Combining transmission of ultra wideband pulses, organized in blocks, with the inclusion of cyclic prefixing pulses yields a pulsewidth periodic signal at the receiver. Although unknown, this signal fits perfectly the diversity exploitive architecture of a RAKE receiver. Aiming to profit from this signal arrangement, we propose a pulse shape modulation system employing a RAKE receiver that estimates this periodic signal during a training interval and uses the estimated values for detection of data symbols. Our proposal relies on the invariability of the multipath propagation channel during the transmission of a UWB packet, the adequate application of the cyclic prefix, and the fact that different transmitted pulses result in different periodic signals at the receiver. This system is equivalent to transforming the multipath nature of the UWB propagation channel into a multichannel digital communications affected solely by additive noise. Our proposal is important because it ameliorates the performance of a pulse shape modulation RAKE receiver. On the other hand, the cost of our proposed system resides in the inefficiencies product of the cyclic prefix inclusion.

Transmit diversity systems based on orthogonal space-time block coding (OSTBC) usually suffer from rate loss and power spreading. Proper antenna selection scheme can help to more effectively utilize the transmit antennas and transmission power in such systems. In this paper, we propose a new antenna selection scheme for such systems based on the idea of antenna switching. In particular, targeting at reducing the number of pilot channels and RF chains, the transmitter now replaces the antennas with the lowest received SNR with unused ones if the output SNR of space time decoder at the receiver is below a certain threshold. With this new scheme, not only the number of pilot channels and RF chains to be implemented is decreased, the average amount of feedback information is also reduced. To analyze the performance of this scheme, we derive the exact integral closed form for the probability density function (PDF) of the received SNR. We show through numerical examples that the proposed scheme offers better performance than traditional OSTBC systems using all available transmitting antennas, with a small amount of feedback information. We also examine the effect of different antenna configuration and feedback delay.

In this paper, we develop a new iterative turbo multiuser detector for direct sequence code-division multiple access (DS-CDMA) systems over unknown frequency-selective channels by decomposing the observation signal into a number of signal components. Virtual trellis model representing the ISI channel for each separating signal user is designed to generate extrinsic probability in term of BCJR algorithm for exchange with a single channel decoder as priori information. Minimum kullback-leibler (MKL) framework is derived to calculate numerical channel estimation and extrinsic probability. In comparison with other similar receiver, simulation results demonstrate that the proposed solution achieves the desirable performance.

Focusing on time correlation of real communication channels, a channel quantization algorithm based on finite state vector quantization (FSVQ) is proposed. Firstly channels are partitioned into finite states, then codebooks corresponding to each state are constructed, which are used to quantize channels transferred from corresponding states. Further, the state transition function is designed to ensure the synchronization between transmitter and receiver. The proposed algorithm can achieve improved performance with the same feedback load compared with classical memoryless channel quantizer without consideration of the influence of time correlation. Simulation results verify the effectiveness of the proposed algorithm.

This letter proposes a UWB signaling localization scheme for indoor multipath channel. It demonstrates that the proposed method does not require LOS path (LP) and is suitable for severe non line-of-sight (NLOS) condition. A low-complexity TOA estimation algorithm, the strongest path (SP) detection by convolution, is designed, which is easier to implement than the LP detection since it dispenses with the process of threshold setting. Experiments under NLOS channels in IEEE.802.15.4a are conducted and the localization influences due to the algorithm parameters are discussed. The results prove the feasibility of the proposed localization scheme under the indoor multipath NLOS environment.

In the present paper, the use of a combination of channel-bonding and multi-channel techniques is proposed to improve the performance of wireless mesh networks (WMNs). It is necessary to increase the network throughput by broadening the bandwidth, and two approaches to effectively utilize the broadened bandwidth can be considered. One is the multi-channel technique, in which multiple separate frequency channels are used simultaneously for information transmission. The other is the channel-bonding technique used in IEEE 802.11n, which joins multiple frequency channels into a single broader channel. The former can reduce the channel traffic to mitigate the effect of packet collision, while the latter can increase the transmission rate. In the present paper, these two approaches are compared and their respective advantages are clarified in terms of the network throughput and delay performance assuming the same total bandwidth and a CSMA protocol. Our numerical and simulation results indicate that under low-traffic conditions, the channel-bonding technique can achieve low delay, while under traffic congestion conditions, the network performance can be improved by using multi-channel technique. Based on this result, the use of a combination of these two techniques is proposed for a WMN, and show that it is better to use a proper channel technique according to the network traffic condition. The findings of the present study also contribute to improving the performance of a multimedia network, which consists of different traffic types of applications.

This paper proposes a novel channel estimation method for iterative equalization in MIMO systems. The proposed method incorporates co-channel interference (CCI) cancellation in the channel estimator and the channel estimation is successively performed with respect to each stream. Accuracy of channel estimation holds the key to be successfully converged the iterative equalization and decoding process. Although the channel estimates can be re-estimated by means of LS (Least Square) channel estimation using tentative decisions obtained in the iterative process, its performance is severely limited in a MIMO system because of erroneous decisions and ill-conditioned channel estimation matrix. The proposed method can suppress the above effects by means of CCI cancellation and successive channel estimation. Computer simulation confirms that the proposed channel estimation method can accurately estimate the channel, and the receiver with iterative equalization and the proposed method achieves excellent decoding performance in a MIMO-SM system.

In this paper, we analyze the robustness for low-density parity-check (LDPC) codes over the Gilbert-Elliott (GE) channel. For this purpose we propose a density evolution method for the case where LDPC decoder uses the mismatched parameters for the GE channel. Using this method, we derive the region of tuples of true parameters and mismatched decoding parameters for the GE channel, where the decoding error probability approaches asymptotically to zero.

MIMO (Multiple Input Multiple Output) communications systems equipped with array antennas at both the transmitter and receiver sides are a promising scheme to realize higher rate and/or reliable data transmission. In this paper, capacity analysis of MIMO Rayleigh channel with spatial correlation at the receiver of multipath taken into account is presented. In general, a model configuration of local scattering around a mobile station in MIMO environment is carried out by simulation to examine spatial correlation coefficients. Based on statistical properties of the eigenvalues of correlated complex random Wishart matrices, the exact closed-form expressions of distribution of the eigenvalues are investigated. Then, the general closed-form evaluation of integral form is proposed based on Meijer's G-function. The results demonstrate that the ergodic capacities are improved by increasing the number of the antennas and the SNR's. Compared with i.i.d. (independent identically distributed) Rayleigh channel, the incremental improvement of correlated Rayleigh channel is reduced by spatial fading correlation. The analytical results validated by Monte-Carlo simulations show a good agreement.

Luby et al. derived evolution of degree distributions in residual graphs for irregular LDPC code ensembles. Evolution of degree distributions in residual graphs is important characteristic which is used for finite-length analysis of the expected block and bit error probability over the binary erasure channel. In this paper, we derive detailed evolution of degree distributions in residual graphs for irregular LDPC code ensembles with joint degree distributions.

Motivated by the recent works of coded cooperation this letter presents a composite signal structure based coded cooperation technique. Our proposed protocol performs well in both slow and fast fading whereas, conventional coded cooperation is ineffective in fast fading. We develop the bounds on BER and FER of our proposal. Simulations confirm our developed bound and shows that the proposed coded cooperation protocol outperforms direct transmission in both fast and slow fading environments.

This letter proposes two efficient decision-feedback (DF) detection schemes for space-time block code (STBC) over time-selective fading channels. The existing DF detection causes error propagation when the first symbol is not detected correctly. However, the proposed detection schemes provide two candidates according to a channel gain or an average log-likelihood ratio (LLR) based selection rule and choose a better candidate for the first symbol. Simulation results show that the proposed detection schemes reduce error propagation and yield significant signal-to-noise ratio (SNR) gain with moderate complexity, compared to the existing DF detection scheme.

Based on the expectation-maximization (EM) algorithm, an iterative time-domain channel estimation approach capable of using a priori information is proposed for orthogonal frequency division multiplexing (OFDM) systems in this letter: it outperforms its noniterative counterpart in terms of estimation accuracy as well as bit error rate (BER) performance. Numerical simulations demonstrate that an SNR gain of 1 dB at BER=10-4 with only one iteration and estimation mean square error (MSE) which nearly coincides with the Cramer-Rao bound (CRB) in the low SNR region can be obtained, thanks to the efficient use of a priori information.

Finite impulse response (FIR) filtering is the most computationally intensive operation in the channelizer of a wireless communication receiver. Higher order FIR channel filters are needed in the channelizer to meet the stringent adjacent channel attenuation specifications of wireless communications standards. The computational cost of FIR filters is dominated by the complexity of the coefficient multipliers. Even though many methods for reducing the complexity of filter multipliers have been proposed in literature, these works focused on lower order filters. This paper presents a coefficient-partitioning-based binary subexpression elimination method for realizing low power FIR filters. We show that the FIR filters implemented using proposed method consume less power and achieve speed improvement compared to existing filter implementations. Design examples of the channel filters employed in the Digital Advanced Mobile Phone System (D-AMPS) and Personal Digital Cellular (PDC) receivers show that the proposed method achieved 23% average reductions of full adder and power consumption and 23.3% reduction of delay over the best existing method. Synthesis results show that the proposed method offers average area reduction of 8% and power reduction of 22% over the best known method in literature.

In the next generation mobile communication systems, multiple-input multiple-output (MIMO) multiplexing is an indispensable technique to achieve very high-speed data transmission with a limited bandwidth. In MIMO multiplexing, it is necessary to estimate the channels between transmit and receive antennas for signal detection. In this paper, we propose a minimum mean square error (MMSE) channel estimation using cyclic delay pilot for single-carrier (SC)-MIMO multiplexing. In the proposed channel estimation, the same pilot block is altered through the addition of different cyclic delays and transmitted from different antennas at the same time for simultaneous estimation of all channels between transmit and receive antennas. We evaluate by computer simulation the bit error rate (BER) performance of MIMO multiplexing using the proposed channel estimation and compare it to those using time-multiplexed pilot based channel estimation (TMP-CE) and code-multiplexed pilot based channel estimation (CMP-CE).

In this letter, we propose a simple detection ordering which can be applied to successive interference cancellation in low-complexity equalization of OFDM in doubly selective channels. Since the detection ordering can be determined solely on the basis of pilot symbol arrangement, the proposed scheme can lead to a significant performance improvement without additional complexity on the premise that pilot symbols are employed primarily for channel estimation.

We propose an implementation of the tapped delay line adaptive array (TDLAA) at the base station for improving the BER performance of asynchronous multi-user mobile communication over fast fading channels using multiple antennas. The data of each user at the mobile station, which applies two transmit antennas, are encoded by Space Time Block Code (STBC). The proposed scheme transmits the pilot signal and information data in alternate time slots. We derive performance criteria for designing such a scheme under the assumption that the fading is classified as fast fading. We show that the proposed scheme can suppress co-channel interference (CCI) and defeat Doppler spread effectively.

A binaural hearing assistance system based on the frequency domain binaural model has been previously proposed. The system can enhance a signal coming from a specific direction. Since the system utilizes a binaural signal, an inter-channel communication between left and right subsystems is required. The bit rate reduction in inter-channel communication is essential for the detachment of the headset from the processing system. In this paper, the performance of a system which uses a differential pulse code modulation codec is examined and the relationship between the bit rate and sound quality is discussed.

In this paper, we investigate the performance of maximum ratio combining (MRC) in the presence of multiple cochannel interferences over a flat Rayleigh fading channel. Closed-form expressions of signal-to-interference-plus-noise ratio (SINR), outage probability, and average symbol error rate (SER) of quadrature amplitude modulation (QAM) with M-ary signaling are obtained for unequal-power interference-to-noise ratio (INR). We also provide an upper-bound for the average SER using moment generating function (MGF) of the SINR. Moreover, we quantify the array gain loss between pure MRC (MRC system in the absence of CCI) and MRC system in the presence of CCI. Finally, we verify our analytical results by numerical simulations.

The dynamic channel selection mechanism used in existing multi-channel MAC protocols selects an idle data channel based on channel usage information from one-hop neighbor nodes. However, this method can cause multi-channel hidden node problem in multi-hop wireless networks. This letter proposes a new approach to channel selection. Nodes snoop data channels during idle times and then select an idle data channel within the carrier sensing range using both the snooping results and the channel usage information. Our simulation results verify that the proposed channel selection approach can effectively avoid the multi-channel hidden node problem and improve the networkwide performance.