Ternary content addressable memory (TCAM) is popular LSI for use in high-throughput forwarding engines on routers. However, the unique structure applied in TCAM consume huge amounts of power, therefore it restricts the ability to handle large lookup table capacity in IP routers. In this paper, we propose a commodity-memory based hardware architecture for the forwarding information base (FIB) application that solves the substantial problems of power and density. The proposed architecture is examined by a fabricated test chip with 40 nm embedded DRAM (eDRAM) technology, and the effect of power reduction verified is greatly lower than conventional TCAM based and the energy metric achieve 0.01 fJ/bit/search. The power consumption is almost 0.5 W at 250 Msps and 8M entries.

In the era of IPv6, since the number of IPv6 addresses rapidly increases and the required speed is more than Giga lookups per second (GLPS), an area-efficient and high-speed IP lookup architecture is desired. This paper shows a parallel index generation unit (IGU) for memory-based IPv6 lookup architecture. To reduce the size of memory in the IGU, we use a linear transformation and a row-shift decomposition. A single-memory realization requires O(2l log k) memory size, where l denotes the length of prefix, while the realization using IGU requires O(kl) memory size, where k denotes the number of prefixes. In IPv6 prefix lookup, since l is at most 64 and k is about 340 K, the IGU drastically reduces the memory size. Also, to reduce the cost, we realize the parallel IGU by using both on-chip and off-chip memories. We show a design algorithm for the parallel IGU to store given off-chip and on-chip memories. The parallel IGU has a simple architecture and performs lookup by using complete pipelines those insert the pipeline registers in all the paths. We loaded more than 340 K IPv6 pseudo prefixes on the Xilinx Virtex 6 FPGA with off-chip DDRII+ Static RAMs (SRAMs). Its lookup speed is 1.100 giga lookups per second (GLPS) which is sufficient for the required speed for a next generation 400 Gbps link throughput. As for the normalized area and lookup speed, our implementation outperforms existing FPGA implementations.

Network traffic keeps increasing due to the increasing popularity of video streaming services. Routers and switches in wire-line networks require guaranteed line rates as high as 20 Gbp/s as well as advanced quality of service (QoS). Hybrid SRAM and DRAM architecture previously presented with the benefit of high-speed and high-density, but it requires complex memory management. As a result, it has hardly supported large numbers of queue, which is an effective approach to satisfying the QoS requirements. This paper proposes an intelligent memory management unit (MMU) which is based on the hybrid architecture, where over 16k multi queues are integrated. The performance examined by the system board is zero-packet loss under the seamless traffic with 60–1.5 kByte packet-length (deterministic manner). Noticeable feature in this paper's architecture is eliminating the need for any premium memories but only low-cost commodity SRAMs and DRAMs are used. The intelligent MMU employs the head buffer architecture, which is suitable for supporting a large numbers of FIFO queues. An experimental board based on this architecture is embedded into a Router system to evaluate the performance. Using 16k queues at 20 Gbps, zero-packet loss is examined with 64-Byte to 1,500-Byte packet-length.

A multiple-registered architecture is described for 180 MHz 16 Mbit synchronous DRAM. The proposed architecture realizes a flexible control of critical timings such as I/O line busy time and achieves an operation at 180 MHz clock rate with area penalty of only 5.4% over the conventional DRAM.