This paper proposes a short delay, error-resilient video transmission scheme for mobile radio channels. Compressed video data are sensitive to channel error. Video coding schemes such as H. 263 use variable length coding so channel error can cause synchronization failure in the decoder and fatally degrade the reconstructed video sequence by triggering intra- and inter-frame error propagation. ARQ prevents all forms of error propagation but significantly increases the transmission delay of the video frame. We propose a new error control scheme to reduces the delay incurred by ARQ; the receiving buffer can transmits the video frame data to the video decoder even if not all ARQ frames containing the video frame are received. The encoder transmits additional information, the Macro Block (MB) size, in the video frame header. Upon receiving this information, the receiving buffer can determine MB length which allows MB de-synchronization to be prevented. For example, if an ARQ frame is lost, the decoder determines the position of the missing MB and replace this MB with the equivalent block in the previous video frame; this prevents intra-frame error propagation. When all ARQ frames are received and decoded correctly, the video frame in the reference video memory is replaced with the correctly decoded one. Simulation results show that the proposed scheme can minimize the delay and the reduction in frame rate caused by retransmission control without intra- and inter-error propagation.

By integrating three networks, namely, Public Switched Telephone Network (PSTN), Personal Handy-Phone System (PHS) and Intelligent Network (IN) to work together as a Personal Communication Telephone (PCT) service to be offered in the Bangkok metropolis area, the PCT service enables the advent of three new concepts, first, using the same telephone number as that of the fixed line to become a "Personal Number," second, a cell coverage designed to cover larger areas than that of the PHS (by changing hand-out threshold level from 33 dBµV to 30 dBµV and hand-in threshold level from 30 dBµV to 25 dBµV) in order to reduce the muting time during the handover process and provide higher mobility at up to 60 kilometers per hour, and third, a technique of "2 carriers per area" to reduce "call drop." All these techniques will be described in this paper.

A direct conversion transmitter IC including a proposed frequency doubler, a quadrature modulator, and a 3-bit variable attenuator was fabricated using BiCMOS technology with fT of 12 GHz. This architecture employing frequency doubler is intended for realizing wireless terminals that are low in cost and small in size. The architecture is effective for reducing serious interference between PA and VCO by making the VCO frequency different from that of PA. The proposed frequency doubler comprises a current-driven 90 phase-shifter and an ECL-EXOR circuit for both low power operation and wide input power range of local oscillator (LO). The proposed frequency doubler keeps high output power even when rectangular wave from LO is applied owing to use of the current-driven 90 phase-shifter instead of a voltage-driven 90 phase-shifter. An LO leakage of less than -25 dBc, an image rejection ratio in excess of 45 dBc, and a maximum attenuation of 21 dB were measured. The transmitter IC successfully operates at LO power above -15 dBm and consumes 68 mA from 2.7 V power supply voltage. An active die size is 1.5 mm3 mm.