittent MPT and data transmission to avoid buffer overflow.

In this paper, we study the feasibility of a batteryless wireless sensor supplied with energy by using microwave power transmission (MPT). If we perform co-channel operation of MPT and wireless local area networks (WLANs) for the sake of spectral efficiency, a time division method for MPT and WLAN communications is required to avoid serious interference from MPT to WLAN data transmissions. In addition, to reduce the power consumption of a sensor, the use of power-save operation of the sensor is desirable. We proposed a scheduling scheme that allocates time for MPT and WLAN communications. Specifically, in the proposed scheduling system, an energy source transmits microwave power to a sensor station except when the sensor station transmits data frames or receives beacon frames. In addition, in the proposed scheduling system, we force the remaining energy of the sensor station to converge to a maximum value by adjusting the time interval of data transmission from the sensor station such that the power consumption of the sensor station is reduced. On the basis of the proposition, we implemented a scheduling system and then confirmed that it performed successfully in the conducted experiments. Finally, we discussed the feasibility of the proposed scheduling scheme by evaluating the coverage and then showed that the scheduling scheme can be applied to closed space or room.