This paper proposes a pulse-width modulated (PWM) signaling[1] to send clock and data over a pair of channels for in-vehicle network where a closed chain of point-to-point (P2P) interconnection between electronic control units (ECU) has been established. To improve detection speed and margin of proposed receiver, we also proposed a novel clock and data recovery (CDR) scheme with 0.5 unit-interval (UI) tuning range and a PWM generator utilizing 10 equally-spaced phases. The feasibility of proposed system has been proved by successfully detecting 1.25 Gb/s data delivered via 3 ECUs and inter-channels in 180 nm CMOS technology. Compared to previous study, the proposed system achieved better efficiency in terms of power, cost, and reliability.

This paper presents a measurement circuit structure for capturing SET pulse-width suppressing pulse-width modulation and within-die process variation effects. For mitigating pulse-width modulation while maintaining area efficiency, the proposed circuit uses massively parallelized short inverter chains as a target circuit. Moreover, for each inverter chain on each die, pulse-width calibration is performed. In measurements, narrow SET pulses ranging 5ps to 215ps were obtained. We confirm that an overestimation of pulse-width may happen when ignoring die-to-die and within-die variation of the measurement circuit. Our evaluation results thus point out that calibration for within-die variation in addition to die-to-die variation of the measurement circuit is indispensable.

A novel driving concept, "pulse-width modulation with current uniformization," is proposed for thin-film transistor driven organic light-emitting diode displays (TFT-OLEDs). An example of this driving concept is the combination of "pulse-width modulation with a self-biased inverter" and a "time-ratio grayscale with current uniformization." Its driving operation is confirmed by circuit simulation. It is found that this driving method can compensate the characteristic deviations and degradations of both TFTs and OLEDs and immensely improve luminance uniformity. Finally, its driving operation is also confirmed by an actual pixel equivalent circuit.

This paper studies dynamics of a delta modulator for PWM control. In order to analyze the circuit dynamics we derive a one-dimensional return map of switching time. The map is equivalent to a circle map in wide parameter region and its nonperiodic behavior corresponds to undesired asynchronous operation of the circuit. We then present a simple stabilization method of the system operations by means of periodic compulsory switching. The mechanism of the stabilization is considered from viewpoints of bifurcation. Using a simple test circuit, typical operations are confirmed experimentally.

The concept of stochastic association has originally been proposed in relation to single-electron devices having stochastic behavior due to quantum effects. Stochastic association is one of the promising concepts for future VLSI systems that exceed the conventional digital systems based on deterministic operation. This paper proposes a CMOS stochastic associative processor using PWM (pulse-width modulation) chaotic signals. The processor stochastically extracts one of the stored binary patterns depending on the order of similarity to the input. We confirms stochastic associative processing operation by experiments for digit pattern association using the CMOS test chip.

This letter proposes a pulse width modulated (PWM) control method which can stabilize chaotic orbits onto unstable fixed points and unstable periodic orbits. Some numerical experiments using the Lorenz equation show that chaotic orbits can be stabilized by the PWM control method. Furthermore, we investigate the stability in the neighborhood of an unstable fixed point and discuss the stability condition of the PWM control method.