The performance of a network router/switch has improved significantly over past decades with explosively increasing internet and data center traffic. The performance of a router heavily depends on the memory system, e.g. DRAM based packet buffers, which often limits the scalability of a router. However, a widening gap between memory I/O bus and memory cell array speed and decreasing row buffer locality from increasing channels and banks severely reduce the performance gain from state-of-the-art memory technology such as DDR4 or HBM2 DRAM. Prior works improved memory bandwidth by maintaining SRAM-based per-queue or per-bank input/output buffers in the memory controller to support a DRAM-based packet buffer. The buffers temporarily store packets when bank conflicts occur but are unable to prevent interference-inducing traffic from thrashing DRAM's row buffers. In this study, we directly integrate SRAM into the DRAM-based packet buffer and map those packets degrading row buffer locality of DRAM into SRAM. This maximizes locality and parallelism of DRAM accesses. The proposed scheme can benefit any existing schemes. Experimental results show 22.41% improvement over the best existing scheme for a single channel in terms of the memory bandwidth utilization under harsh congested scenarios.

This paper presents a soft-error-tolerant memory-control circuit for SRAM-based field programmable gate arrays (FPGAs). A potential obstacle to applying such FPGAs to safety-critical industrial control systems is their low tolerance. The main reason is that soft errors damage circuit-configuration data stored in SRAM-based configuration memory. To overcome this obstacle, the soft-error tolerance must thus be improved while suppressing the circuit area overhead, and data stored in external memory must be protected when a fault occurs on the FPGA. Therefore, a memory-control circuit was developed on the basis of a dual-modular-redundancy (DMR) architecture. This memory controller has a repair and retry scheme that repairs damaged circuit-configuration data and re-executes unfinished accesses after the repair. The developed architecture reduces circuit redundancy below that of a commonly used triple-modular-redundancy (TMR) architecture. Moreover, a write-invalidation circuit was developed to protect data in external memory, and an external-memory-state recovery circuit was developed to enable resumption of memory access after fault repair. The developed memory controller was implemented in a prototype circuit on an FPGA and evaluated using the prototype. The evaluation results demonstrated that the developed memory controller can operate successfully for 1.03×109 hours (at sea level). In addition, its circuit area overhead was found to be sufficiently smaller than that of the TMR architecture.

Network traffic keeps increasing due to the increasing popularity of video streaming services. Routers and switches in wire-line networks require guaranteed line rates as high as 20 Gbp/s as well as advanced quality of service (QoS). Hybrid SRAM and DRAM architecture previously presented with the benefit of high-speed and high-density, but it requires complex memory management. As a result, it has hardly supported large numbers of queue, which is an effective approach to satisfying the QoS requirements. This paper proposes an intelligent memory management unit (MMU) which is based on the hybrid architecture, where over 16k multi queues are integrated. The performance examined by the system board is zero-packet loss under the seamless traffic with 60–1.5 kByte packet-length (deterministic manner). Noticeable feature in this paper's architecture is eliminating the need for any premium memories but only low-cost commodity SRAMs and DRAMs are used. The intelligent MMU employs the head buffer architecture, which is suitable for supporting a large numbers of FIFO queues. An experimental board based on this architecture is embedded into a Router system to evaluate the performance. Using 16k queues at 20 Gbps, zero-packet loss is examined with 64-Byte to 1,500-Byte packet-length.

FPGA-based hardware emulators are often used for the verification of LSI functions. They generally have dedicated external memories, such as SDRAMs, to compensate for the lack of memory capacity in FPGAs. In such a case, access between the FPGAs and the dedicated external memory may represent a major bottleneck with respect to emulation speed since the dedicated external memory may have to emulate a large number of memory blocks. In this paper, we propose three methods, "Dynamic Clock Control (DCC)," "Memory Mapping Optimization (MMO)," and "Efficient Access Scheduling (EAS)," to avoid this bottleneck. DCC controls an emulation clock dynamically in accord with the number of memory accesses within one emulation clock cycle. EAS optimizes the ordering of memory access to the dedicated external memory, and MMO optimizes the arrangement of the dedicated external memory addresses to which respective memories will be emulated. With them, emulation speed can be made 29.0 times faster, as evaluated in actual LSI emulations.