Hiromasa HABUCHI Takaaki HASEGAWA
Recently, there has been increasing interest in Code Division Multiplex (CDM) systems. We reported the CDM system using the -chip shift multiplex operation. So far the performance of this system evaluated under the optimum . In this letter, we evaluate an influence of the phase difference between the groups on BER performance in 2M-plex system.
Carlos VALDEZ Hiroyuki FUJIWARA Ikuo OKA Hirosuke YAMAMOTO
The performance evaluation by analysis of systems employing Reduced State Viterbi decoding is addressed. This type of decoding is characterized by an inherent error propagation effect, which yields a difficulty in the error probability analysis, and has been usually neglected in the literature. By modifying the Full State trellis diagram, we derive for Reduced State schemes, new transfer function bounds with the effects of error propagation. Both the Chernoff and the tight upper bound are applied to the transfer function in order to obtain the bit error probability upper bound. Furthermore, and in order to get a tighter bound for Reduced State decoding schemes with parallel transitions, the pairwise probability of the two sequences involved in an error event is upper bounded, and then the branch metric of a sequence taken from that bound is associated with a truncated instead of complete Gaussian noise probability density function. To support the analysis, particular assessment is done for a Trellis Coded Modulation scheme.
This paper proposes a second order auto-regressive equation with discrete-valued random coefficients. The auto-regressive equation transforms an independent stochastic sequence into a binary sequence, which is a special case of a stationary Markov chain. The power spectrum, correlation function and the transition probability are explicitly obtained in terms of the random coefficients. Some computer results are illustrated in figures.
This paper presents newly developed very small MMIC bandpass filters along with novel positive and negative feedback techniques. In order to maintain the expected Q factor without unwanted oscillations in the positive feedback loop, the unity-coupler principle is proposed to stabilize the constituent amplifier. A prototype bandpass filter is monolithically integrated in a very small area of only 0.1 mm2 on a GaAs substrate. A sharp factor as high as 5.6/1-30 dB is achieved near the frequency range of 1 GHz. The other technique presented in this paper is to achieve the bandpass function without using any positive feedback. This is negative feedback consisting of feedback elements with the unique variable transfer function of b/(1as). A variable bandpass filter based on this design concept is also fabricated in a 1.21.3 mm2 area on a GaAs substrate. It has both a varactor and varistor integrated in the circuit, resulting in an independently controllable center frequency and Q factor. It is shown experimentally that the Q factor is controllable over a remarkable range of 20 to 400 and the center frequency is broader than 100 MHz at the 1 GHz band. By cascading two of the fabricated MMIC chips, a forth-order frequency response is successfully obtained along with a 35-40 dB forward gain and an in-band gain flatness of 0.35 dB.
Tadao NAKAGAWA Tetsuo HIROTA Takashi OHIRA
A novel sampling comparator circuit is presented for extending the pull-in range of microwave phase-locked oscillators (PLOs). It performs both phase and frequency detection without any frequency dividers, and a GaAs MMIC prototype is developed and tested. The proposed comparator improves the pull-in range by about 10 times more than is possible with conventional sampling phase detectors.
Youhei ISHIKAWA Sadao YAMASHITA Seiji HIDAKA
An active feedback resonator (AFR) is a kind of circuit which functions as a high unloaded Q resonator. The AFR employs an active feedback loop which compensates for the energy loss of a conventional microwave resonator. Owing to an active element in the AFR, thermal noise should be taken into account when designing the AFR. In order to simplify a circuit design using the AFR we introduced noise temperature (Tn) for the AFR. In addition, we describe the AFR design which gives minimum noise temperature. Finally, the noise temperature, measured in an AFR as a band elimination filter, is compared with the theoretical value to evaluate the AFR.
Tosiro KOGA Masaharu SHINAGAWA Satoshi HASAKO
As is well known, Li
Tatsuya KABASAWA Toshiyuki WATANABE Masakazu SENGOKU Yoshio YAMAGUCHI Shoji SHINODA Takeo ABE
In a cellular system for mobile communications, every service area is divided into a number of cells for utilizing the frequency spectrum efficiently. Service areas for such systems are two dimensional, however, the analysis of the characteristics of the communication traffic for the areas are quite complicated, since the motion of the vehicles in the area can not be predicted precisely. For making the analysis easily, the areas are assumed to be band-shaped like a highway. Furthermore, in the analysis, the traffic offered to a cell is assumed to be stationary. In actual systems, the density of vehicles and the offered communication traffic is not stationary, so that many differences exist between the analysis and the actual systems. This paper presents an analysis method using state equations. The equations represent the transient characteristics of mobile communication traffic when a band-shaped service area is assumed. The transition is made by accidents or congestion, and causes the rapid offered traffic change in a communication system. In the method, numerical analysis is made under the consideration of "handoff" operation. The operation consists of surrendering the channel used in the previous cell and reassigning a new channel when the vehicle crosses the cell boundary. The analytical results are compared with the simulations, and the two results show good agreement. The method presented in this paper can be used for designing the switching system when the offered traffic changes rapidly due to accidents or congestion.
Kiyotaka YAMAMURA Shin'ichi OISHI Kazuo HORIUCHI
Algorithms for computing channel capacity have been proposed by many researchers. Recently, one of the authors proposed an efficient algorithm using Newton's method. Since this algorithm has local quadratic convergence, it is advantageous when we want to obtain a numerical solution with high accuracy. In this letter, it is shown that this algorithm can be extended to the algorithm for computing the constrained capacity, i.e., the capacity of discrete memoryless channels with linear constraints. The global convergence of the extended algorithm is proved, and its effectiveness is verified by numerical examples.
Hiroyuki YABUKI Morikazu SAGAWA Mitsuo MAKIMOTO
This paper describes the fundamental principle of novel push-push oscillators using hairpin-shaped split-ring resonators and their application to voltage controlled and injection locked oscillators for frequency synthesizers. The experimental results make it clear that the synthesizer systems discussed here have the advantages of high frequency operation, compact size and low power consumption. Experimental work has been carried out in the L band, but these systems can be applied to much higher frequencies.
Zouheir TRABELSI Yoshiyuki KOTANI Nobuo TAKIGUCHI Hirohiko NISHIMURA
In using a natural language database interface (NLI) to access the contents of a databese, the user queries may contain terms that do not appear at all in both the NLI lexicon and the database. A friendly NLI should not reject user queries with unknown terms, but should be able to handle them, and should be able to learn new lexical items. Such capability increases the usefulness of the NLI, and allows the NLI to more cover the domain of the underlying database. Therefore, a technique to handle unknown terms is decisive in designing a friendly NLI. In this work, we discuss a method that would allow a NLI to identify the meanings of unknown database field values, and terms that are exceeding the conceptual coverage of the database, in the user queries, by engaging the user in clarification dialogues based on a database-domain hierarchy. It will be shown that the method enables the NLI lexicon to learn new lexical items at run time while the clarification dialogues, and it may provide the necessary information for generating informative answers to some particular failing user queries. Moreover, the method is an efficient means to handle queries with insufficience contextual cues. The examples throughout this work are drawn from FIFA 90, an experimental NLI to a soccer database.
Takahiro HANYU Sungkun CHOI Michitaka KANEYAMA Tatsuo HIGUCHI
This paper presents a new high-speed three-dimensional (3-D) object recognition system based on two-dimensional (2-D) chain code matching. An observed 3-D object is precisely represented by a 2-D chain code sequence from the discrete surface points of the 3-D object, so that any complex objects can be recognized precisely. Moreover, the normalization procedures such as translation, rotation of 3-D objects except scale changes can be performed systematically and regularly regardless of the complexity of the shape of 3-D objects, because almost all the normalization procedures of 3-D objects are included in the 2-D chain code matching procedure. As a result, the additional normalization procedure become only the processing time for scale changes which can be performed easily by normalizing the length of the chain code sequence. In addition, the fast fourier transformation (FFT) is applicable to 2-D chain code matching which calculates cross correlation between an input object and a reference model, so that very fast recognition is performed. In fact, it is demonstrated that the total recognition time of a 3-D ofject is estimated at 5.35 (sec) using the 28.5-MIPS SPARC workstation.
This paper deals with the uniqueness of a solution of the basic equation obtained from the analysis of resistive circuits including ideal diodes. The equation in consideration is of the type of (A-)X=b, where A is a constant matrix, b a constant vector, X an unknown vector satisfying X 0, and a diagonal matrix whose diagonal elements take the value 0 or 1 arbitrarily. The necessary and sufficient conditions for the equation to have a unique solution X 0 for an arbitrary vector b are shown. Some numerical examples are given for the illustration of the result.
This paper describes new methematical tools, taken from quantum field theory (QFT), which may make it possible to characterize localized excitations (including solitons, but also including chaotic modes) generated by PDE systems. The significance to computer hardware and neurocomputing is also discussed. This mathematics--IF further developed--may also have the potential to reorganize and simplify our understanding of QFT itself--a topic of very great intellectual and practical importance. The paper concludes by describing three new possibilities for research, which will be very important to achieving these goals.
A group-based random access communication system which consists of two groups of many users is considered. The two different groups share a common random multiple access channel. Users from a group are allocated a high transmitting power level and have a high probability of correct reception among overlapping packets. We set a threshold, θ, which is such that the group with the high power level will occupy the channel if less than or equal to θ packets are transmitted from the group with the low power level. We obtain a two-dimensional Markovian model by tracing the number of backlogged users in the two groups. The two-dimensional Markov chain is shown to be not ergodic and thus the system is not stable. A two-dimensional retransmission algorithm is developed to stabilize the system and the retransmission control parameters are chosen so as to maximize the channel throughput. An equilibrium point analysis is performed by studying the drift functions of the system backlog and it is shown that there is a unique global equilibrium point. The channel capacity for the system is found to be in the range from 0.47 up to 0.53, which is a remarkable increase compared to the conventional slotted ALOHA system.
This paper proposes a self frequency preset (SFP) PLL synthesizer to realize a simple frequency preset PLL synthesizer with temperature-resistant and shorter frequency settling time than the conventional temperature un-compensated phase and frequency preset (PFP) PLL synthesizer. Since the proposed synthesizer employs a simple frequency locked loop (FLL) circuit to preset the output frequency at each frequency hopping period, the synthesizer eliminates the need to store f-V characteristic of the VCO in ROM. The frequency settling time of the proposed synthesizer is theoretically and experimentally analyzed. The theoretical analysis using the realistic f-V characteristic of a IF band VCO show that the frequency settling time of the proposed synthesizer is 130µs shorter than that of the conventional PFP PLL synthesizer at 40MHz hopping in the 200MHz band for all temperatures. Furthermore, the experimental results confirm that the frequency acquisition time of a prototype FLL circuit is accordant with the calculated results. Thus, the proposed SFP PLL synthesizer can achieve faster frequency settling than the conventional PFP PLL synthesizer for all temperatures and its simple configuration allows to be easily implemented with existing CMOS ASIC devices.
Novel circuit design techniques for bipolar and MOS four-quadrant analog multipliers operable on low supply voltage are described. There are three design techniques for multipliers operable on low supply voltage. One is the transistor-size unbalance technique. Another is the bias offset technique. A third is the multitail technique. Bipolar and MOS four-quadrant analog multipliers proposed in this paper consist of transistor-pairs with different transistor sizes (i.e. emitter areas or gate W/L values are different), transistor-pairs with the same bias offset or multitail cells (i.e. quadritail cells and an octotail cell). Several kinds of squaring circuits consisting of such transistor-pairs are applied to the multipliers when the multiplication method is based on the quarter-square technique. These multipliers all have satisfiable multiplication characteristics with four-quadrant operations in analog signal processing, whether implemented in bipolar technology or implemented in MOS technology.
Akira INOUE Masahide KASHIWAGI Shin'ichi OISHI Mitsunori MAKINO
In this paper, we are concerned with a problem of obtaining an approximate solution of a finite-dimensional nonlinear equation with guaranteed accuracy. Assuming that an approximate solution of a nonlinear equation is already calculated by a certain numerical method, we present computable conditions to validate whether there exists an exact solution in a neighborhood of this approximate solution or not. In order to check such conditions by computers, we present a method using rational arithmetic. In this method, both the effects of the truncation errors and the rounding errors of numerical computation are taken into consideration. Moreover, based on rational arithmetic we propose a new modified Newton interation to obtain an improved approximate solution with desired accuracy.
Takatoshi SUGIYAMA Hiroshi KAZAMA Masahiro MORIKURA Shuji KUBOTA Shuzo KATO
This paper proposes a superposed SSMA (Spread Spectrum Multiple Access)-QPSK (Quadrature Phase Shift Keying) signal transmission scheme over high speed QPSK signals to achieve higher frequency utilization efficiency and to facilitate lower power transmitters for SSMA-QPSK signal transmission. Experimental results show that the proposed scheme which employs the coding-rate of one-half FEC (Forward Error Correction) and a newly proposed co-channel interference cancellation scheme for SSMA-QPSK signals can transmit twenty SSMA-QPSK channels simultaneously over a nonlinearly amplified high speed QPSK signal transmission channel and achieve as ten times SSMA channels transmission as that without co-channel interference cancellation when the SSMA-QPSK signal power to the high speed QPSK signal power ratio equals -30dB. Moreover, cancellation feasibility generation of the interference signals replica through practical hardware implementation is clarified.
BiCMOS circuit performance at low supply voltages is discussed. The basic advantages of BiCMOS circuits are briefly reviewed, and then actual advantages of the BiCMOS gate and the BiCMOS sense circuits, which are typical BiCMOS circuits, are explained. Their advantages at low supply voltages are also discussed. BiCMOS gates, BiCMOS sense circuits, and combined circuits that include a BiCMOS sense circuit are two or three times faster than CMOS circuits down to a supply voltage of 2 V. BiCMOS circuits have high performance even at low supply voltages such as 2 V.