This study investigates a two/three-dimensional (2D/3D) symbol-mapping technique that evaluates data transmission quality based on a four-level pulse-amplitude modulation (PAM-4) symbol transition. Multi-dimensional symbol transition mapping facilitates the visualization of the degree of interference (ISI). The simulation and experimental results demonstrated that the 2D symbol mapping can evaluate the PAM-4 data transmission quality degraded by ISI and visualize the equalization effect. Furthermore, potential applications of 2D mapping and its extension to 3D mapping were explored.

Intersymbol interference (ISI) is a significant source of degradation in many digital communication systems including our proposed non-far region communication system using large array antennas in the millimeter-wave band in which the main cause of ISI can be attributed to the path delay differences among the elements of an array antenna. This paper proposes a quantitative method to evaluate the ISI estimated from the measured near-field distribution of the array antenna. The influence of the uniformity in the aperture field distribution in ISI is discussed and compared with an ideally uniform excitation. The reliability of the proposed method is verified through a comparison with another method based on direct measurements of the transmission between the actual antennas. Finally, the signal to noise plus interference is evaluated based on the estimated ISI results and ISI is shown to be the dominant cause of the degradation in the reception zone of the system.

In this paper, we theoretically analyse the influence of intersymbol interference (ISI) and continuous wave interference (CWI) on the bit error rate (BER) performance of the spread spectrum (SS) system using a real-valued Huffman sequence under the additive white Gaussian noise (AWGN) environment. The aperiodic correlation function of the Huffman sequence has zero sidelobes except the shift-end values at the left and right ends of shift. The system can give the unified communication and ranging system because the output of a matched filter (MF) is the ideal impulse by generating transmitted signal of the bit duration T=NTc, N=2n, n=1,2,… from the sequence of length M=2kN+1, k=0,1,…, where Tc is the chip duration and N is the spreading factor. As a result, the BER performance of the system is improved with decrease in the absolute value of the shift-end value, and is not influenced by ISI if the shift-end value is almost zero-value. In addition, the BER performance of the system of the bit duration T=NTc with CWI is improved with increase in the sequence length M=2kN+1, and the system can decrease the influence of CWI.

In this letter we proposed the linear combination of two ISI-free pulses with different decay rates in order to obtain a new Nyquist pulse. The proposed pulse contains a new design parameter β, giving an additional degree of freedom to minimize the bit error probability performance in the presence of symbol-timing errors, for a given roll-off factor α. Several practical tools are implemented for evaluating the performance of the proposed filter. The novel pulse is evaluated in terms of the bit error probability performance in the presence of symbol-timing errors. Eye diagrams are presented to visually assess the vulnerability of the transmission system to ISI, and the maximum distortion is estimated as a quantitative measure of performance.

A K-exponential filter is derived and utilized for pulse shaping to reduce peak to average power ratio (PAPR) without intersymbol interference (ISI). While keeping the same bandwidth, the frequency responses of the filters vary with different values of the parameter k. The minimum PAPR is associated with a value of the parameter k when the roll-off factor α is specified. Simulations show that the PAPR can be reduced compared with the raised cosine (RC) filter in various systems. The derived pulse shaping filters also provide better performance in PAPR reduction compared with the existing filters.

In order to evaluate the effect of Nakagami-Rice fading on Orthogonal Frequency Division Multiplex (OFDM) signal transmission when the delay profile exceeds the guard interval, a simple prediction model is developed by extending the Equivalent Transmission-Path (ETP) model for Rayleigh fading. The validity of the model is demonstrated by comparing the calculated values of BER to those obtained by computer simulation. Using the newly developed ETP-OFDM model, digital transmission characteristics of the OFDM signal in a multipath environment when the delay profile exceeds the guard interval are shown as a function of K factor, delay spread, guard interval and OFDM symbol period.

For more efficient data transmissions, a new MLP/BP-based channel equalizer is proposed to compensate for multi-path fading in wireless applications. In this work, for better system performance, we apply the soft output and the soft feedback structure as well as the soft decision channel decoding. Moreover, to improve packet error rate (PER) and bit error rate (BER), we search for the optimal scaling factor of the transfer function in the output layer of the MLP/BP neural networks and add small random disturbances to the training data. As compared with the conventional MLP/BP-based DFEs and the soft output MLP/BP-based DFEs, the proposed MLP/BP-based soft DFEs under multi-path fading channels can improve over 3-0.6 dB at PER=10-1 and over 3.3-0.8 dB at BER=10-3.

In this letter, we propose a low-complexity estimation method of cyclic-prefix (CP) length for a discrete multitone (DMT) very high-speed digital subscriber line (VDSL) system. Using the sign bits of the received DMT VDSL signals, the proposed method provides a good estimate of CP length, which is suitable for various channel characteristics. This simple estimation method is consistent with the initialization procedure of T1E1.4 multi-carrier modulation (MCM)-based VDSL Standard. Finally, simulation results with VDSL test loops are presented.

In indoor optical channels, intersymbol interference (ISI) due to multipath propagation prevents high data rate transmission. In this paper, a new Optical Multi-Wavelength Modulation technique has been investigated for improving the quality of transmission. In this technique, parallel transmission is used, which lowers the data rate per channel and thus reduces the effects of ISI. Furthermore, parallel coding is used in predetermined parallel branches, so that coding can correct errors without changing the system data rate. Simulation results show that a combination of these methods can achieve high quality transmission without reduction of the total data rate.