The search functionality is under construction.

Author Search Result

[Author] Katsuhiko ARAKI(6hit)

1-6hit
  • Spreading Code Assignment for Multicarrier CDMA System over Frequency-Selective Fading Channels

    Takashi SHONO  Tomoyuki YAMADA  Kiyoshi KOBAYASHI  Katsuhiko ARAKI  Iwao SASASE  

     
    PAPER-Terrestrial Radio Communications

      Vol:
    E87-B No:12
      Page(s):
    3734-3746

    In multicarrier code division multiple access (MC-CDMA) systems, the orthogonality among the spreading codes is destroyed because the channels exhibit frequency-selective fading and the despreading stage performs gain control; that is, inter-code interference (ICI) can significantly degrade system performance. This paper proposes an optimum spreading code assignment method that reflects our analysis of ICI for up and downlink MC-CDMA cellular systems over correlated frequency-selective Rayleigh fading channels. At first, we derive theoretical expressions for the desired-to-undesired signal power ratio (DUR) as a quantitative representation of ICI; computer simulation results demonstrate the validity of the analytical results. Next, based on the ICI imbalance among code pairs, we assign specific spreading codes to users to minimize ICI (in short, to maximize the multiplexing performance); our proposed method considers the quality of service (QoS) policy of users or operators. We show that the proposed method yields better performance, in terms of DUR, than the conventional methods. The proposed method can maximize the multiplexing performance of a MC-CDMA cellular system once the channel model, spreading sequence, and combining strategy have been set. Three combining strategies are examined at the despreading stage for the uplink, equal gain combining (EGC), orthogonality restoring combining (ORC), and maximum ratio combining (MRC), while two are considered for the downlink, EGC and MRC.

  • A 0.9-2.6 GHz Broadband RF Front-End Chip-Set with a Direct Conversion Architecture

    Munenari KAWASHIMA  Tadao NAKAGAWA  Hitoshi HAYASHI  Kenjiro NISHIKAWA  Katsuhiko ARAKI  

     
    PAPER

      Vol:
    E85-B No:12
      Page(s):
    2732-2740

    A broadband RF front-end having a direct conversion architecture has been developed. The RF front-end consists of two broadband quadrature mixers, a multi-band local oscillator, and a broadband low-noise variable gain amplifier (LNVGA). The mixer achieves broadband characteristics through the incorporation of an in-phase power divider and a 45-degree power divider. The in-phase power divider achieves broadband characteristics through the addition of a compensation capacitor. The 45-degree power divider achieves broadband phase characteristics through the addition of a compensation capacitor and a compensation resistor. The local oscillator, which is composed of two VCOs, two frequency dividers, and four switches, can cover three systems including one FDD system. The LNVGA achieves its broadband characteristics without the use of reactance elements, such as inductors or capacitors. In a trial demonstration, when the RF frequency was between 900 MHz and 2.5 GHz, the mixer for a demodulator experimentally demonstrated an amplitude balance of less than 1.6 dB and a quadrature phase error of less than 3 degrees. When the RF frequency was between 900 MHz and 2.5 GHz, the mixer for a modulator demonstrated an image ratio of less than -30 dBc. The local oscillator demonstrated multi-band characteristics, which are able to cover the target frequencies for three systems (PDC, PHS, 2.4 GHz WLAN). From 900 MHz to 2.5 GHz, the amplifier shows a noise figure of less than 2.1 dB and a gain of 28 1.6 dB.

  • A Novel Adaptive Linearization Technique for a Balanced-Amplifier Array

    Takana KAHO  Yo YAMAGUCHI  Tadao NAKAGAWA  Katsuhiko ARAKI  Kiyomichi ARAKI  

     
    PAPER-Microwaves, Millimeter-Waves

      Vol:
    E89-C No:10
      Page(s):
    1448-1453

    We propose a novel adaptive linearization technique for a balanced-amplifier array. The technique uses the specific intermodulation distortions (IMDs) at the output ports in the array. The detected IMD power level can be used to optimize the linearizer's characteristics. Because the design does not need as many power detectors and carrier cancel loops as it does amplifiers, we were able to successfully miniaturize the array-antenna system. This paper describes the principles, verified both experimentally and mathematically for a 4-port amplifier array.

  • Inter-Code Interference and Optimum Spreading Sequence in Frequency-Selective Rayleigh Fading Channels on Uplink MC-CDMA

    Takashi SHONO  Tomoyuki YAMADA  Kiyoshi KOBAYASHI  Katsuhiko ARAKI  Iwao SASASE  

     
    PAPER-Signal Processing for Communications

      Vol:
    E87-A No:8
      Page(s):
    1981-1993

    In uplink multicarrier code division multiple access (MC-CDMA), the inter-code interference (ICI) caused by the independent and frequency-selective fading channel of each user and the inter-carrier interference caused by the asynchronous reception of each user's OFDM symbols result in multiple access interference (MAI). This paper evaluates the ICI in frequency-selective Rayleigh fading channels for uplink MC-CDMA. We derive theoretical expressions for the desired-to-undesired signal power ratio (DUR) as a quantitative representation of ICI, and validate them by comparison with computer simulations using a Walsh-Hadamard (WH) code. Based on the analytical results, we obtain the optimum spreading sequence that minimizes the ICI (in short, maximizes the multiplexing performance); this sequence appears to be orthogonal. Three equalization combining methods are examined; equal gain combining (EGC), orthogonality restoring combining (ORC), and maximum ratio combining (MRC).

  • Design and Performance Evaluation of IEEE 802.11a SDR Software Implemented on a Reconfigurable Processor

    Kazunori AKABANE  Hiroyuki SHIBA  Munehiro MATSUI  Kiyoshi KOBAYASHI  Katsuhiko ARAKI  

     
    PAPER

      Vol:
    E88-B No:11
      Page(s):
    4163-4169

    Software defined radio (SDR) mobile terminals that can access multiple wireless communication systems are the trend of the future. An SDR wideband mobile terminal must be capable of high-speed data processing and low power consumption. We focused on reconfigurable processors with these features. To evaluate the performance of reconfigurable processors for SDR wideband mobile terminals, we developed and evaluated software that runs on a reconfigurable processor for the IEEE 802.11a wireless local area network (LAN) baseband part, which requires high-speed data processing. This paper describes the configuration of the SDR IEEE 802.11a software for the reconfigurable processor and its performance evaluation results. Moreover, we showed the requirements for applying the reconfigurable processor to SDR wideband mobile terminals, and confirmed that the reconfigurable processor could be applied to SDR mobile terminals by slight progresses.

  • A Monolithic Linearizer Using an Even-Order-Distortion Controller for an S-Band High Power Amplifier

    Takana KAHO  Hiroshi OKAZAKI  Tadao NAKAGAWA  Katsuhiko ARAKI  Kohji HORIKAWA  

     
    PAPER

      Vol:
    E85-C No:12
      Page(s):
    1959-1966

    An S-band linearizer was developed using GaAs MMIC technology. We call it the even-order-distortion-implemented intermodulation distortion controller (EODIC). EODIC uses even-order intermodulation distortion (IM) components in the second harmonic frequency band to control its IM components in the fundamental frequency band. EODIC is a suitable tool to compensate near-saturated high power amplifiers (HPAs). We developed an EODIC using MMIC technology. This paper describes the principle of EODIC and then introduces the EODIC MMIC in detail. This paper also presents the IM reduction performance of an EODIC in a near-saturated HPA.