A fast, low-power 16-bit adder, 32-word register file and 512-bit cache SRAM have been developed using 0.25-µm GaAs HEMT technology for future multi-GHz processors. The 16-bit adder, which uses a negative logic binary look-ahead carry structure based on NOR gates, operates at the maximum clock frequency of 1.67 GHz and consumes 134.4 mW at a supply voltage of 0.6 V. The active area is 1.6 mm2 and there are about 1,230 FETs. A new DC/DC level converter has been developed for use in high-speed, low-power storage circuits such as SRAMs and register files. The level converter can increase the DC voltage, which is supplied to an active-load circuit on request, or supply a minimal DC voltage to a load circuit in the stand-by mode. The power dissipation (P) of the 32-word register file with on-chip DC/DC level converters is 459 mW, a reduction to 25.2% of that of an equivalent conventional register file, while the operating frequency (fc) was 5.17 GHz that is 74.8% of fc for the conventional register file. P for the 512-bit cache SRAM with the new DC/DC level converters is 34.3 mW, 89.7% of the value for an equivalent conventional cache SRAM, with the read-access time of 455 psec, only 1.1% longer than that of the conventional cache SRAM.

A 167-MHz 1-Mbit CMOS synchronous cache SRAM was developed using 0.40-µm process technology. The floor plan was designed so that the address registers are located in the center of the chip, and high-speed circuits were developed such as the quasi latch (QL) sense amplifier and the one-shot control (OSC) output register. To maintain suitable setup and hold time margins, an equivalent margin (EM) design method was developed. 167-MHz operation was measured at a supply voltage of 2.5 V and an ambient temperature of 75. The same margins 1.1 ns of the setup time and hold time were measured for the specifications of a setup time of 2.0 ns and a hold time of 0.5 ns.