We propose a spectrum regeneration and demodulation method for multiple direct RF undersampled real signals by using a new algorithm. Many methods have been proposed to regenerate the RF spectrum by using undersampling because of its simple circuit architecture. However, it is difficult to regenerate the spectrum from a real signal that has a band wider than a half of the sampling frequency, because it is difficult to include complex conjugate relation of the folded spectrum into the linear algebraic equation in this case. We propose a new spectrum regeneration method from direct undersampled real signals that uses multiple clocks and an extended algorithm considering the complex conjugate relation. Simulations are used to verify the potential of this method. The validity of the proposed method is verified by using the simulation data and the measured data. We also apply this algorithm to the demodulation system.

Blind nonlinear compensation for RF receivers is an important research topic in 5G mobile communication, in which higher level modulation schemes are employed more often to achieve high capacity and ultra-broadband services. Since nonlinear compensation circuits must handle intermodulation bandwidths that are more than three times the signal bandwidth, reducing the sampling frequency is essential for saving power consumption. This paper proposes a novel blind nonlinear compensation technique that employs sub-Nyquist sampling analog-to-digital conversion. Although outband distortion spectrum is folded in the proposed sub-Nyquist sampling technique, determination of compensator coefficients is still possible by using the distortion power. Proposed technique achieves almost same compensation performance in EVM as the conventional compensation scheme, while reducing sampling speed of analog to digital convertor (ADC) to less than half the normal sampling frequency. The proposed technique can be applied in concurrent dual-band communication systems and adapt to flat Rayleigh fading environments.

In this letter, a method of wideband direction of arrival (DOA) estimation based on co-prime arrays with sub-Nyquist sampling is proposed. Previous works have employed co-prime arrays for wideband DOA estimation, which can increase the degrees of freedom (DOFs) in the spatial domain. However, they are all based on Nyquist sampling. Different from existing methods, we incorporate a sub-Nyquist sampling scheme called multicoset sampling for DOA estimation to relax hardware condition. Simulation results show the correctness and effectiveness.

We propose a cooperative spectrum sensing scheme based on sub-Nyquist sampling in cognitive radios. Our main purpose is to understand the uncertainty caused by sub-Nyquist sampling and to present a sensing scheme that operates at low sampling rates. In order to alleviate the aliasing effect of sub-Nyquist sampling, we utilize cooperation among secondary users and the sparsity order of channel occupancy. The simulation results show that the proposed scheme can achieve reasonable sensing performance even at low sampling rates.

A major challenge in wideband spectrum sensing, in cognitive radio system for example, is the requirement of a high sampling rate which may exceed today's best analog-to-digital converters (ADCs) front-end bandwidths. Compressive sampling is an attractive way to reduce the sampling rate. The modulated wideband converter (MWC) proposed recently is one of the most successful compressive sampling hardware architectures, but it has high hardware complexity owing to its parallel channels structure. In this paper, we design a single channel sub-Nyquist sampling scheme to bring substantial savings in terms of not only sampling rate but also hardware complexity, and we also present a wideband power spectrum sensing and reconstruction method for bandlimited wide-sense stationary (WSS) signals. The total sampling rate is only one channel rate of the MWC's. We evaluate the performance of the sensing model by computing the probability of detecting signal occupancy in terms of the signal-to-noise ratio (SNR) and other practical parameters. Simulation results underline the promising performance of proposed approach.