This paper presents a novel architecture of an asynchronous FPGA for handshake-component-based design. The handshake-component-based design is suitable for large-scale, complex asynchronous circuit because of its understandability. This paper proposes an area-efficient architecture of an FPGA that is suitable for handshake-component-based asynchronous circuit. Moreover, the Four-Phase Dual-Rail encoding is employed to construct circuits robust to delay variation because the data paths are programmable in FPGA. The FPGA based on the proposed architecture is implemented in a 65 nm process. Its evaluation results show that the proposed FPGA can implement handshake components efficiently.

This paper presents a low-power FPGA based on mixed synchronous/asynchronous design. The proposed FPGA consists of several sections which consist of logic blocks, and each section can be used as either a synchronous circuit or an asynchronous circuit according to its workload. An asynchronous circuit is power-efficient for a low-workload section since it does not require the clock tree which always consumes the power. On the other hand, a synchronous circuit is power-efficient for a high-workload section because of its simple hardware. The major consideration is designing an area-efficient synchronous/asynchronous hybrid logic block. This is because the hardware amount of the asynchronous circuit is about double that of the synchronous circuit, and the typical implementation wastes half of the hardware in synchronous mode. To solve this problem, we propose a hybrid logic block that can be used as either a single asynchronous logic block or two synchronous logic blocks. The proposed FPGA is fabricated using a 65-nm CMOS process. When the workload of a section is below 22%, asynchronous mode is more power-efficient than synchronous mode. Otherwise synchronous mode is more power-efficient.

This paper presents an asynchronous FPGA that combines 4-phase dual-rail encoding and LEDR (Level-Encoded Dual-Rail) encoding. 4-phase dual-rail encoding is employed to achieve small area and low power for function units, while LEDR encoding is employed to achieve high throughput and low power for the data transfer using programmable interconnection resources. Area-efficient protocol converters and their control circuits are also proposed in transistor-level implementation. The proposed FPGA is designed using the e-Shuttle 65nm CMOS process. Compared to the 4-phase-dual-rail-based FPGA, the throughput is increased by 69% with almost the same transistor count. Compared to the LEDR-based FPGA, the transistor count is reduced by 47% with almost the same throughput. In terms of power consumption, the proposed FPGA achieves the lowest power compared to the 4-phase-dual-rail-based and the LEDR-based FPGAs. Compared to the synchronous FPGA, the proposed FPGA has lower power consumption when the workload is below 35%.