In this paper, we quantitively analyzed speech data in seven different styles to make natural Japanese conversational speech synthesis. Three reading styles were produced at different speeds (slow, normal and fast), and four speaking styles were produced by enacting conversation in different situations (free, hurried, angry and polite). To clarify the differences in prosodic characteristics between conversational speech and read speech, means and standard deviations of vowel duration, vowel amplitude and fundamental frequency (F0) were analyzed. We found large variation in these prosodic parameters. To look more precisely at the segmental duration and segmental amplitude differences between conversational speech and read speech, control rules of prosodic parameters in reading styles were applied to conversational speech. F0 contours of different speaking styles are superposed by normalizing the segmental duration. The differences between estimated values and actual values were analyzed. Large differences were found at sentence final and key (focused) phrases. Sentence final positions showed lengthening of segmental vowel duration and increased segmental vowel amplitude. Key phrase positions featured raising F0.

We analyze frame rates in low bit rate video coding and show that an optimal frame rate can be theoretically obtained. In low bit rate video coding the frame rate is usually forced to be decreased for reducing the total amount of coded information. The choice of frame rate, however, has a great effect on the picture quality in a trade-off relation between coded picture quality and motion smoothness. It is known from experience that in order to achieve an optimum balance between these two factors, a frame rate has to be selected which is appropriate for the coding scheme, property of the video sequences and coding bit rate. A theoretical analysis, however, on the existence of an optimal frame rate and how the optimal frame rate would be expressed has not been performed. In this paper, coding distortion measured by mean square error is analyzed by using video signal models such as a rate-distortion function for coded frames and inter-frame correlation coefficients for non-coded frames. Overall picture quality taking account of coded picture quality and motion smoothness simultaneously is expressed as a function of frame rate. This analysis shows that the optimum frame rate can be uniquely specified. The maximum frame rate is optimal when the coding bit rate is higher than a certain value for a given video scene, while a frame rate less than the maximum is optimal otherwise. The result of the theoretical analysis is compared with the results of computer simulation. In addition, the relation between this analysis and a subjective evaluation is described. From both comparisons this theoretical analysis can be justified as an effective scheme to indicate the optimal frame rate, and it shows the possibility of improving picture quality by selecting frame rate adaptively.

A text-to-speech conversion system for Japanese has been developed for the purpose of producing high-quality speech output. This system consists of four processing stages: 1) linguistic processing, 2) phonological processing, 3) control parameter generation, and 4) speech waveform generation. Although the processing at the first stage is restricted to the texts on general weather conditions, the other three stages can also cope with texts of news and narrations on other topics. Since the prosodic features of speech are largely related to the linguistic information, such as word accent, syntactic structure and discourse structure, linguistic processing of a wider range than ever, at least a sentence, is indispensable to obtain good quality speech with respect to the prosody. From this point of view, input text was restricted to the weather forecast sentences and a method for linguistic processing was developed to conduct morpheme, syntactic and semantic analyses simultaneously. A quantitative model for generating fundamental frequency contours was adopted to make a good reflection of the linguistic information on the prosody of synthetic speech. A set of prosodic rules was constructed to generate prosodic symbols representing prosodic structures of the text from the linguistic information obtained at the first stage. A new speech synthesizer based on the terminal analog method was also developed to improve the segmental quality of synthetic speech. It consists of four paths of cascade connection of pole/zero filters and three waveform generators. The four paths are respectively used for the synthesis of vowels and vowel-like sounds, nasal murmur and buzz bar, friction, and plosion, while the three generators produce voicing source waveform approximated by polynomials, white Gaussian noise source for fricatives and impulse source for plosives. The validity of the approach above has been confirmed by the listening tests using speech synthesized by the developed system. Improvements both in the quality of prosodic features and in the quality of segmental features were realized for the synthetic speech.

A new automated main distributing frame (AMDF) system is developed that reduces operating costs in metallic-cable main distributing frames (MDFs) used for communication networks. In this AMDF system, a robot inserts connecting-pins into the crosspoint holes of matrix-boards. This process allows jumpering to be completed within three minutes and the route-setting for line testing within one minute. The AMDF system provides approximately 2,100 office equipment cable-terminals. Parallel installation of several AMDF systems allows larger MDF systems to be constructed. This system reduces costs and achieves high reliability through three new technologies: high-density matrix-board, precision pin-handling, and a highly reliable system control. Test results for a prototype AMDF system confirm their effectiveness.

Scattering characteristics of a stratified chiral slab, which is composed of dielectric chiral layers of different material properties and thicknesses, are extensively explored. Design considerations for optical filters are also presented for both the cases of normal and oblique incidence. In the analysis, the incident field is assumed to be a plane monochromatic wave of any arbitrary polarization. The transmitted and reflected electric fields are obtained by noting the fact that the electric field inside a chiral medium is expressed as a sum of the left- and right-circularly polarized plane waves of different phase velocities. Then one can describe the power densities and the Stokes parameters of the transmitted and reflected waves in terms of their field components. As is well known,the Stokes parameters characterize every possible state of polarization of a plane wave. Numerical examples are presented to show the effects of chirality on polarization conversion properties of the stratified chiral slab. The cross- and co-polarized powers and the Stokes parameters of the transmitted and reflected waves are computed for the incident wave of perpendicular polarization. The numerical results demonstrate novel depolarization properties of the slab with application to the design of efficient filters active at the optical region. It is seen from the results that the stratified chiral slab acts as a polarization-conversion transmission filter that passes only a cross-polarized component of the transmitted wave at some frequency band. Furthermore, the slab may be utilized as an antireflection filter for both the cross- and co-po1arized components of the reflected wave at the band region.

The paper presents the improvement of out new approach to optimize the process parameter variation, device heat and wire parasitics for analog LSI design by explicitly incorporating various performance estimations into objective functions for placement and routing. To minimize these objective functions, the placement by the simulated annealing method, and maze routing are effectively modified with the perfomance estimation. The improvement results in the excellent performance driven layout for the large size of analog LSIs.

In this paper, a definitce relation between the TSP's optimal solution and the attracting region in the parameters space of TSP's energy function is discovered. An many attracting region relating to the global optimal solution for TSP is founded. Then a neural network algorithm with the optimized parameters by using Orthogonal Array Table Method is proposed and used to solve the Travelling Salesman Problem (TSP) for 30, 31 and 300 cities and Map-coloring Problem (MCP). These results are very satisfactory.

A coherent communication system using squeezed light is one of candidates for a realization of super-reliable systems. In order to design such a system, it is essential to understand and to analyze modulators mathematically. However, quantum noise of squeezed light has a colored spectrum which changes with respect to phase of a local laser. Therefore the optimization of the relationship between signal and quantum noise spectrums is required at a modulator to obtain the ultimate performance of the communication system. In this paper, some ideas of modulators for squeezed light are proposed and their spectrum transformations are given. After the brief summary of squeezed quantum noise, a new concept which originates from the restriction of the local laser phase is applied to it. This concept makes a problem originated from a colored quantum noise spectrum more serious. It results in the optimization problem for the relationship between the quantum noise spectrum and signal power spectrum. The solution of this problem is also given under the restriction of local laser phase. As a result, a general design theory for coherent communication system using the squeezed light is given.

This paper presents a technique by which any linear CCD camera, be it one with lens distortions, or even one with misaligned lens and CCD, may be calibrated to obtain optimum performance characteristics. The camera-image formation model is described as a polynomial expression, which provides the line-of-sight flat-beam, including the target light-spot. The coefficients of the expression, which are referred to as camera parameters, can be estimated using the linear least-squares technique, in order to minimize the discrepancy between the reference points and the model-driven flat-beam. This technique requires, however, that a rough estimate of camera orientation, as well as a number of reference points, are provided. Experiments employing both computer simulations and actual CCD equipment certified that the model proposed can accurately describe the system, and that the parameter estimation is robust against noise.

The matrix whose eigenvectors are the basis vectors of the DCT is introduced. This matrix leads to a convolution-product property using the DCT. Based on the property, the parameter of uniform blur, such as motion blur or out-of-focus blur, is estimated from the local minima of the DCT energy spectrum of a blurred image. Computer experiments confirmed that the DCT is superior to the DFT for estimating the parameter.

This letter proposes an LSP quantizing method which uses interframe correlation of the parameters. The quantized parameters are represented as a moving average of code vectors. Using this method, LSP parameters are quantized efficiently and the degradation of decoded parameters caused by bit errors affects only a few following frames.

A new transfer mode and a switching architecture which can support loss free and no delay jitter service class with shorter switching delay compared with "stop and go queueing scheme" is proposed. This scheme combines ATM scheme with hierarchical STM framing concept.

In our recent work, a forward test generation method for sequential circuits by using a single time frame was proposed. In order to improve the effectiveness of the method, we introduced an extended mode which can handle the two time frames for a hard-to-test fault and a state escaping phase which can detect a sequence of unsuitable states for test generation. The experimental results show that the improved method is effective in generating higher coverage tests with a small number of tests.

Behavior of solutions related to an accuracy exp(-1/ε) is studied. Computer results are given, and examined from the view-point of non-standard analysis. The experimental results raise some important questions on the computer study of slow-fast systems.

This letter extends the overfitting lattice filter for ARMA parameter estimation with additive noise proposed by Sun and Yahagi. A new way of calculating the lattice parameters is proposed, making their computation truly recursive. This simplifies the method in Ref.(1), and makes it suitable to the parameter estimation of high-order systems.

Some problems in formal language theory are considered and are shown to be deterministic exponential time complete. They include the problems for a given context-free grammar G, a nondeterministic finite automaton M, a deterministic pushdown automaton MD, of determining whether L(G)L(M), and whether L(MD)L(M). Polynomial time reductions are presented from the pebble game problem, known to be deterministic exponential time complete, to each of these problems.

In this paper, a methodology for designing the architecture of the processor array for wide class of image processing algorithms is proposed. A concept of spatially expanding the SFG description which enables us to handle the problem as merely one-dimensional signal processing is used in constructing the methodology. Problem of I/O interface which is critical in real-time processing is also considered.

In this paper, four simple nonlinear circuits with time-varying resistors are analyzed. These circuits consist of only four elements; a inductor, a capacitor, a diode and a time-varying resistor and are a kind of parametric excitation circuits whose dissipation factors vary with time. In order to analyze chaotic phenomena observed from these circuits a degeneration technique is used, that is, diodes in the circuits are assumed to operate as ideal switches. Thereby the Poincar maps are derived as one-dimensional maps and chaotic phenomena are well explained. Moreover, validity of the analyzing method is confirmed theoretically and experimentally.

An adaptive restoration algorithm is developed for binary images degraded nonadditively with flip noises. The true image is assumed to be a realization of a Markov Random Field (MRF) and the nonadditive flip noises are assumed to be statistically independent and asymmetric. Using the Expectation and Maximization (EM) method and approximating the Baum's auxiliary function, the degraded image is restored iteratively. The algorithm is implemented as follows. First, the unknown parameters and the true image are guessed or estimated roughly. Second, using the true image estimate, the Baum's auxiliary function is approximated and then the noise and MRF parameters are reestimated. To reestimate the MRF parameters the Maximum Pseudo-likelihood (MPL) method is used. Third, using the Iterated Conditional Modes (ICM) method, the true image is reestimated. The second and third steps are carried out iteratively until by some ad hoc criterion a critical point of EM algorithm is approximated. A number of simulation examples are presented which show the effectiveness of the algorithm and the parameter estimation procedures.

In this paper, optimal static load balancing in a tree hierarchy network that consists of a set of heterogeneous host computers is considered. It is formulated as a nonlinear optimization problem. We study the effects of the link communication time on the optimal link flow rate (i.e., the rate at which a node forwards jobs to other nodes for remote processing), the optimal node load (i.e., the rate at which jobs are processed at a node), and the optimal mean response time, by parametric analysis. We show that the entire network can be divided into several independent sub-tree networks with respect to the link flow rates and node loads. We find that the communication time of a link has the effects only on the link flow rates and the loads on nodes that are in the same sub-tree network. The increase in the communication time of a link causes the decrease in the link flow rates of its descendant nodes, its ancestor nodes and itself, but causes the increase in the link flow rates of other nodes in the same sub-tree network. It also causes the increase in the loads of its descendant nodes and itself, but causes the decrease in the loads of other nodes in the same sub-tree network. In general, it causes the increase in the mean response time.