A new structure of the electro-optic modulator to compensate the third-order intermodulation distortion (IMD3) is introduced. The modulator includes two Mach-Zehnder modulators (MZMs) operating with frequency chirp and the two modulated outputs are combined with an adequate phase difference. We revealed by theoretical analysis and numerical calculations that the IMD3 components in the receiver output could be selectively suppressed when the two MZMs operate with chirp parameters of opposite signs to each other. Spectral power of the IMD3 components in the proposed modulator was more than 15dB lower than that in a normal Mach-Zehnder modulator at modulation index between 0.15π and 0.25π rad. The IMD3 compensation properties of the proposed modulator was experimentally confirmed by using a dual parallel Mach-Zehnder modulator (DPMZM) structure. We designed and fabricated the modulator with the single-chip structure and the single-input operation by integrating with 180° hybrid coupler on the modulator substrate. Modulation signals were applied to each modulation electrode by the 180° hybrid coupler to set the chirp parameters of two MZMs of the DPMZM. The properties of the fabricated modulator were measured by using 10GHz two-tone signals. The performance of the IMD3 compensation agreed with that in the calculation. It was confirmed that the IMD3 compensation could be realized even by the fabricated modulator structure.

An electro-optic (EO) modulator integrated with the microwave planar circuit directly formed on a LiNbO3 (LN) substrate for low frequency-chirp performance and compact configuration is introduced. Frequency chirp of EO intensity modulators was investigated and a dual-electrode Mach-Zehnder (MZ) modulator combined with a microwave rat-race (RR) circuit was considered for the low-chirp modulation. The RR circuit, which operates as a 180-degree hybrid, was designed on a z-cut LN substrate to create two modulation signals of the same amplitude in anti-phase with each other from a single input signal. Output ports of the RR were connected to the modulation electrodes on the substrate. The two signals of the equal amplitude drive two phase modulation parts of the modulator so that the symmetric interference are realized to obtain intensity modulation of low frequency-chirp. The modulator was designed and fabricated on a single LN substrate for around 10 GHz modulation frequencies and 1550 nm light wavelength. The chirp parameters were measured to be less than 0.2 in the frequency range between 8 and 12 GHz. By compensating imbalance of the light power splitting in the waveguide MZ interferometer the chirp could be reduced even more.

Optical single sideband (SSB) modulation with the Mach-Zehnder (MZ) interferometer was realized by integrating the modulation electrode with the branch-line coupler (BLC) as a 90-degree hybrid onto the modulator substrate. In this paper, BLCs of the microsrtip-line structure were miniaturized on modulator substrates, LiNbO3 (LN), to realize more compact optical SSB modulators. We introduced two techniques of miniaturizing the BLC, one is using periodically installed open-circuited stabs and the other is installing series capacitors. Compared with a conventional pattern of the BLC, an area of the miniaturized BLC by using periodically installed open-circuited stubs was reduced to about 50%, and that by installing series capacitors was done to about 60%. The operation of these miniaturized BLCs was experimentally confirmed as the 90-degree hybrid at around 10GHz. Output ports of each miniaturized BLC were directly connected with the modulation electrode on the modulator substrate. Thereby, we fabricated two types of compact SSB modulators for 1550nm light wavelength. In the experiments, the optical SSB modulation was successfully confirmed by the output light spectra and the sideband suppression ratio of more than 30dB were observed.

We propose new electro-optic modulators using a double antenna-coupled electrode structure for radio-over-fiber systems. The proposed modulators are composed of a pair of patch antennas and a standing-wave resonant electrode. By utilizing a pair of patch antennas on SiO2 substrates and a coupled-microstrip line resonant electrode on a LiNbO3 substrate with a symmetric configuration, high-efficiency optical modulation is obtainable for 24 optical waveguides at the same time. The proposed modulators were designed at 58 GHz and their basic operations were demonstrated successfully with an improvement of 9 dB compared to a single antenna-coupled electrode device on a LiNbO3 substrate in our previous work.

A novel and compact electro-optic modulator implemented by a combination of a 12 multimode interference (MMI) coupler and an integrated Mach-Zehnder interferometer (MZI) modulator consisting of a microring and a phase modulator (PM) is presented and analyzed theoretically. It is shown that the proposed modulator offers both ultra-linearity and high output RF gain simultaneously, with no requirements for complicated and precise direct current (DC) control.