1-4hit |
Mitsuru SHIOZAKI Kota FURUHASHI Takahiko MURAYAMA Akitaka FUKUSHIMA Masaya YOSHIKAWA Takeshi FUJINO
Silicon Physical Unclonable Functions (PUFs) have been proposed to exploit inherent characteristics caused by process variations, such as transistor size, threshold voltage and so on, and to produce an inexpensive and tamper-resistant device such as IC identification, authentication and key generation. We have focused on the arbiter-PUF utilizing the relative delay-time difference between the equivalent paths. The conventional arbiter-PUF has a technical issue, which is low uniqueness caused by the ununiformity on response-generation. To enhance the uniqueness, a novel arbiter-based PUF utilizing the Response Generation according to the Delay Time Measurement (RG-DTM) scheme, has been proposed. In the conventional arbiter-PUF, the response 0 or 1 is assigned according to the single threshold of relative delay-time difference. On the contrary, the response 0 or 1 is assigned according to the multiple threshold of relative delay-time difference in the RG-DTM PUF. The conventional and RG-DTM PUF were designed and fabricated with 0.18 µm CMOS technology. The Hamming distances (HDs) between different chips, which indicate the uniqueness, were calculated by 256-bit responses from the identical challenges on each chip. The ideal distribution of HDs, which indicates high uniqueness, is achieved in the RG-DTM PUF using 16 thresholds of relative delay-time differences. The generative stability, which is the fluctuation of responses in the same environment, and the environmental stability, which is the changes of responses in the different environment were also evaluated. There is a trade-off between high uniqueness and high stability, however, the experimental data shows that the RG-DTM PUF has extremely smaller false matching probability in the identification compared to the conventional PUF.
Takashi INOUE Yuji ANDO Kensuke KASAHARA Yasuhiro OKAMOTO Tatsuo NAKAYAMA Hironobu MIYAMOTO Masaaki KUZUHARA
High-frequency characterization and delay-time analysis have been performed for a short channel AlGaN/GaN heterojunction FET. The fabricated device with a short gate length (Lg) of 0.07 µm exhibited an extrinsic current gain cutoff frequency of 81 GHz and a maximum frequency of oscillation of 190 GHz with a maximum stable gain (MSG) of 8.2 dB at 60 GHz. A new scheme for the delay-time analysis was proposed, in which the effects of rather large series resistance RS + RD are properly taken into account. By applying the new scheme to a device with Lg=0.25 µm, we obtained an effective high-field electron velocity of 1.75107 cm/s, which is consistent with our previous results calculated using Monte Carlo simulation.
Takakuni DOUSEKI Shin-ichiro MUTOH
This paper describes the effects of operating temperature on delay time in a 1-V multi-threshold CMOS(MTCMOS) circuit, Delay-time analysis including the temperature factor shows that the delay-time variation of the CMOS circuit becomes amall for low-voltage operation and the variation is mainly determined by the threshold voltage and its variation-rate with temperature. As a design method of a MTCMOS circuit with both high-threshold and low-threshold MOSFETs, optimization of the low-threshold voltage at which the delay-time of the circuit is independent of operating temperature is described in detail. The validity of the design method is confirmed by the evaluation of a gate-chain TEG and a 1-V 12 K-gate digital-filter LSI fabricated with o.5-µm MTCMOS technology.
Bumchul KIM Michitaka KAMEYAMA Tatsuo HIGUCHI
This paper proposes parallel VLSI processors for robotics based on multiple processing elements organized around multiple bus interconnection networks. The advantages of multiple bus interconnection networks are generality, simplicity of implementation and capability of parallel communications between processing elements, therefore it is considered to be suitable for parallel VLSI systems. We also propose the optimal scheduling formulated in an integer programming problem to minimize the delay time of the parallel VLSI processors.