We propose a cyclic sleep control technique for backup resources in reconfigurable optical add/drop multiplexer (ROADM) systems to simultaneously achieve power savings and high-speed recovery from failures. Processes to check the reliability of backup resources, backup transponders and paths, are also provided in the control technique. The proposed technique uses sleep mode where backup transponders are powered down to minimize power for power savings. At least one of the backup transponders is always activated after self-checking using the loopback fiber connection in the ROADM and it becomes a shared backup for working transponders to enable high-speed recovery from failures. This activated backup transponder is powered down again after the next transponder is activated. These state transitions are cyclically applied to each backup transponder. This “cyclic” aspect of operation enables network operators to continuously monitor the reliability for all backup resources with the sleep mode. The activated backup transponders at both ends of the path are used in checking the reliability of backup paths. Therefore, all backup resources, both transponders and paths, can be regularly checked with the sleep mode to ensure data are stably forwarded. We estimated the power consumption with this technique under various conditions and found a trade-off between power reduction and the recovery capabilities from failures. We achieved more than 34% power saving of backup transponders maintaining the failure recovery time within 50ms in experiments. Furthermore, we confirmed the reliability of backup paths in experiments using backup transponders with the cyclic sleep control technique. These results indicated that the proposed control technique is promising in dramatically and reliably reducing the power consumption of backup resources.

Cognitive radio is one of the most promising wireless technologies and has been recognized as a new way to improve the spectral efficiency of wireless networks. In a cognitive radio network, secondary users exchange control information for network coordination such as transmitter-receiver handshakes, for sharing spectrum sensing results, for neighbor discovery, to maintain connectivity, and so on. Spectrum utilization and resource optimizations thus rely on information exchange among secondary users. Normally, secondary users exchange the control information via a predefined channel, called a common control channel (CCC). Most of the medium access control (MAC) protocols for cognitive radio networks were designed by assuming the existence of a CCC, and further assuming that it was available for every secondary user. However, the main drawback of using a static CCC is it is susceptible to primary user activities since the channel can be occupied by primary users at any time. In this paper, we propose a MAC protocol for cognitive radio networks with dynamic control channel assignment, called DYN-MAC. In DYN-MAC, a control channel is dynamically assigned based on spectrum availability. Thus, it can tolerate primary user activities. DYN-MAC also supports collision free network-wide broadcasting and addresses other major problems such as primary/secondary user hidden terminal problems.

We propose a novel dynamic hierarchical optical path network architecture that achieves efficient optical fast circuit switching. In order to complete wavelength path setup/teardown efficiently, the proposed network adaptively manages waveband paths and bundles of optical paths, which provide virtual mesh connectivity between node pairs for wavelength paths. Numerical experiments show that operational and facility costs are significantly reduced by employing the adaptive virtual waveband connections.

In the IEEE 802.11 MAC protocol, access points (APs) are given the same priority as wireless terminals in terms of acquiring the wireless link, even though they aggregate several downlink flows. This feature leads to a serious throughput degradation of downlink flows, compared with uplink flows. In this paper, we propose a dynamic contention window control scheme for the IEEE 802.11e EDCA-based wireless LANs, in order to achieve fairness between uplink and downlink TCP flows while guaranteeing QoS requirements for real-time traffic. The proposed scheme first determines the minimum contention window size in the best-effort access category at APs, based on the number of TCP flows. It then determines the minimum and maximum contention window sizes in higher priority access categories, such as voice and video, so as to guarantee QoS requirements for these real-time traffic. Note that the proposed scheme does not require any modification to the MAC protocol at wireless terminals. Through simulation experiments, we show the effectiveness of the proposed scheme.

In this letter, we present an output feedback controller design technique for uncertain discrete time systems with multiple time-delays. Based on Lyapunov second method, a sufficient condition for the robust stability of the system with a dynamic controller is derived in terms of the linear matrix inequality (LMI) with respect to design variables. The solutions of the LMIs can be easily obtained using existing efficient convex optimization techniques.

Bursts from a number of variable bit rate sources allocated to a virtual path with a given capacity can inundate the channel. Buffers used to take care of such bursts can fill up rapidly. The buffer size limits its burst handling capability. With large bursts or a number of consecutive bursts, the buffers fill up and this leads to high cell losses. Channel reconfiguration with dynamic allocation of spare capacities is one of the methods used to alleviate such cell losses. In reconfigurable networks, spare capacity allocation can increase the channel rates for short durations, to cope with the excess loads from the bursts. The dynamic capacity allocations are adaptable to the loads and have fast response times. We propose heuristic rules for spare capacity assignments in ATM networks. By monitoring buffer occupancy, triggers which anticipate excess traffic can be used to assign spare capacities to reduce the cell loss probabilities in the network.