1-4hit |
Huan-Bang LI Kenichi TAKIZAWA Fumihide KOJIMA
Because of its high throughput potentiality on short-range communications and inherent superiority of high precision on ranging and localization, ultra-wideband (UWB) technology has been attracting attention continuously in research and development (R&D) as well as in commercialization. The first domestic regulation admitting indoor UWB in Japan was released by the Ministry of Internal Affairs and Communications (MIC) in 2006. Since then, several revisions have been made in conjunction with UWB commercial penetration, emerging new trends of industrial demands, and coexistence evaluation with other wireless systems. However, it was not until May 2019 that MIC released a new revision to admit outdoor UWB. Meanwhile, the IEEE 802 LAN/MAN Standards Committee has been developing several UWB related standards or amendments accordingly for supporting different use cases. At the time when this paper is submitted, a new amendment known as IEEE 802.15.4z is undergoing drafting procedure which is expected to enhance ranging ability for impulse radio UWB (IR-UWB). In this paper, we first review the domestic UWB regulation and some of its revisions to get a picture of the domestic regulation transition from indoor to outdoor. We also foresee some anticipating changes in future revisions. Then, we overview several published IEEE 802 standards or amendments that are related to IR-UWB. Some features of IEEE 802.15.4z in drafting are also extracted from open materials. Finally, we show with our recent research results that time bias internal a transceiver becomes important for increasing localization accuracy.
Lechang LIU Takayasu SAKURAI Makoto TAKAMIYA
A 0.6-V voltage shifter and a 0.6-V clocked comparator are presented for sampling correlation-based impulse radio UWB receiver. The voltage shifter is used for a novel split swing level scheme-based CMOS transmission gate which can reduce the power consumption by four times. Compared to the conventional voltage shifter, the proposed voltage shifter can reduce the required capacitance area by half and eliminate the non-overlapping complementary clock generator. The proposed 0.6-V clocked comparator can operate at 100-MHz clock with the voltage shifter. To reduce the power consumption of the conventional continuous-time comparator based synchronization control unit, a novel clocked-comparator based control unit is presented, thereby achieving the lowest energy consumption of 3.9 pJ/bit in the correlation-based UWB receiver with the 0.5 ns timing step for data synchronization.
Lechang LIU Zhiwei ZHOU Takayasu SAKURAI Makoto TAKAMIYA
A low power impulse radio ultra-wideband (IR-UWB) receiver for DC-960 MHz band is proposed in this paper. The proposed receiver employs multiple DC power-free charge-domain sampling correlators to eliminate the need for phase synchronization. To alleviate BER degradation due to an increased charge injection in a subtraction operation in the sampling correlator than that of an addition operation, a comparator with variable threshold (=offset) voltage is used, which enables an addition-only operation. The developed receiver fabricated in 1.2 V 65 nm CMOS achieves the lowest energy consumption of 17.6 pJ/bit at 100 Mbps in state-of-the-art correlation-based UWB receivers.
Lechang LIU Yoshio MIYAMOTO Zhiwei ZHOU Kosuke SAKAIDA Jisun RYU Koichi ISHIDA Makoto TAKAMIYA Takayasu SAKURAI
A novel DC-to-960 MHz impulse radio ultra-wideband (IR-UWB) transceiver based on threshold detection technique is developed. It features a digital pulse-shaping transmitter, a DC power-free pulse discriminator and an error-recovery phase-frequency detector. The developed transceiver in 90 nm CMOS achieves the lowest energy consumption of 2.2 pJ/bit transmitter and 1.9 pJ/bit receiver at 100 Mbps in the UWB transceivers.