A Power on Reset signal generation circuit referencing threshold voltage without standby current consumption has been proposed. The POR signal is generated when supply voltage is larger than the sum of threshold voltages of N- and P-MOSFET.

This paper discusses stability boundaries in an electric power system with dc transmission based on a differential-algebraic equation (DAE) system. The DAE system is derived to analyze transient stability of the ac/dc power system: the differential equation represents the dynamics of the generator and the dc transmission, and the algebraic equation the active and reactive power relationship between the ac system and the dc transmission. In this paper complete characterization of stability boundaries of stable equilibrium points in the DAE system is derived based on an energy function for the associated singularly perturbed (SP) system. The obtained result completely describes global structures of the stability boundaries in solution space of the DAE system. In addition the characterization is confirmed via several numerical results with a stability boundary.

The chaotic property of a new open addressing hash function, called exponential hashing, is presented. Our analysis indicates the connection between ergodic theory and hashing. Based on that, concepts from ergodic theory are applied to predict the performance of exponential hashing. Experimental results are presented to verify our theoretic analysis and the prediction.

This paper presents a simplified maximum likelihood detection (MLD) scheme for multiple-input and multiple-output spatial division multiplexing (MIMO-SDM) systems. In the scheme, ordered successive detection (OSD) is applied to multiple symbol candidates retained in the preceding stage to limit the number of symbol vector candidates. Accordingly, the subsequent MLD searches for the most likely signal vector among the limited symbol-vector candidates. Simulation results demonstrated that the proposed scheme provides the bit error rate performance close to that achieved by MLD while reducing the computational complexity.

This paper proposes the joint beamforming space-time block coding (JBSTBC) scheme for multi-input multi-output (MIMO) communication systems. To enhance the order of spatial diversity in presence of deteriorate fading correlations as well as inter-substream interferences, the proposed JBSTBC method employs joint eigen-beamforming technique together with the block-ordered layered detector (BOLD) for MIMO-STBC. In order to confirm the superiority of the proposed JBSTBC method, computer simulations are conducted in highly correlated fading situations while providing detailed mathematical derivations for clarifying functionality of the proposed scheme.

Classical designs of maximally flat finite impulse response digital filters need to perform inverse discrete Fourier transformation of the frequency responses, in order to calculate the impulse response coefficients. Several attempts have been made to simplify the designs by obtaining explicit formulas for the impulse response coefficients. Such formulas have been derived for digital differentiators having maximal linearity at zero frequency, using different techniques including interpolating polynomials and the Taylor series etc. We show that these formulas can be obtained directly by application of maximal linearity constraints on the frequency response. The design problem is formulated as a system of linear equations, which can be solved to achieve maximal linearity at an arbitrary frequency. Certain special characteristics of the determinant of the coefficients matrix of these equations are explored for designs centered at zero frequency, and are used in derivation of explicit formulas for the impulse response coefficients of digital differentiators of both odd and even lengths.

The issue of guaranteeing Quality of Services (QoS) in a network has emerged in recent years. The Proportional Delay Differentiated Model has been presented to provide the predictable and controllable queueing delay differentiation for different classes of connections. However, most related works have focused on providing this model for a wired network. This study proposes a novel scheduler to provide proportional delay differentiation in a wireless network that includes a multi-state link. This scheduler, Look-ahead Waiting-Time Priority (LWTP), offers proportional delay differentiation and a low queueing delay, by adapting to the location-dependent capacity of the wireless link and solving the head-of-line (HOL) blocking problem. The simulation results demonstrate that the LWTP scheduler actually achieves delay ratios much closer to the target delay proportion between classes and yields smaller queueing delays than past schedulers.

This paper proposes a learning classifier based on Support Vector Domain Description (SVDD) for two-class problem. First, by the description of the training samples from one class, a sphere boundary containing these samples is obtained; then, this boundary is used to classify the test samples. In addition, instead of the traditional quadratic programming, multiplicative updates is used to solve the Lagrange multiplier in optimizing the solution of the sphere boundary. The experiment on CBCL face database illustrates the effectiveness of this learning algorithm in comparison with Support Vector Machine (SVM) and Sequential Minimal Optimization (SMO).

The DAPDNA®-2 is the world's first general purpose dynamically reconfigurable processor for commercial usage. It is a dual-core processor consisting of a custom RISC core called the Digital Application Processor (DAP), and a two dimensional array of dynamically reconfigurable processing elements referred to as the Distributed Network Architecture (DNA). The DAP has a 32 bit instruction set architecture with an 8 KB instruction cache and 8 KB data cache that can be accessed in one clock cycle. It has an interrupt control function to detect data processing completion in the DNA-Matrix. The DNA-Matrix has different types of data processing elements such as ALU, delay, and memory elements to process fully parallel computations. The DNA-Matrix includes 32 independent 16 KB high speed SRAM elements (in total 512 KB). The DNA-Matrix, even with its parallel computational capability, can be synchronized and co-work at the same clock frequency as the DAP. The processor operates at a 166 MHz working frequency and fabricated with a 0.11 µm CMOS process. The DAPDNA-2 device can be connected directly with up to 16 units with linear scalability in processing performance, provided the bandwidth requirement is within the maximum communication speed between DNAs, which is 32 Gbps. The DAPDNA-2 performs at a level that is two orders of magnitude higher than conventional high performance processors.

Computer simulation of cellular process is one of the most important applications in bioinformatics. Since such simulators need huge computational resources, many biologists must use expensive PC/WS clusters. ReCSiP is an FPGA-based, reconfigurable accelerator which aims to realize economical high-performance simulation environment on desktop computers. It can exploit fine-grain parallelism in the target applications by small hardware modules in the FPGA which work in parallel manner. As the first step to implement a simulator of cellular process on ReCSiP, a solver to perform a basic simulation of metabolism was implemented. The throughput of the solver was about 29 times faster than the software on Intel's PentiumIII operating at 1.13 GHz.

Subgraph isomorphism problems have various important applications, while generally being NP-complete. Though Ullmann and Konishi proposed the custom circuit designs to accelerate subgraph isomorphism problem, they require many hardware resources for large problems. This study describes the design of data-dependent circuits for subgraph isomorphism problem with evaluation results on an actual FPGA platform. Data-dependent circuits are logic circuits specialized in specific input data. Such circuits are smaller and faster than the original circuit, although it is not reusable and involves circuit generation for each input. In the present study, the circuits were implemented on Xilinx XC2V3000 FPGA, and they successfully operated at a clock frequency 25 MHz. In the case of graphs with 16 vertices, the average execution time is about 7.0% of the software executed on an up-to-date microprocessor (Athlon XP 2600+ of 2.1 GHz clock). Even if the circuit generation time is included, data-dependent circuits are about 14.4 times faster than the software (for random graphs with 16 vertices). This performance advantage becomes larger for larger graphs. Two algorithms (Ullmann's and Konishi's) were examined, and the data-dependent approach was found to be equally effective for both algorithms. We also examined two types of input graph sets, and found that the data-dependent approach shows advantage in both cases.

Multi-Input Multi-Output (MIMO) systems, which utilize multiple antennas at both the receiver and transmitter, promise very high data rates in a rich scattering environment. It was proven in literature that with optimal power allocation, MIMO eigenmode transmission system (EMTS) is optimal because MIMO capacity is maximized. However, the performance of MIMO EMTS is very sensitive to the accuracy of channel state information and thus it is of practical importance to analyze its performance when channel state information is corrupted under realistic system and propagation conditions. In this paper, we lower bound the mutual information of MIMO EMTS with imperfect channel estimation and delayed quantized feedback in a spatially correlated continuous fading channel. Our results showed that this lower bound is tight and can serve as a comprehensive guide to the actual performance of MIMO EMTS under practical operating conditions.

Performance of selective Rake (SRake) receiver is evaluated for direct sequence ultra wideband (DS-UWB) communications considering an independent Rayleigh channel having exponentially decaying power delay profile (PDP). BEP performances are shown. The results obtained are compared with similar results in a channel having flat PDP. Assumption of a flat PDP is found to predict the optimum spreading bandwidth to be lower and sub-optimum operating performance beyond optimum spreading bandwidth to be severely worse than that is achievable in a channel having exponentially decaying PDP by employing an SRake receiver having fixed number of combined paths. Optimum spreading bandwidth for SRake in a channel having exponentially decaying PDP is shown to be much larger than the one in a channel having flat PDP; that is specifically a good-news for UWB communications. Effects of partial band interference are also investigated. Interference is found to be less effective in exponentially decaying PDP.

Differentiated Services architecture provides a framework that enables relative differentiation of Assured Forwarding (AF) service. The differentiation is quantified by QoS parameters in terms of loss probability and maximum delay. We develop herein an efficient model to compute resource allocation in terms of buffer and service rate that satisfies the QoS differentiation between classes of service. To evaluate the performance of the proposed model, we conducted extensive simulation on both single-node and multi-node cases. The simulation studies show that the model can provide an efficient method to allocate network resources for aggregated traffic.

There have been many researches on providing mobility under mobile/wireless environment. However, previous researches had several problems as disruption and unnecessary traffic. Disruption happens when messages are exchanged between nodes as registration is made after handoff, and unnecessary traffic occurs because of the use of Random-walk model, in which the probability for MN to move to the neighboring cells is equal. In order to solve these problems, this study proposes a technique and algorithm for composing Directional Shadow Registration Region (DSRR) that provides seamless mobility. The core of DSRR is to prevent disruption and unnecessary traffic by shadow registration at neighboring cells with a high probability of handoff (AAAF). We are introduced a cell division scheme and decided minimal DSRR. DSRR can sensed the optimal time for handoff through Regional Cell Division and applied Direction Vector (DV) obtained through Directional Cell Sectoring. According to the result of the experiment, the proposed DSRR processes message exchange between nodes within the intra-domain, the frequency of disruptions decreased significantly compared to that in previous researches held in inter-domain environment. In addition, traffic that occurs at every handoff happened twice in DSRR compared to n (the number of neighboring cells) times in previous researches.

In policy-based management, in addition to deliver and enforce policies in managed systems, it is inevitable to manage the policy life-cycle. We mean the policy life-cycle as cyclic iteration of processes involving monitoring to see if the enforced policies actually work at operators' will and their adaptation based on monitoring. Enabling such policy life-cycle management by the current centralized management paradigm such as SNMP may, however, result in poor scalability and reliability. This is typically due to much bandwidth consumption for monitoring and communication failure between a management system and a managed system. It may also impose a heavy burden on the operators in analyzing management information for the policy adaptation. For a solution to that, we propose a scalable and reliable policy-based management scheme enabling the policy life-cycle management based on distributed management paradigm. In the scheme, we provide a new management script describing policies and how their life-cycle should be managed, and execute the script on the managed system with enough computation resources. The scheme can make the current policy-based management more scalable by reducing management traffic, more reliable by distributing management tasks to the managed systems, and more promising by relieving of the operators' burden. We implement a prototype system based on the scheme taking Differentiated Services as a policy enforcement mechanism, and evaluate the scheme from the following viewpoints: 1) the reliability, 2) relievability, and 3) scalability. The first two will be shown with a policy adaptation scenario in an operational network. The last one will be investigated in terms of the management traffic reduction by a management script, the management traffic required for the management of a management script, and the load on a managed system to execute management scripts. As deployment consideration of the proposed scheme besides technical aspects, we also discuss how the prototype system could be integrated with managed systems compliant to the standards emerging in the marketplace.

A compact low-voltage CMOS exponential current-to-voltage converter free from transconductance parameter matching between NMOS and PMOS is proposed. The circuit is composed of level shift circuits and current mirrors. The SPICE simulation results show a 27 dB linear range with a linearity error of less than 1 dB.

Structural learning algorithms are obtained by adding a penalty criterion (usually comes from the network structure) to the conventional criterion of the sum of squared errors and applying the backpropagation (BP) algorithm. This problem can be viewed as a constrained minimization problem. In this paper, we apply the Lagrangian differential gradient method to the structural learning based on the backpropagation-like algorithm. Computational experiments for both artificial and real data show that the improvement of generalization performance and the network optimization are obtained applying the proposed method.

Sequential estimation of arrival angles allows us to resolve closely located sources that the standard MUSIC fails to do so. A new sequential estimation method is proposed which utilizes only the signal subspace components of the steering vectors for some estimates of the arrival angles. It is theoretically shown that the asymptotic performance of the proposed method is better than that of the conventional sequential method which exploits both the signal and the noise subspace components. Simulation results show that the former outperforms the latter in correlated sources as well as in uncorrelated sources.

We propose a new method to recover scene points from a single calibrated view using a subset of distances among the points. This paper first introduces the problem and its relationship with the perspective n point problem. Then the number of distances required to uniquely recover scene points are explored. The result is then developed into a practical vision algorithm to calculate the initial points' coordinates using distance constraints. Finally SQP (Sequential Quadratic Programming) is used to optimize the initial estimations. It can minimize a cost function defined as the sum of squared reprojection errors while keeping the specified distance constraints strictly satisfied. Both simulation data and real scene images have been used to test the proposed method, and good results have been obtained.