In this paper, we present an efficient low power scan test technique which simultaneously reduces both average and peak power consumption. The selective scan chain activation scheme removes unnecessary scan chain utilization during the scan shift and capture operations. Statistical scan cell reordering enables efficient scan chain removal. The experimental results demonstrated that the proposed method constantly reduces the average and peak power consumption during scan testing.

In this paper, the scan chain ordering method for BIST-aided scan test for reducing test data and test application time is proposed. In this work, we utilize the simple LFSR without a phase shifter as PRPG and configure scan chains using the compatible set of flip-flops with considering the correlations among flip-flops in an LFSR. The method can reduce the number of inverter codes required for inverting the bits in PRPG patterns that conflict with ATPG patterns. The experimental results for some benchmark circuits are shown to present the feasibility of our test method.

This paper presents a reordering model using a source-side parse-tree for phrase-based statistical machine translation. The proposed model is an extension of IST-ITG (imposing source tree on inversion transduction grammar) constraints. In the proposed method, the target-side word order is obtained by rotating nodes of the source-side parse-tree. We modeled the node rotation, monotone or swap, using word alignments based on a training parallel corpus and source-side parse-trees. The model efficiently suppresses erroneous target word orderings, especially global orderings. Furthermore, the proposed method conducts a probabilistic evaluation of target word reorderings. In English-to-Japanese and English-to-Chinese translation experiments, the proposed method resulted in a 0.49-point improvement (29.31 to 29.80) and a 0.33-point improvement (18.60 to 18.93) in word BLEU-4 compared with IST-ITG constraints, respectively. This indicates the validity of the proposed reordering model.

This paper surveys several state-of-the-art reordering techniques employed in Statistical Machine Translation systems. Reordering is understood as the word-order redistribution of the translated words. In original SMT systems, this different order is only modeled within the limits of translation units. Relying only in the reordering provided by translation units may not be good enough in most language pairs, which might require longer reorderings. Therefore, additional techniques may be deployed to face the reordering challenge. The Statistical Machine Translation community has been very active recently in developing reordering techniques. This paper gives a brief survey and classification of several well-known reordering approaches.

In the current statistical machine translation (SMT), erroneous word reordering is one of the most serious problems. To resolve this problem, many word-reordering constraint techniques have been proposed. Inversion transduction grammar (ITG) is one of these constraints. In ITG constraints, target-side word order is obtained by rotating nodes of the source-side binary tree. In these node rotations, the source binary tree instance is not considered. Therefore, stronger constraints for word reordering can be obtained by imposing further constraints derived from the source tree on the ITG constraints. For example, for the source word sequence { a b c d }, ITG constraints allow a total of twenty-two target word orderings. However, when the source binary tree instance ((a b) (c d)) is given, our proposed "imposing source tree on ITG" (IST-ITG) constraints allow only eight word orderings. The reduction in the number of word-order permutations by our proposed stronger constraints efficiently suppresses erroneous word orderings. In our experiments with IST-ITG using the NIST MT08 English-to-Chinese translation track's data, the proposed method resulted in a 1.8-points improvement in character BLEU-4 (35.2 to 37.0) and a 6.2% lower CER (74.1 to 67.9%) compared with our baseline condition.

Given a sparse linear system, A x = b, we can solve the equivalent system P A PT y = P b, x = PT y, where P is a permutation matrix. It has been known that, for example, when P is the RCMK (Reverse Cuthill-Mckee) ordering permutation, the convergence rate of the Krylov subspace method combined with the ILU-type preconditioner is often enhanced, especially if the matrix A is highly nonsymmetric. In this paper we offer a reordering heuristic for accelerating the solution of large sparse linear systems by the Krylov subspace methods with the ILUT preconditioner. It is the LRB (Line Red/Black) ordering based on the well-known 2-point Red-Black ordering. We show that for some model-like PDE (partial differential equation)s the LRB ordered FDM (Finite Difference Method)/FEM (Finite Element Method) discretization matrices require much less fill-ins in the ILUT factorizations than those of the Natural ordering and the RCMK ordering and hence, produces a more accurate preconditioner, if a high level of fill-in is used. It implies that the LRB ordering could outperform the other two orderings combined with the ILUT preconditioned Krylov subspace method if the level of fill-in is high enough. We compare the performance of our heuristic with that of the RCMK (Reverse Cuthill-McKee) ordering. Our test matrices are obtained from various standard discretizations of two-dimensional and three-dimensional model-like PDEs on structured grids by the FDM or the FEM. We claim that for the resulting matrices the performance of our reordering strategy for the Krylov subspace method combined with the ILUT preconditioner is superior to that of RCMK ordering, when the proper number of fill-in was used for the ILUT. Also, while the RCMK ordering is known to have little advantage over the Natural ordering in the case of symmetric matrices, the LRB ordering still can improve the convergence rate, even if the matrices are symmetric.

In this letter, we propose a simple detection ordering which can be applied to successive interference cancellation in low-complexity equalization of OFDM in doubly selective channels. Since the detection ordering can be determined solely on the basis of pilot symbol arrangement, the proposed scheme can lead to a significant performance improvement without additional complexity on the premise that pilot symbols are employed primarily for channel estimation.

The H.264/AVC standard provides several new error-resilient features to enable the reliable transmission of compressed video signals over lossy packet networks. Flexible Macroblock Ordering (FMO) is one of the most interesting resilient features within the H.264/AVC standard. Unlike former standards, in which slices were constructed out of consecutive raster scan macroblocks, FMO suggests new slices composed of spatially distributed Macroblocks (MBs), and organized in a mixed-up fashion. H.264/AVC specifies seven types of FMO. The standard defines also an explicit FMO type (Type 6), which allows explicitly assignment of each MB within the frame to any available slice groups. Therefore new FMO types can be used and integrated into H264/AVC without violating the standard. In this paper we propose a new Explicit Chessboard-Wipe (ECW) Flexible Macroblocks Ordering (FMO) technique, which outperforms all other FMO types. The new ECW ordering results in effective error scattering which maximizes the number of correctly received macroblocks located around corrupted macroblocks, leading to better error concealment. Performance evaluations demonstrate that the proposed Explicit FMO approach outperforms all the FMO types. Both subjective and objective visual quality comparative study has been also carried out in order to validate the proposed approach.

In this paper, we present a multiple capture approach to reducing the peak power as well as average power consumption during testing. The basic idea behind is to divide a scan chain into two sub-scan chains, and only one sub-scan chain will be enabled at a time during the scan shift or capture operations. We develop a pattern insertion technique to efficiently deal with the capture violation problem during the capture cycle. In order to alleviate the timing cost due to the insertion of redundant patterns, a scan chain partitioning method incorporated with test pattern reordering is developed to reduce the testing time. Experimental results for large ISCAS'89 benchmark circuits show that the proposed approach can efficiently reduce peak and average power with little timing overhead.

In this paper, we investigate a detection ordering scheme of OSIC (Ordered Successive Interference Cancellation) systems suitable for power controlled MIMO transmission. Most studies about power controlled systems have mainly focused on strategies for transmitter, while the ordering scheme optimized at open-loop system has not been modified. In a conventional ordering scheme, the ordering process is done according to the largeness and smallness relation of each sub-stream's SNR. Unlike the conventional scheme, we derive an optimized detection ordering scheme that uses proximity to the optimal SNR. Because of error propagation, our proximity based algorithm is not valid for open-loop MIMO system in many cases. An optimization problem analysis and simulation results show that the system using the proposed ordering scheme outperforms the system using the conventional ordering scheme. Furthermore, due to the nature of QR decomposition, the proposed scheme shows not only lower implementation complexity but also better BER performance compared with the conventional scheme based on pseudo-inverse.

In rich scattering environments, multiple antenna systems designed to accomplish spatial multiplexing have enormous potential of lifting the capacity of corresponding multiple input multiple output channels. In this paper, we present a new low complexity algorithm for decision feedback equalization detector in the SM scheme. The basic idea is to reduce the joint optimization problem to separate optimization problems to achieve better performance-complexity tradeoffs. Concretely, we separately optimize the detection order and the detector filters so that the complexity of the entire signal detection task is reduced. The new order search rule approximates the optimal Bell Labs layered space time (BLAST) approach from a geometrical perspective, and the detector filters are derived using a Cholesky based QR decomposition. The new algorithm is able to switch from zero forcing to minimum mean square error without additional operations and the computational effort is a small fraction of that in the optimal BLAST algorithm. Despite its low complexity, the error performance of new detector closely approximates that of the standard BLAST.

In this letter, we propose a novel subsampling based image watermark sequentially embedding scheme to reduce the risk of common permutation attack. The image is still perceptual after watermarking, and experimental results also show its effectiveness and robustness.

This paper examines a system which is inspected at equally spaced points in time. We express the observed states of the system as a discrete time Markov chain with an absorbing state. It is assumed that the true state is certainly identified through inspection. After each inspection, one of three actions can be taken: Operation, repair, or replacement. We assume that the result of repair is uncertain. If repair is taken, we decide whether to inspect the system or not. When inspection is performed after completion of repair, we select an optimal action. After replacement, the system becomes new. We study the optimal maintenance policy which minimizes the expected total discounted cost for unbounded horizon. It is shown that, under reasonable conditions on the system's deterioration and repair laws and the cost structures, a control limit policy is optimal. We derive several valid properties for finding the optimal maintenance policy numerically. Furthermore, numerical analysis is conducted to show our theoretical results could hold under weaker conditions.

We propose a likelihood detection scheme that utilizes ordering and decision of partial bits in MIMO spatial multiplexing systems. We compute BER performance of the proposed detection scheme under Rayleigh fading channels in a 33 MIMO spatial multiplexing system and compare it with BER performance using MLD only and detection utilizing ZF or MMSE only. In addition, the computational complexity of the proposed detection scheme is compared with that of MLD and detection utilizing ZF or MMSE. The results of our investigation show that the proposed detection is a scheme achieves both good BER performance and low computational complexity.

There is redundancy in instruction sequences, which can be utilized for information hiding or digital watermarking. This study quantitatively examines the information capacity in the order of variables, basic blocks, and instructions in each basic block. Derived information density was 0.3% for reordering of basic blocks, 0.3% for reordering instructions in basic blocks, and 0.02% for reordering of global variables. The performance degradation caused by this method was less than 6.1%, and the increase in the object file size was less than 5.1%.

This paper proposes a new detection ordering scheme, which minimizes average error rate of the MIMO system with per antenna rate control. This paper shows an optimal scheme minimizing average error rate expressed by the Q function, and simplifies the optimal scheme by using the minimum equivalent SINR scaled by modulation indices, based on approximated error rate. In spite of reduced complexity, the simplified scheme demonstrates the almost same performance as the optimal scheme. Owing to the diversity of detection ordering, the proposed scheme has over 2 dB higher SNR gain at the BER of 10-3 than the existing ordering schemes in balanced array size systems.

This paper presents an approach of logic mapping into LUT-Array-Based PLD where Boolean functions in the form of the sum of generalized complex terms (SGCTs) can be mapped directly. While previous mapping approach requires predetermined variable ordering, our approach performs mapping and variable reordering simultaneously. For the purpose, we propose a directed acyclic graph based on the multiple-valued decision diagram (MDD) and an algorithm to construct the graph. Our algorithm generates candidates of SGCT expressions for each node in a bottom-up manner and selects the variables in the current level by evaluating the sizes of SGCT expressions directly. Experimental results show that our approach reduces the number of terms maximum to 71 percent for the MCNC benchmark circuits.

Given a graph G, we give a fast algorithm for approximating the vertex connectivity κ of G. Our algorithm delivers a minimum vertex cut of G if κ δ/2, and returns a message "κ > δ/2" otherwise, where δ denotes the minimum degree of G. The algorithm runs in O(n2(1 + min {κ2, κ/δ)) time and O(n + m) space, where n and m denote the numbers of vertices and edges in G, respectively.

With the need and adoption of link aggregation where multiple links exist between two adjacent nodes in order to increase transmission capacity between them, there arise the problems of service guarantee and fair sharing of multiple servers. Although a lot of significant work has been done for single-server scheduling disciplines in the past years, not much work is available for multi-server scheduling disciplines. In this paper, we present and investigate two round robin based multi-server scheduling disciplines, which are Multi-Server Uniform Round Robin (MS-URR) and Multi-Server Deficit Round Robin (MS-DRR). In particular, we analyze their service guarantees and fairness bounds. In addition, we discuss the misordering problem with MS-DRR and present a bound for its misordering probability.

The multiple space-time trellis codes (M-STTC) structure is one of the Multiple Input Multiple output (MIMO) schemes providing high transmission rate and diversity and coding gain without bandwidth expansion. In this paper, an M-STTC system is proposed wherein the transmitter employs a multiple space-time TCM for the fast fading channel and the receiver has a decoding order block, several whitening processors, STTC decoders, and interference cancellers. The proposed layered receiver adopts a whitening process instead of a minimum mean squared error (MMSE) estimator, which is widely used in the BLAST type receiver. An optimum decoding order scheme is also planned since it gives at least a 2 dB gain in the proposed system in the fast flat Rayleigh fading channel of fd Tc = 1/3 at the FER of 10-2. For an M-STTC system employing two STTCs with four transmit and receive antennas, the layered receiver with whitening process obtains a 5 dB gain over the coded layered space-time processing in the fast flat Rayleigh fading channel at the FER of 10-2.