To cope with the drastic increase in traffic, space division multiplexing elastic optical networks (SDM-EONs) have been investigated. In multicore fiber environments that realize SDM-EONs, crosstalk (XT) occurs between optical paths transmitted in the same frequency slots of adjacent cores, and the quality of the optical paths is degraded by the mutual influence of XT. To solve this problem, we propose a core and spectrum assignment method that introduces the concept of prohibited frequency slots to protect the degraded optical paths. First-fit-based spectrum resource allocation algorithms, including our previous study, have the problem that only some frequency slots are used at low loads, and XT occurs even though sufficient frequency slots are available. In this study, we propose a core and spectrum assignment method that introduces the concepts of “adjacency criterion” and “XT budget” to suppress XT at low and middle loads without worsening the path blocking rate at high loads. We demonstrate the effectiveness of the proposed method in terms of the path blocking rate using computer simulations.

Multi-core fiber (MCF) is one of the promising space-division multiplexing technologies to increase the capacity of optical networks. MCF-based networks have two challenges. One is the inter-core crosstalk (XT) that degrades the quality of optical signals in two neighboring fiber cores. The other is network protection against link failures that cause massive data loss. One way to protect against multiple link failures is to prepare physically separated links as a backup network. Probabilistic protection improves the efficiency of protection by allowing a certain probability of protection failure. Existing studies on backup network design with probabilistic protection do not target MCF-based networks, which raises problems such as protection failure due to the inter-core XT and excessive consumption of optical resources. To address these problems, this paper proposes a XT-aware backup network design model for the MCF optical path networks. The proposed model protects the network against probabilistic multiple link failures. We adopt probabilistic protection that allows a certain probability of protection failure due to the inter-core XT and minimizes the required number of links in the backup network. We present an algorithm to satisfy the probabilistic protection requirement and formulate the model as an integer linear programming problem. We develop a heuristic approach to apply the proposed model to larger networks. Numerical results observe that the proposed model requires fewer links than the dedicated allocation model, which provisions the backup paths in the same manner as the primary paths.

We propose a novel mode-multiplexed light source using angularly-multiplexed volume holograms. Mode division multiplexing beams can be generated from a simple transmitter that is made of a laser array, single lens, and volume holograms. Hologram media has low recording sensitivity; hence, using holograms in the communication band is difficult. However, a dual wavelength method that uses different wavelengths for recording and reading holograms can realize the volume holograms for the infrared region. The volume holograms for three spatial mode multiplexing are formed using a compact Michelson interferometer type recording setup; simultaneous generations of three modes were demonstrated using a fiber array or vertical cavity surface emitting laser array with the volume holograms. A low loss coupling of three modes to few-mode-fiber can be achieved through the precise design and recording of volume holograms. The simple and low-cost mode-multiplexed light source using the volume holograms has the potential to broaden the application of MDM.

To simultaneously enhance data rate and physical layer security (PLS) for low-luminance smartphone screen to camera uplink communication, space division multiplexing using high-luminance cell-size reduction arrangement is numerically analyzed and experimentally verified. The uplink consists of a low-luminance smartphone screen and an indoor telephoto camera at a long distance of 3.5 meters. The high-luminance cell-size reduction arrangement avoids the influence of spatial inter-symbol interference (ISI) and ambient light to obtain a stable low-luminance screen. To reduce the screen luminance without decreasing the screen pixel value, the arrangement reduces only the high-luminance cell area while keeping the cell spacing. In this study, two technical issues related to high-luminance cell-size reduction arrangement are solved. First, a numerical analysis and experimental results show that the high-luminance cell-size reduction arrangement is more effective in reducing the spatial ISI at low luminance than the conventional low-luminance cell arrangement. Second, in view point of PLS enhancement at wide angles, symbol error rate should be low in front of the screen and high at wide angles. A numerical analysis and experimental results show that the high-luminance cell-size reduction arrangement is more suitable for enhancing PLS at wide angles than the conventional low-luminance cell arrangement.

Although multi-user multiple-input multiple-output (MI-MO) systems provide high data rate transmission, they may suffer from interference. Block diagonalization and eigenbeam-space division multiplexing (E-SDM) can suppress interference. The transmitter needs to determine beamforming weights from channel state information (CSI) to use these techniques. However, MIMO channels change in time-varying environments during the time intervals between when transmission parameters are determined and actual MIMO transmission occurs. The outdated CSI causes interference and seriously degrades the quality of transmission. Channel prediction schemes have been developed to mitigate the effects of outdated CSI. We evaluated the accuracy of prediction of autoregressive (AR)-model-based prediction and Lagrange extrapolation in the presence of channel estimation error. We found that Lagrange extrapolation was easy to implement and that it provided performance comparable to that obtained with the AR-model-based technique.

The stochastic behavior of inter-core crosstalk in multi-core fiber is discussed based on a theoretical model validated by measurements, and the effect of the crosstalk on the Q-factor in transmission systems, using multi-core fiber is investigated theoretically. The measurements show that the crosstalk rapidly changes with wavelength, and gradually changes with time, in obedience to the Gaussian distribution in I-Q planes. Therefore, the behavior of the crosstalk as a noise may depend on the bandwidth of the signal light. If the bandwidth is adequately broad, the crosstalk may behave as a virtual additive white Gaussian noise on I-Q planes, and the Q-penalty at the Q-factor of 9.8dB is less than 1dB when the statistical mean of the crosstalk from other cores is less than -16.7dB for PDM-QPSK, -23.7dB for PDM-16QAM, and -29.9dB for PDM-64QAM. If the bandwidth is adequately narrow, the crosstalk may behave as virtually static coupling that changes very gradually with time and heavily depends on the wavelength. To cope with a static crosstalk much higher than its statistical mean, a margin of several decibels from the mean crosstalk may be necessary for suppressing Q-penalty in the case of adequately narrow bandwidth.

In this paper, the performance of multiuser MIMO E-SDM systems in downlink transmission is evaluated in both uncorrelated and correlated time-varying fading environments. In the ideal case, using the block diagonalization scheme, inter-user interference can be completely eliminated at each user; and using the E-SDM technique for each user, optimal resource allocation can be achieved, and spatially orthogonal substreams can be obtained. Therefore, a combination of the block diagonalization scheme and the E-SDM technique applied to multiuser MIMO systems gives very good results. In realistic environments, however, due to the dynamic nature of the channel and processing delay at both the transmitter and the receiver, the channel change during the delay may cause inter-user interference even if the BD scheme is used. In addition, the change may also result in large inter-substream interference and prevent optimal resource allocation from being achieved. As a result, system performance may be degraded seriously. To overcome the problem, we propose a method of channel extrapolation to compensate for the channel change. Applying our proposed method, simulation results show that much better system performance can be obtained than the conventional case. Moreover, it also shows that the system performance in the correlated fading environments is much dependent on the antenna configuration and the angle spread from the base station to scatterers.

In time-varying fading environments, the performance of multiple-input multiple-output (MIMO) systems applying an eigenbeam-space division multiplexing (E-SDM) technique may be degraded due to a channel change during the time interval between the transmit weight matrix determination and the actual data transmission. To compensate for the channel change, we have proposed some channel prediction methods. Simulation results based on computer-generated channel data showed that better performance can be obtained when using the prediction methods in Rayleigh fading environments assuming the Jakes model with rich scatterers. However, actual MIMO systems may be used in line-of-sight (LOS) environments, and even in a non-LOS case, scatterers may not be uniformly distributed around a receiver and/or a transmitter. In addition, mutual coupling between antennas at both the transmitter and the receiver cannot be ignored as it affects the system performance in actual implementation. We conducted MIMO channel measurement campaigns at a 5.2 GHz frequency band to evaluate the channel prediction techniques. In this paper, we present the experiment and simulation results using the measured channel data. The results show that robust bit-error rate performance is obtained when using the channel prediction methods and that the methods can be used in both Rayleigh and Rician fading environments, and do not need to know the maximum Doppler frequency.

In a frequency-selective multiple-input multiple-output (MIMO) channel, the optimum transmission is achieved by beamforming with eigenvectors obtained at each discrete frequency point, i.e., an extension of eigenbeam-space division multiplexing (E-SDM). However, the calculation load of eigenvalue decomposition at the transmitter increases in proportion to the number of frequency points. In addition, frequency-independent eigenvectors increase the delay spread of the effective channel observed at the receiver. In this paper, we propose a pseudo eigenvector scheme for the purpose of mitigating the calculation load and maintaining frequency continuity (or decreasing the delay spread). First, we demonstrate that pseudo eigenvectors reduce the delay spread of the effective channels with low computational complexity. Next, the practical performance of the pseudo E-SDM (PE-SDM) transmission is evaluated. The simulation results show that PE-SDM provides almost the same or better performance compared with E-SDM when the receiver employs a time-windowing-based channel estimation available in the low delay spread cases.

MIMO systems using a space division multiplexing (SDM) technique in which each transmit antenna sends an independent signal substream have been studied as one of the successful applications to increase data rates in wireless communications. The throughput of a MIMO channel can be maximized by using an eigenbeam-SDM (E-SDM) technique, and this paper investigates the practical performance of 22 and 44 MIMO E-SDM based on indoor measurements. The channel capacity and bit error rate obtained in various uniform linear array configurations are evaluated and are compared with the corresponding values for conventional SDM. Analysis results show that the bit error rate performance of E-SDM is better than that of SDM and that E-SDM gives better performance in line-of-sight (LOS) conditions than in non-LOS ones. They also show that the performance of E-SDM in LOS conditions depends very much on the array configuration.

Multiple-input multiple-output (MIMO) systems using eigenbeam space division multiplexing (E-SDM) perform well and have increased capacities compared with those using conventional space division multiplexing (SDM). However, channel state information (CSI) is required at a transmitter, and the performance of E-SDM systems depends much on the accuracy of the CSI at a transmitter and a receiver. In time-varying fading environments, the channel change between the transmit weight determination time and the actual data transmission time causes the system performance to degrade. To compensate for the channel error, a linear extrapolation method has been proposed for a time division duplexing system. Unfortunately, the system performance still deteriorates as the maximum Doppler frequency increases. Here, two new techniques of channel extrapolation are proposed. One is second order extrapolation, and the other is exponential extrapolation. Also, we propose maximum Doppler frequency estimation methods for exponential extrapolation. Simulation results for 4tx 4rx MIMO systems showed that using the proposed techniques, E-SDM system performs better in a higher Doppler frequency region.

We consider space division multiplexing in a MIMO-OFDM system for high data rate transmission. Channel estimation is very important for suppressing interference and demultiplexing signals. In a wireless LAN system such as IEEE 802.11a, only a few training symbols are inserted in each subcarrier. First, we propose a channel estimation method for a MIMO-OFDM system with two training symbols per subcarrier. The basic idea is to estimate the time-domain channel responses between the transmit and receive antennas. The array response vectors for each subcarrier are calculated by applying a fast Fourier transform to them. We then can obtain the adaptive weights to cancel the interference. We show that employing training symbols having a lower condition number of the matrix used for the channel estimation improves the estimation accuracy. Furthermore, we show the bit error rate for several signal detection schemes using the above estimated channel. It is shown that an ordered successive detection based on an MMSE criterion has excellent performance, that is, it can achieve higher-speed transmissions with a lower transmit power.

In this paper, to enhance the power efficiency a new simple space-time coding scheme is devised with application to the OFDM based Wireless LAN system. The basic idea is from the receiver's point of view and is referred to as Virtual Constellation Mapping (VCM). We designed a new combination of the channel coding (Turbo Code) along with multiple transmit antennas (Two antennas) to achieve transmit diversity and space division multiplexing transmission. Computer simulation results showed that with the same transmission data rate, our proposed scheme can achieve better bit error rate (BER) compared with the conventional space-time trellis coded OFDM scheme in high Doppler fading channels.

In this letter, we study the performance of the iterative receiver as applied to the space division multiplexing/orthogonal frequency division multiplexing (SDM/OFDM) systems. The iterative receiver under consideration employs the soft in/soft out (SISO) decoding process, which operates iteratively in conjunction with channel estimation for performing data detection and channel estimation at the same time. As opposed to the previous studies in which the perfect channel state information is assumed, the effects of channel estimation are taken into account for evaluating the performance of the iterative receiver and it is shown that the channel estimation applied in every iteration step of the iterative receiver plays a crucial role to warrant the performance, especially at a low signal-to-noise power ratio (SNR).