This paper describes circuit design and measurement results of a newly proposed GaAs-HBT step-gain amplifier configuration and its application to a 3.3-3.6 GHz WiMAX power amplifier module for use in customer premises equipment. The step-gain amplifier implemented using only a usual HBT process is based on a current-mirror-based, base-collector diode switches and a passive attenuator core for the purpose of bypassing a power-gain stage. The stage allows an individual design approach in terms of gain and attenuation levels as well as large operating current reduction in the attenuation state. To confirm the effectiveness of the proposed step-gain amplifier, a prototype of the amplifier was designed and fabricated, and then a WiMAX power amplifier module was also designed and fabricated as an application example of the proposed configuration to an amplifier product. Measurements are as follows. For a 3.5-V power supply and a 3.5-GHz non-modulated signal, the step-gain amplifier delivers 23.7 dBm of 1-dB gain compressed output power and 10.7 dB of linear gain in the amplification state. In the attenuation state, the amplifier exhibits 21 dBm of 1-dB gain expanded input power, -9.7 dB of gain, and 15 mA of current dissipation while keeping the gain stage switched off and maintaining input and output return loss of less than -10 dB at a 3.5-GHz band. The WiMAX amplifier operating with a 5-V supply voltage and a 64-QAM modulated signal is capable of delivering a 28.5-dBm linear output power, a 37-39 dB gain, and 15% of PAE over a wide frequency range from 3.3 to 3.6 GHz in the high-gain state while keeping error vector magnitude as low as 2.5%. This amplifier, which incorporates the proposed step-gain configuration into its interstage, enables a 24-dB gain reduction and a 45-mA large quiescent current reduction in the low-gain state.

This paper describes a novel layout optimization technique using electromagnetic (EM) simulation. Simple equivalent circuits fitted to EM simulation results are employed in this method, to present a modification guide for a layout pattern. Fitting errors are also investigated with some layout patterns in order to clarify the applicable range of the method, because the errors restrict the range. The method has been successfully adopted to an X-band low noise MMIC amplifier (LNA). The layout pattern of the amplifier was optimized in only two days and the amplifier has achieved target performances--a 35 dB gain and a 1.7 dB noise figure--in one development cycle. The effective chip area has been miniaturized to 4.8 mm2. The area could be smaller than 70% in comparison with a conventional layout MMIC.