We have comprehensively studied by numerical simulation high power transmission properties through single mode fiber for non-repeatered system application. We have clearly captured bit error rates (BERs) of digital coherent signal exhibit specific floor levels, depending on transmitter powers, due to fiber nonlinearity. If the maximum transmitter powers are defined as the powers at which BER floor levels are 1.0×10-2 without error correction, those are found to be approximately +20.4dBm, +14.8dBm and +10.6dBm, respectively, for single-channel 120Gbps DP-QPSK, DP-16QAM and DP-64QAM formats in large-core and low-loss single-mode silica fibers. In the simulations, we set fiber lengths over 100km, which is much longer than the effective fiber length, thus the results are applicable to any of long-length non-repeatered systems. We also show that the maximum transmitter powers gradually decrease in logarithmic feature with the increase of the number of DWDM channels. The channel number dependence is newly shown to be almost independent on the modulation format. The simulated results have been compared with extended Gaussian-Noise (GN) model with introducing adjustment parameters, not only to confirm the validity of the results but to explore possible new analytical modeling for non-repeatered systems.

This paper investigates the transmission capacity of open-loop spatial multiplexing with zero-forcing receivers in overlaid ad hoc networks. We first derive asymptotic closed-form expressions for the transmission capacity of two coexisting networks (a primary network vs. a secondary network). We then address a special case with equal numbers of transmit and receive antennas through exact analysis. Numerical results validate the accuracy of our expressions. Our findings show that the overall transmission capacity of coexisting networks will improve significantly over that of a single network if the primary network can tolerate a slight outage probability increase. This improvement can be further boosted if more streams are configured in the spatial multiplexing scheme; less improvement is achieved by placing more antennas at the receive side than the transmit side. However, when the stream number exceeds a certain limit, spatial multiplexing will produce negative effect for the overlaid network.

In this paper, a 0.18-V input three-stage charge pump circuit applying forward body bias is proposed for energy harvesting applications. In the developed charge pump, all the MOSFETs are forward body biased by using the inter-stage/output voltages. By applying the proposed charge pump as the startup in the boost converter, the kick-up input voltage of the boost converter is reduced to 0.18 V. To verify the circuit characteristics, the conventional zero body bias charge pump and the proposed forward body bias charge pump were fabricated with 65 nm CMOS process. The measured output current of the proposed charge pump under 0.18-V input voltage is increased by 170% comparing to the conventional one at the output voltage of 0.5 V. In addition, the boost converter successfully boosts the 0.18-V input to higher than 0.65-V output.

Laser speech detection uses a non-contact Laser Doppler Vibrometry (LDV)-based acoustic sensor to obtain speech signals by precisely measuring voice-generated surface vibrations. Over long distances, however, the detected signal is very weak and full of speckle noise. To enhance the quality and intelligibility of the detected signal, we designed a two-sided Linear Prediction Coding (LPC)-based locator and interpolator to detect and replace speckle noise. We first studied the characteristics of speckle noise in detected signals and developed a binary-state statistical model for speckle noise generation. A two-sided LPC-based locator was then designed to locate the polluted samples, composed of an inverse decorrelator, nonlinear filter and threshold estimator. This greatly improves the detectability of speckle noise and avoids false/missed detection by improving the noise-to-signal-ratio (NSR). Finally, samples from both sides of the speckle noise were used to estimate the parameters of the interpolator and to code samples for replacing the polluted samples. Real-world speckle noise removal experiments and simulation-based comparative experiments were conducted and the results show that the proposed method is better able to locate speckle noise in laser detected speech and highly effective at replacing it.

In this paper, Digital Low Dropout Regulator (LDO) is proposed to provide the low noise and tunable power supply voltage to the 0.5-V near-threshold logic circuits. Because the conventional LDO feedback-controlled by the operational amplifier fail to operate at 0.5 V, the digital LDO eliminates all analog circuits and is controlled by digital circuits, which enables the 0.5-V operation. The developed digital LDO in 65 nm CMOS achieved the 0.5-V input voltage and 0.45-V output voltage with 98.7% current efficiency and 2.7-µA quiescent current at 200-µA load current. Both the input voltage and the quiescent current are the lowest values in the published LDO's, which indicates the good energy efficiency of the digital LDO at 0.5-V operation.