Path loss in high frequency bands above 6GHz is the most fundamental and significant propagation characteristic of IMT-2020. To develop and evaluate such high frequency bands, ITU-R SG5 WP5D recently released channel models applicable up to 100GHz. The channel models include path loss models applicable to 0.5-100GHz. A path loss model is used for cell design and the evaluation of the radio technologies, which is the main purpose of WP5D. Prediction accuracy in various locations, Tx positions, frequency bands, and other parameters are significant in cell design. This article presents the prediction accuracy of UMa path loss models which are detailed in Report ITU-R M.2412 for IMT-2020. We also propose UMa_A' as an extension model of UMa_A. While UMa_A applies different equations to the bands below and above 6GHz to predict path loss, UMa_A' covers all bands by using the equations of UMa_A below 6GHz. By using the UMa_A' model, we can predict path loss by taking various parameters (such as BS antenna height) into account over a wide frequency range (0.5-100GHz). This is useful for considering the deployment of BS antennas at various positions with a wide frequency band. We verify model accuracy by extensive measurements in the frequency bands from 2 to 66GHz, distances up to 1600 m, and an UMa environment with three Tx antenna heights. The UMa_A' extension model can predict path loss with the low RMSE of about 7dB at 2-26.4GHz, which is more accurate than the UMa_A and UMa_B models. Although the applicability of the UMa_A' model at 66GHz is unclear and needs further verification, the evaluation results for 66GHz demonstrate that the antenna height may affect the prediction accuracy at 66GHz.

This paper proposes a path loss model for crowded outdoor environments that can consider the density of people. Measurement results in an anechoic chamber with three blocking persons showed that multiple human body shadowing can be calculated by using finite width screens. As a result, path loss in crowded environments can be calculated by using the path losses of the multipath and the multiple human body shadowing on those paths. The path losses of the multipath are derived from a ray tracing simulation, and the simulation results are then used to predict the path loss in crowded environments. The predicted path loss of the proposed model was examined through measurements in the crowded outdoor station square in front of Shibuya Station in Tokyo, and results showed that it can accurately predict the path loss in crowded environments at the frequencies of 4.7GHz and 26.4GHz under two different conditions of antenna height and density of people. The RMS error of the proposed model was less than 4dB.

This paper presents a numerical study of the wireless channel characteristics of liver implants in a frequency range of 4.5-6.5GHz, considering different digital human phantoms by employing two inhomogeneous male and female models. Path loss data for in-body to on-body and in-body to off-body communication scenarios are provided. The influence of respiration-induced organ movement on signal attenuation is demonstrated. A narrower range of attenuation deviation is observed in the female model as compared to the male model. The path loss data in the female body is between 40-80dB which is around 5-10dB lower than the male model. Path loss data for the in-body to off-body scenario in both models suggest that in-body propagation is the main component of total path loss in the channel. The results demonstrate that channel characteristics are subject dependent, and thus indicate the need to take subject dependencies into consideration when investigating in-body communication channels.

This paper proposed that a path loss model for outdoor-to-indoor corridor is presented to construct next generation mobile communication systems. The proposed model covers the frequency range of millimeter wave bands up to 40GHz and provides three dimensional incident angle characteristics. Analysis of path loss characteristics is conducted by ray tracing. We clarify that the paths reflected multiple times between the external walls of buildings and then diffracted into one of the buildings are dominant. Moreover, we also clarify how the paths affect the path loss dependence on frequency and three dimensional incident angle. Therefore, by taking these dependencies into consideration, the proposed model decreases the root mean square errors of prediction results to within about 2 to 6dB in bands up to 40GHz.

A path loss model for low antenna heights below surrounding buildings in residential areas is presented to contribute to the construction of VHF band wireless systems. The model is constructed on the basis of measurement results at 167.65MHz, near center frequency at VHF band. Path loss characteristics in the middle VHF band are compared to those in bands above UHF. The dominant paths in bands above UHF include propagation paths below surrounding buildings, such as paths along roads. However, in the middle VHF band, these paths are instantly attenuated because their 1st Fresnel zone radius is larger than the average building height or road width. The dominant path in the middle VHF band is the over-roof propagation path, and the 1st Fresnel zone of the path is shielded by the buildings and the ground surface. The proposed path loss model has two features. First, it derives the effective height of the ground surface from the terrain profile of the buildings and the ground surface. Second, it uses formulas of a two-path model to take the shielding of the 1st Fresnel zone into account. Finally, it is shown that the proposed model is able to predict the path loss measurement results more accurately than the conventional model.

A new path loss model of interference between mobile terminals in a residential area is proposed. The model uses invertible formulas and considers the effects on path loss characteristics produced by paths having many corners or corners with various angles. Angular profile and height pattern measurements clarify three paths that are dominant in terms of their effect on the accurate modeling of path loss characteristics in residential areas: paths along a road, paths between houses, and over-roof propagation paths. Measurements taken in a residential area to verify the model's validity show that the model is able to predict path loss with greater accuracy than conventional models.

An implantable WBAN path-loss model for a capsule endoscopy which is used for examining digestive organs, is developed by conducting simulations and experiments. First, we performed FDTD simulations on implant WBAN propagation by using a numerical human model. Second, we performed FDTD simulations on a vessel that represents the human body. Third, we performed experiments using a vessel of the same dimensions as that used in the simulations. On the basis of the results of these simulations and experiments, we proposed the gradient and intercept parameters of the simple path-loss in-body propagation model.

Body Area Network (BAN) is considered as a promising technology in supporting medical and healthcare services by combining with various biological sensors. In this paper, we look at wearable BAN, which provides communication links among sensors on body surface. In order to design a BAN that manages biological information with high efficiency and high reliability, the propagation characteristics of BAN must be thoroughly investigated. As a preliminary effort, we measured the propagation characteristics of BAN at frequency bands of 400 MHz, 600 MHz, 900 MHz and 2400 MHz respectively. Channel models for wearable BAN based on the measurement were derived. Our results show that the channel model can be described by using a path loss model for all frequency bands investigated.