In this paper we describe and experimentally validate a dual-band digital predistortion (DPD) model we propose that takes account of the intermodulation and harmonic distortion produced when the center frequencies of input bands have a harmonic relationship. We also describe and experimentally validate our proposed novel dual-band power amplifier (PA) linearization architecture consisting of a single feedback loop employing a dual-band mixer. Experiment results show that the DPD linearization the proposed model provides can compensate for intermodulation and harmonic distortion in a way that the conventional two-dimensional (2-D) DPD approach cannot. The proposed feedback architecture should make it possible to simplify analog-to-digital converter (ADC) design and eliminate the time lag between different feedback paths.

In the recently developed Flexible Wireless System (FWS), the same platform needs to deal with different wireless systems. This increases nonlinear distortion in its wideband power amplifier (PA) because the PA needs to concurrently amplify multi-band signals. By taking higher harmonics as well as inter- and cross-modulation distortion into consideration, we have developed a method to analytically evaluate the adjacent channel leakage power ratio (ACPR) and error vector magnitude (EVM) on the basis of the PA's nonlinear characteristics. We devise a novel method for modeling the PA amplifying dual-band signals. The method makes it possible to model it merely by performing a one-tone test, making use of the Volterra series expansion and the general Wiener model. We then use the Mehler formula to derive the closed-form expressions of the PA's output power spectral density (PSD), ACPR, and EVM. The derivations are based on the assumption that the transmitted signals are complex Gaussian distributed in orthogonal frequency division multiplexing (OFDM) transmission systems. We validate the method by comparing measurement and simulation results and confirm it can appropriately predict the ACPR and EVM performance of the nonlinear PA output with OFDM inputs. In short, the method enables correct modeling of a wideband PA that amplifies dual-band signals merely by conducting a one-tone test.

This paper suggests an outphasing scheme to reduce adjacent channel spectral regrowth triggered by the gain and phase mismatch between two signal paths in linear amplification with nonlinear component (LINC) systems. The error vector magnitude and power spectral density of the output signal considering path mismatch are described analytically using path mismatch factor. An outphasing scheme is proposed to reduce the spectral regrowth. The proposed outphasing scheme reshapes the phases of the separated signals in LINC systems to reduce the changes of the phases. Its performance is verified by performing simulations with multi-tone signals. The result shows that the scheme can reduce the spectral regrowth of the multi-tone signals significantly compared to the conventional outphasing scheme for LINC systems with path imbalance.

Nonlinear distortions in power amplifiers (PAs) generate spectral regrowth at the output, which causes interference to adjacent channels and errors in digitally modulated signals. This paper presents a novel method to evaluate adjacent channel leakage power ratio (ACPR) and error vector magnitude (EVM) from the amplitude-to-amplitude (AM/AM) and amplitude-to-phase (AM/PM) characteristics. The transmitted signal is considered to be complex Gaussian distributed in orthogonal frequency-division multiplexing (OFDM) systems. We use the Mehler formula to derive closed-form expressions of the PAs output power spectral density (PSD), ACPR and EVM for memoryless PA and memory PA respectively. We inspect the derived relationships using an OFDM signal in the IEEE 802.11a WLAN standard. Simulation results show that the proposed method is appropriate to predict the ACPR and EVM values of the nonlinear PA output in OFDM systems, when the AM/AM and AM/PM characteristics are known.

This paper investigates limitations of adjacent channel power ratio (ACPR) improvement in predistortion (pre-D) linearizer used with nonlinear RF power amplifiers (PAs) when the PA model is not perfectly acquired in pre-D design. The error between the physical PA and the nonlinear model is expanded by pre-D function and its power spectral density (PSD) works as limitations in ACPR improvement of the pre-D linearizer. An analytical estimation of ACPR limitations in RF PAs driven by digitally modulated input signal is derived using a formulation of autocorrelation function. The analysis technique is validated with the example of the memory polynomial PA model with the quasi-memoryless pre-D linearizer. The technique is also verified by comparing predicted ACPR limitation with measured limitation for a RF PA with 802.11g input signal.